As an amateur it can be difficult filming from several angles at the same time as this requires several cameras. It´s also hard to film at occasions when it´s not appropriate to manoeuvre the camera manually. Systems for solving these problems already exist, but it´s either more expensive, professionalsystems or cheaper systems with limited functionality.The purpose of this project is to develop a cost efficient solution to the problem above that offers a better functionality then existing commercial systems. The biggest difference from existing products is the Wireless video feedback from the camera to the remote unit.The result of the project is a system consisting of two units, a manoeuvre unit with a cradle for the video camera and a remote unit from which the operator can control pan and tilt of the video camera.Communication between the two units is Wireless.On the remote unit there is a joystick and a display mounted. In addition to this, there is also an IR receiver that is capable of reading the signal from the cameras own remote and sending it to the manoeuvre unit.The manoeuvre unit is equipped with one motor to control the tilt function and one motor to control the pan.

Denna undersökning har studerat ett lätt infanteriförbands användning av kombinerad bekämpning som metod för verkan under en amfibieoperation samt vilka aspekter som påverkade möjligheten till kombinerad bekämpning p.g.a. operationens amfibiska karaktär. Fallet har utgjorts av Parachute Regiments två bataljoner som under Falklandskriget utkämpade tre slag vid Darwin ? Goose Green, Mount Longdon och Wireless Ridge. Som analysverktyg har använts Robert Leonhards teori om den kombinerade bekämpningens tre principer.

Lansen Technology develops and sells alarm systems. The communication between the system devices are Wireless. The radio protocol used by the system is developed by Lansen with the purpose to be energy efficient. The alarm systems target groups are individuals, businesses and government agencies. The current system is installed, configured and controlled from a control panel for all audiences.

Lansen Technology develops and sells alarm systems. The communication between the system devices are Wireless. The radio protocol used by the system is developed by Lansen with the purpose to be energy efficient. The alarm systems target groups are individuals, businesses and government agencies. The current system is installed, configured and controlled from a control panel for all audiences.

The thesis work was conducted with the company Free2Move AB. The company is located in Halmstad and is an acting provider of Wireless communications for industrial customers, mainly focused on Bluetooth? technology.In today's society most people have their music on their computer, MP3 player or mobile phone. What if you could avoid the cable between your sound system and sound source and transfer music Wirelessly instead? Together with the company's engineers, I have developed a new comprehensive product for Wireless music transmission.

Kandidatuppsatsen skrevs på Göteborgs Hamn, Skandinaviens största hamn. Uppsatsen skrevs isyfte att observera möjligheter med vilka trådlösa kommunikationsmedel produktionsledarna kananvända när de tidsrapporterar. Genom intervjuer och egna observationer visade analysen atthandhållna enheter för tidsrapportering är möjlig i mån om anpassning av handhållen enhet tillverksamhet och målsystemet. Teorin lyfter fram olika möjligheter och komponenter för vadanalysen skall tillämpa villkor, användningsområde, teknologi, objekt och funktioner kommerligger till grund för hur man skall tänka då man implementerar och designar ett nytt eller ettbefintligt målsystem. Resultatet visar att en handhållen enhet är möjlig då man även måste se överett system som passar ihop med målsystem och handhållen enhet samt uppnå de viktiga faktorernasom respondenterna önskar vid övergång från Excel ark till PDA.The thesis was written in Gothenburg Harbor, the biggest harbor in Scandinavia, and was created toobserve what the opportunities are for a change in the ways of communications for the productionmanagement and if there are opportunities for a Wireless communication for time report throughhandhelds.

Most of the portable electronic devices use a battery as a primary power source. Nowadays, when the applications are becoming smaller and smaller and more power efficient, the designer needs to concentrate more on reducing power consumption, using secondary power sources and introducing power storage devices. Multiple power source availability and a power storage device on the board will make the applications much more useful and efficient in everyday use. This thesis proposes a power supply unit (PSU) for Wireless sensor platforms which is capable of supplying a sensor node with energy from multiple sources, as well as status information from the PSU. Present power storage devices, like electric double-layer capacitors (EDLCs) and batteries, have become more and more common as their characteristics have developed.

