In the Kolmården area, northeast of Norrköping in south-central Sweden, it was discovered that shoots of spruce Picea abies, plants to a seemingly large extent had been browsed by deer. The area inhabits a dense red deer population, alongside with moose and roe deer, and red deer is thus suspected to cause the damage. The main purposes of this study are, however, to estimate the extent of the shoot-damage and to investigate what factors that may affect the browsing of shoots. For each stand information was recorded about the age of the plants, area for the stand, height over the sea for the stand, site productivity, type of plants and stand-history. The study was done in three areas: Simonstorp, Stavsjö and Valinge. At Simonstorp and Stavsjö, respectively, 10 stands were chosen for study and on Valinge six stands. In each stand, 10 plots were sampled.

Vattenfall AB is a large producer of electric energy where approximately half of the energy comes from hydropower. Vattenfall Hydropower has got almost a 100-year old history and the company has developed a lot since 1909. After that the number of power plants increased and the competition got more intense, there were higher demands on the reliability. One way to secure the reliability with a good satisfaction at the power plants is to implement a maintenance method named Reliability-Centred Maintenance. RCM is a result of the introduction of the complex aeroplane Boeing 747 in the 1960?s.

Today 70 percent of the world's sand beaches are under recession due to erosion. The global warming may have the effect upon the sea level increasing and the erosion increasing on the sand beaches. To save these sand beaches, the erosion must be prevented. Coast erosion shelters like gabions and sea walls are functioning extremely well to protect the land behind the sand beach, but due to the wave reflections, created in front of these so called hard erosion shelters, the erosion of the front beach is accelerated. During the last decades, artificial sand supply (beach nourishment) has been the adopted praxis.

This thesis describes a conceptual design of a support frame for a synchronousgenerator used in a vertical axis wind power plant. In this system the generator isplaced on ground level. The thesis also considers the design of housing for thesupport frame and generator. The concept presented in this report is based on anearlier design. Besides geometric design, simplified simulations has been run in orderto optimize some of the parts included in the construction considering naturalfrequencies and structural strength.The result is presented as CAD-models andan assembly drawing..

System based models of plants rely on descriptions and assigned functions of genes, and currently 50% of the genes in Arabidopsis thaliana has either no assigned function or a function based on homology only. Mitogen activated protein kinases (MAPK's) are key players in cell signalling and are conserved among eukaryotes, though their targets are highly diverse. A recent study has described a small Arabidopsis protein (80), without homology to any described protein, as a phosphorylation target of the MAPK's MPK3/6. Further work established ?-glucan phosphorylase (PHS) as interacting with 80 and described a delayed senescence phenotype for 80 knock-out plants.

A plant's defensive ability against herbivore attack can be influenced by many different factors, one of them being domestication. During human selection to improve the yield of plants, the resistance against herbivore attack can have been lowered, due to a trade-off for use of resources between these traits in the plants. In this thesis I investigated the effect of domestication on resistance against herbivorous insects in cotton plants. I used different varieties and species of wild and domesticated cotton in three different experiments. A feeding assay was conducted, the mortality, development time and pupal weight of larvae of the Egyptian cotton leaf worm Spodoptera littoralis was studied. In a second experiment the preference of the root-feeding beetle Agriotes spp.

Dimensional stability is an important aspect of fuel mechanical design and licensing of new fuel designs for nuclear power plants. Dimensional changes within the reactor can affect the safety margins against overheating of the cladding and the pellets, therefore it is crucial that the dimensional changes are kept to a minimum.The profits per produced kiloWatt hour continue to decrease for the Swedish nuclear power plants. Some reactors are even operated with a calculated loss. To reduce fuel costs and thereby improve the profit some reactors are operated with higher uranium enrichment, so that the assemblies can reach a higher average burnup. This increases the neutron fluence to the pellets, cladding an spacers.

