Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

The scope of this project is to make a comparison of costs associated with wind and nuclear power in order to decide which one of these is the most suitable in the case of an increased demand for electricity. It is also investigated if there are other factors that can influence the choice of energy source.An average cost is calculated in terms of kronor per kilowatt-hour (SEK/kWh) using cost of investment, operation & maintenance and taxes & subsidies. Total investment cost is recalculated to production cost using the annuity method at three different interest rates (6%, 9% and 12%).The comparison is made between three cases of wind power and two cases of nuclear power. For wind power there are two ocean-based (300MW and 100MW installed capacity, respectively) and one land-based (60MW) wind farm. For nuclear power there is one EPR-reactor (1600MW) and one AP1000-reactor (1100MW).

The expansion of the Swedish hydro power has contributed positively to the reduction of the environmental impacts from the fossil fueled power production. In the same time the extensive expansion has been proved to cause negative ecological and local environment impacts of a stream. This, in turn, has been affecting the biodiversity and fish stock negatively, which has been reduced. One of the underlying problems is the lack of possibility for the fish to pass the plants, but it is also directly correlated to the mortality rate of the fish passing through the turbine, which this study is investigating.The mortality rate has been computed for three different locations in Sweden, Untra, Tännfallet and a third one whose location is confidential, and is denoted as Case 1, 2 and 3. The model used to calculate the mortality rate in this investigation is based by existing blade strike models and knowledge and are investigating the death due to mechanical injuries from collision with a runner blade in the turbine.

AbstractThis thesis is the final part of the Innovation and Design Engineering Programme (180 ECTS credits)at the Faculty of Health, Nature and Engineering Science at Karlstad University. The extent of thisthesis is 22.5 ECTS credits and has been performed independently by Hannes Jernberg during thespring of 2013. Metso Paper Karlstad AB is the task maker of this project, and Arvid Johansson is thecompany Representative. Metso Paper Karlstad AB is one of the world leading developer andmanufacturer of tissue paper machines.In the current situation, the company has developed and patented a power management systembased on a Cross Flow Turbine. The current construction is limited to a paper width of 2.9 meters.The company wants to take advantage of all the opportunities provided by the patents, to develop aturbine solution paper machine with a paper width that is wider than 5.5 meters, and give the abilityto manufacture paper for lower energy consumption which is an important part of the production asit is very energy intensive.Problems arise with the increasing length of the turbine, ultimately resulting in that the deflectionbecomes too big and that the momentums, due to the increased torque the turbine blades breaks.By applying the design process, this work has resulted in a number of potential solutions to theproblem.

This thesis analyzes the expected profitability in land based wind power plants. The expected profitability is calculated on the basis of a wind power project in Vartofta, Falköping. The information required to calculate the expected outcome is then concentrated to this project, which is in this thesis called project Näs. In project Näs they plan to build three wind power plants, with each an effect of 2 MWh. These wind power plants are very capital intensive investments with a long and uncertain payback time.

Wind power is a growing energy sector in Sweden. However, it still represents only a small part of the total electricity production, about 0.7%. In order to create good conditions and to facilitate the establishment of wind power in Sweden, the government has for example, created a national centre for wind use. The objective has been to reach the governmental goal, which is an expansion of wind power by 10 TWh by year 2015 compared to the level in 2002. The Swedish electricity market was deregulated in 1996 which refers to the introduction of a competitive market in electricity production and trade.

The dependency of fossil fuels has to decrease in order to reduce emissions of green house gases. Wind turbines generate electricity with low environmental impact, but the local opinion in Sweden is sometimes an obstacle to new developments. The acceptance of nuclear power increases at the same time. Mining uranium is once again on the agenda and prospectors are currently drilling for uranium. This cross-sectional study deals with acceptance of wind farms and uranium drilling.