Near Field Communication (NFC) is a short range Wireless communication technology that enables data exchange between devices. NFC is used in many different areas, from subway tickets to authentication systems. This paper presents possible security threats to Near Field Communication and documented attacks that have been used to target various NFC protocols. Weaknesses in different NFC protocols will be presented and suggestions on how to counter certain weaknesses will be discussed. This survey will be valuable for companies interested in protecting their data when using or planning to use NFC systems..

Målet med detta arbete är att utveckla och utvärdera ett shadergrafsystem med stöd för ?era shaderspråk. Fokus ligger på implementationen av en prototyp och hur dess delar fungerar. Prototypen utvärderas med hjälp av ett par experiment för att se hur användbart systemet för datorspel. Experimenten visar att systemet kan användas istället för traditionellt handskrivna shaders och på så vis avlasta programmerare och ge mer kontroll till gra?ker..

This report deals with the modeling of a part of the communication system based on the IEEE 802.11a standard which represents the next generation of Wireless LAN with greater scalability, better interference immunity and significantly higher speed, up to 54 Mbps. 802.11a uses Orthogonal Frequency Division Multiplexing (OFDM) where modulation is performed by an IFFT and the demodulation by an FFT. After modeling the FFT in Matlab and C, the FFT implementation has been validated using a soft microprocessor core by Xilinx (Microblaze) and the results were compared..

Internet Service Providers (ISP) har på senare år etablerat ett ökat antal Wi-Fi Hotspots på publika platser för att erbjuda Internettjänster så som e-post, Web och andra Internet-baserade program, till resande användare. Exempel på dessa platser är flygplatser, skolor, parker och städer. Växjö universitet har valt att bygga etttrådlöst nätverk på campus som man ska påbörja under sommaren 2005. Uppsatsen tar upp detta som fallstudie för diskussion av ämnet..

Wireless communication is becoming more common, a relatively new technology within the area is Bluetooth Low Energy. It?s been developed to be energy efficient and in regard to compatibility. Alongside the growth of Wireless technology, scientists and companies are looking for new areas of use. One of these is localization, which means to determine the position of a moving device with the use of stationary devices, an example of this would be GPS.This report means to evaluate indoor localization using Bluetooth Low Energy and was made for Combitech AB in Jönköping.

Projektet syftar till att utveckla en kommunikationsmodul till ett trådlöst larmsystem.Kommuikationsmodulen integrerar ett inbyggt system som kommunicerar via en radiomodulutvecklad av företaget Emwitech AB. Kommunikationsmodulen har som uppgift att styra externadetektorer och periferienheter. Utvecklingen av hårdvaran har skett i Altium Designer vilket harresulterat i en prototyp. Prototypen inkluderar avancerad teknik såsom programmerbar logik ochmikroprocessorer. Mjukvaran utgör intelligensen i systemet och ansvarar för att larmsystemetarbetar enligt de standarder som finns för hög säkerhet.En utredning med avsikt att välja kärnan i systemet har utförts och ett flertal aktuella teknologierhar analyserats och vägts mot varandra..

This project investigated the current market regarding Wireless net and the communication between the tools used for diagnostics/maintenance and an embedded system. Based on documentation obtained through interviews a demo system was created based on Bluetooth Low Energy (BLE) communication between an embedded system and an Android device.This report intends to describe the tools and methods used in the design of the demo system and the result of an analysis of the BLE communication.Bluetooth Low Energy is an exciting protocol with wide applicability within the industrial field. This project investigated the communicational possibilities between a Smartphone and a Raspberry Pi and based on the results that emerged the conclusion can be drawn that BLE is a protocol with many beneficial applications within industrial IT..

This paper describes a method for Wireless energy transfer via near-field electromagnetic inductionthat is inexpensive, simple and can be applied to almost any type of system, regardless of size andenergy demands.The method uses a primary unit consisting of an oscillator, amplifier and inductive coil thattransfers energy to a secondary unit consisting of a coil, rectifier and voltage regulator. Two typesof oscillators and several amplifier designs were realized and evaluated together with a multitudeof flat coils of both monofilar and bifilar type.The results show that it is important to use an oscillator whose frequency is dependent on theinductance of the connected transmission coil, such as the Colpitts oscillator. This is preferable toan oscillator with a preset frequency, such as a Schmitt-trigger oscillator..