The technological legacy from the early electrification of the Swedish railroads has resulted in a power grid with a lower grid frequency than the national power grid from which it is fed. Energy transfer between these power grids with different frequencies requires substations, adapting the grid frequency for the rail road power grid. For this purpose, a feeding power grid has been built, stretching across the country from Boden in the north to Tälle/Häggvik in the south.Power transfer in the Swedish power grid results in voltage angle differences which increase with increasing loads and transfer distance. These voltage angle differences are transferred from the power feeding substations to the rail road power grid, will in some extent cause loss of energy due to unwanted power flows from north to south.To minimize the losses due to this phenomenon, a power management system called EFS 132 kV has been developed and implemented. The system minimizes the unwanted power flows and controls the desired power flow for a good distribution of loads between the power feeding substations.This thesis investigates the extent of the transmission losses avoided due to the EFS 132 kV that coordinates the idling angles to a common reference point.The results indicate that EFS 132 kV affects the power flow, especially between the northern substations through an improved load distribution.

As a consequence of increasing wind power installations in the Nordic grid the last years, the need for regulating power has become larger. In the Nordic grid, regulating power is mainly provided by hydro power. One part of the regulating power is called frequency control, which ensures that the grid frequency is stable and close to 50 Hz.However, setting the turbine into frequency controlled operation may cause stress and wear of the components in the mechanical control system. Frequency controlling implies large and frequent servo forces and longer travelling distance of the sliding bearings in the Kaplan turbine.Based on one selected Kaplan turbine, Selsfors G1, measurements and MATLAB calculations have been performed in order to determine forces and movements of the linkage system. With these forces and movements as input, stresses and fatigue have been determined as well as sliding distances, bearing pressures and wear of bearings during a typical lifetime of 40 years.The results indicate that no severe wear exists on the bearings during 40 years of service.

The housing sector uses 40 % of the energy in Sweden and half of the electricity usage. Theuse of energy is the main reason to the increasing rate of carbon dioxide in the atmosphere.This is the main motive but also a wish of higher safety, that is a higher rate of selfsufficientenergy production in Sweden, we want to decrease the need of using fossil fuel. Now whenthe energy price rise, the interest in energy issues increase and more people discuss thepossibility of reducing the usage of fossil fuel. A change to renewable energy such as sun,wind and water is the only solution where we can get a sustainable development.One way to contribute to a better use of energy is to build in the principle of passive house.The house is being built with a thick and tight insulation. If you use a heat-exchanger withhigh degree of efficiency and a final heating battery on the ventilation system, the heat fromlamps, devices and the ones living in the house should be enough to fulfil the criteria ofliving.

yield optimization, wind energy, sustainability, maintenance..

This thesis treats the normative power of the European Union and its affect on Macedonia. The main purpose has been to look closer with the use of the application of Ian Manners theory of normative power on the Macedonian case. The focus will be to answer the following questions: Does the European Union act as a normative power in relation to Macedonia, if so, how are these values diffused? Has there been any effect of the spreading of these values? Based on six interviews and the available material of European Union strategies for the Macedonian membership I have attempted to understand to what extent the European Union?s normative power has had an influence in Macedonia. The result of my analysis is confirmation of the European Union as a normative power in Macedonia and the understanding of the methods of application..

The Russian-Georgian war of 2008 drastically changed Europe´s and Sweden´s political climate.Russiashowed that it is capable of successfully completing complex campaigns including ground, naval and air assets. However, not much has been said about the theoretical framework and doctrine of the Russian military of today. Even less has been researched about Russian use of air power and applied air theory. Are air power assets still considered primarily as support of ground offensives or has the theoretical framework changed?John A.

What kind of international actor is the European Union and how shall we define it? These are questions that many have tried to answer often by addressing the apparent uniqueness of the EU itself. One of these theories is Normative power Europe. A theory whose main argument is that the EU is best perceived as a changer of norms. My aim with this thesis is to test this claim and to see if the Union should be regarded as a normative power.

Delia flies (Diptera: Anthomyiidae) are economically important pests in several horticultural crops. The control is commonly relying on chemical insecticides, though there are possibilities with biological control from the natural enemies in the field. An important natural enemy is the parasitic wasp, Trybliographa rapae Westwood (Hymenoptera: Figitidae) that lays eggs in the Delia fly larvae. The parasitoid larva and the host larva have a parallel development until the host dies within its puparium and an adult parasitoid emerges. The aim of this thesis was to understand the attraction to host- and food-associated plant volatiles of T. rapae, in order to enhance the effectiveness of the parasitic wasp as a biological control agent.