The first commercially produced Wind turbines in Sweden are starting to reach theend of their lifetime after approximately 25 years of producing energy. The cost fordismantling the turbines, according to Ardefors et al. (2009), is calculated to be 1-2 %of the total investment of the Wind turbines. The purpose of this master thesis is tomap the dismantling process of Wind turbines in Sweden and try to find a sustainablesolution for the future.To make sure that a correct dismantling process takes place, and that the financialaspect is covered, a proposal for a financial guarantee is worked upon. A nationalunanimity will be created through a financial guarantee and the risk will be minimalof a third party getting afflicted.Studies of literature and interviews have been carried out.

ABSTRACTMany Wind turbines have problems with icing and there is still no effective method to de-ice without stoppage of production and power loss. Here I therefore consider other methods than those available today, and particularly, I consider how these methods could be applied to Wind turbines of the company Oxel. A surface where the water droplets do not attach might be the basis for a useful method. If no water attaches, no ice could form. To accomplish this a hydrophobic surface is nessesary, for example wax.

Wind damages next to strip roads in 1st and 2nd thinning in Boxholm, Östergötland Anneli Fransson, SLU, inst f sydsvensk skogsvetenskap, Examensarbete no 108 Wind damage is something we are all familiar with since the storms Gudrun (2005) and Per (2007). Research about strip roads and wind damage is very limited. It is commonly known that the trees next to the strip roads more often fall whit heavy winds, and the purpose of this thesis was to verify this statement. Data was collected from first- and second thinnings at Boxholms Skogar AB, Östergötland. In first thinnings data was collected from both spruce and pine stands and second thinnings only data from spruce stands was collected.

A large number of rivers in northern Sweden have hydropower developments that cause negative effects on both up- and downstream migrations of anadromous species like Atlantic salmon. So far, most attention has focused on the hindrances of adult fish during their upstream spawning migration. However, since turbines in power stations cause losses on downstream passing fish, the focus on negative effects on smolts has increased. The aim of this study was to compare three different causes of losses of salmon smolts passing downstream through a power station area in the flow-controlled River Åbyälven in northern Sweden.A total of 61 wild salmon smolts were caught and radio-tagged in the River Åbyälven during their downstream migration in June 2009. The salmon smolts were released at three locations, 1.1 km upstream from the power station, in the turbine intake and in the upper part of a fishway, acting both for up- and downstream fish passage.

Simulation is a vital tool during development of JAS 39 Gripen, since money and time can be saved.The Auxiliary and Emergency Power System, AEPS, is a subsystem of the secondary power system in Gripen. It has the function of providing the aircraft with electrical and hydraulical power before activation and after deactivation of the main engine. The system also functions as backup in case of a safety critical problem in the main power supply system. The system basically consists of a control unit and an auxiliary gearbox. The gearbox is driven by an air turbine.

The Swedish Parliament has decided to increase the share of electricity produced by wind power. The same parliament has decided that the Sami have the right to herd reindeer over 50% of the country's land area. In this literature review the potential impact wind power development and associated infrastructure may have on reindeer husbandry conditions are examined. The unique physiology of the reindeer enables it to live out of grazing in the arctic climate in the north of Sweden. For reindeer husbandry to be long-term productive and sustainable, it is important that there is enough land for grazing. The research available on how reindeer are disturbed by human activities such as roads, mines, hikers, etc., clearly indicates that the reindeer avoids areas close to such disturbance.

This master thesis is a study of the Swedish hydropower capacity to balance wind power. The Swedish government has decided that it should be possible to produce 30 TWh from wind power in the year 2020. The Swedish municipalities have to have plans for wind power plants with total yearly generation of 30 TWh. Wind power is an variable energy source that needs to be balanced by other energy sources. In Sweden the Swedish hydropower can be used for balancing a large scale introduction of wind power.

AbstractThis report describes our ten week long thesis work which is the last task in our education in mechanical engineering at Linköpings University. The project has been performed at Siemens Industrial Turbomachinery AB?s service department. The company which is located in Finspång produces, sells and provides service for steam and gas turbines around the world.The purpose of this project is to help Siemens develop their maintenance programs for two of the auxiliary systems which are a part of the complete steam turbine system. These are lube and control oil systems.The project is restricted to two of Siemens maintenance products, No Stop Check (NSC) and the annual Safety Inspection (SI).