The purpose of this report is to investigate and compare the difference between stand-thinning machines and strip-road thinning machines, and how they affect the stand on behalf of future growth, theoretical economic result, wind impact, snow pressure and density of stand. The investigation is regarding the first commercial thinning of pine stands, after pre-commercial thinning that was well conducted. The investigation area was located near Katrineholm, Sweden. The measurements that were measured were strength of thinning and amounts of wind throws, snow-breaks and hauling damages. The results that emerged, was that thinning with strip-road machines had a significantly higher strength of thinning over all, as compared with the stand- thinning machines (45 percent versus 30 percent). Comparisons between wind-throws, snow-breaks and hauling damages of the stand could not establish any significant differences between the two methods that were investigated. Conclusions, over all, were that if forest owners want to have more timber volume left for second thinning and final cut of the stand, the forest owners should choose the method with stand-thinning machines. From the point of view of gentle treatment of the stand and ground damages the choice should be the same. However, the method with strip-road thinning machines is the most common and accessible method in Sweden. Most likely it is the most economical way to manage the stand for forest owners in present time. If the method with stand-thinning machines is becoming more common in Sweden, it is suggested for forest owners to consider the stand-thinning method as a candidate for treatment due to economic aspects..

To be able to measure high-surge voltages and transients with short rise times youneed measuring instruments with a high sampling frequency and large Bandwidth.These surges and transients occur primarily at lightning but can also occur at forexample at connecting errors at an electrical switch-gear. This report describes thework with finding two solutions for measuring and log data from these surges andtransients. One temporary solution where a measurement program has beendeveloped. A second solution where different company solutions have been analyzedto decide which fits best. For these measurement solutions two solutions for bringingdown the voltage has been used.

Housing construction very close to the lake Mälaren has become very popular today. One potential problem with these houses is the influence of the sea climate. Unprotected buildings are affected by strong winds and precipitation. So for that reason, it is very important to make an accurate climate investigation and use it for decision-making during the planning of the new settlement.It is very important with a good moisture protection regarding pelting rain, that is the combination of wind and rain. This is more important for buildings close to a lake, as this location normally means a higher exposure to wind.

Authors: Maria Bergholtz, Alexander WestessonTutor: Daniel EricssonTitle: Performance Measurement of Creative work ? a culture study at PS CommunicationKeywords: Key Performance Indicators, Organizational Culture, Macro-culture, Subculture,Micro-culture, Art, Business, Creativity, PS CommunicationIn the paper?s introductory chapter, the chosen problem area regarding art and business willbe presented. The paper?s studied empirical case will also be introduced here. This then leadsto the reports chosen research questions:How do the company management and the companies? creative personnel approach differ inthe discussion regarding performance measurement on PS Communication?-What causes these differences?What impact does the corporate culture have in the discussion about performancemeasurement of PS Communication?-Is the corporate culture weak or strong?The purpose of this paper is to resolve the stand still in the discussion regarding performancemanagement by creating an understanding of different people active in the organization?sapproach to performance measurement.

To be able to measure high-surge voltages and transients with short rise times youneed measuring instruments with a high sampling frequency and large Bandwidth.These surges and transients occur primarily at lightning but can also occur at forexample at connecting errors at an electrical switch-gear. This report describes thework with finding two solutions for measuring and log data from these surges andtransients. One temporary solution where a measurement program has beendeveloped. A second solution where different company solutions have been analyzedto decide which fits best. For these measurement solutions two solutions for bringingdown the voltage has been used.

This paper aims to explore the phenomenon urban wind energy, its visual effect on built environment and the factors that affect the opinion towards new elements in the city. A place study of the city Gävle serves as a complement to the theoretical part of the paper. The theoretical discussion opens with an account for the technical and economical conditions of urban wind energy. It presents the technical basics, different types of turbines and a discussion occurring wind related techniques in built environment. Today, the knowledge of how the wind moves and acts in the rural landscape is quite good.

There have been, in some rare cases, difficulties with clamping of inserts with U-holesin their tool holder. According to the complaints, the inserts could not be properlyclamped or could fracture when clamped. A study has shown that variations inclamping behaviour are mainly depending by the position of the screw hole in the toolholder and the centering of the screw hole in the insert.The focus of this project has been the centering of screw hole in insert. It has beenshown that the screw holes are not always enough centered in the insert. Theproblem may occur after a certain step in the production, i.e.

Both the German and the Nordic power markets are seeing dramatically changed conditions due to an ongoing process of expanding the share of renewable production in the systems. For the German part this comes from heavy subsidies which have led to an explosive development in installed capacity of photovoltaic and wind based production. After the Fukushima incident it has been decided to shut down all Germanys nuclear plants. This capacity drop is however not of the same magnitude as the increase in renewables, but will impact the stability of the power system. The Nordic power system which already has a surplus of power sees an even further increase, coming mainly from construction of new nuclear plants in Finland and a general increase in wind farms.

The purpose of this paper is to understand the climate of the street and how it can be modified to better meet the needs of the street and the user groups. At the same time the conditions of the street and its surroundings also has to be taken into account. To accomplish this it is necessary to have a broad knowledge of the climate conditions in the city. Therefore an overview of the climate elements and how these are modified in the built-up areas are given. The part of the paper which deals with the city climate has a global approach to be able to give an as complete picture as possible.

Sweden's drinking water quality is considered to be high partly due to a high quality of the raw water and a well developed sewage infrastructure. Despite this, there is water contamination that could be prevented by installation of a sophisticated early warning system. Some of the major players in the production of drinking water have already invested in different types of early warning systems to ensure drinking water of high quality. There are various forms of early warning systems where automatic monitoring of E. Coli is an interesting alternative.

The project contains a force analysis of the vertical axis wind turbine Lucia's supporting arms and a measuring device to experimentally measure the forces is made. The forces between the supporting arms and the tower are calculated theoretically and then simulated by a computere. A measuring devise is then designed to measure the forces experimentally. The forces acting on the attachment between the supporting arms and the tower is primarily the centripetal force, gravitational force and the aerodynamic forces on the rotor wings. The maximum forces were theoretically calculated and is 13.38 kN along the x-axis, -0.25 kN along the y-axis and then 0.5 kN along the z-axis.

AbstractThis bachelor?s thesis at the Department of Production Engineering at the Royal Institute of Technology in Stockholm deals with the subject of automated metrology. The degree of automation of tasks within production has been a growing trend but the measurement of quality has not followed the same trend. The main thesis follows:What incentives are there to automate the measurement of quality in production?What factors are crucial and why are not all metrology automated?The thesis comes along with a number of sub-queries and delimitations.The working method includes both theoretical and empirical studies.

En del länder väljer att investera och utveckla vindkraftmarknaden mycket, medan en del länder väljer att inte göra det. I Europa startade vindkraftutvecklingen under 1970-talet. Efter en trög start är den europeiska vindkraftutvecklingen nu marknadsledande och fortsätter att expandera i hög takt. Tyskland har den högsta installerade kapaciteten av vindkraft i världen, och Danmark har den högsta installerade kapaciteten per capita. Dessa länder, samt Spanien, Sverige och Storbritannien har alla satt nationella mål för utvecklingen av vindkraften.

ObjectiveThe objective of this study was to investigate the clinical application to use ASSR in anesthetized childrenDesignOne main ambition of the investigation was to compare hearing threshold using ABR with estimated hearing threshold using ASSR. Another aim was to examine if the duration of an ASSR measurement could be reduced by only using the frequencies 1, 2 and 4 kHz and exclude the frequency 0.5 kHz. This is a retrospective study using electrophysiological measurement from a database.ResultResults showed a high correlation between hearing threshold using ABR and estimated thresholds using ASSR, with the frequency 0.5 kHz showing a slightly lower correlation. Result also showed that the test duration was increased when using all test frequencies in ASSR-measurement compared to when 0.5kHz was excluded. ConclusionThe study showed a high correlation when comparing hearing threshold using ABR and ASSR.

The Private Equity industry has over the past years been booming and major external environmental changes have made the industry transform rapidly. Increased competition between Private Equity firms is one of the reasons why the industry has been and is being forced to focus more on addition of value through increased operational management. Consequently, the focus of value addition is by some said to be transferred away from deal making and financial skills, and into active operative management. This case study investigates how the portfolio management, and more specifically the measuring and management of performance, is carried out in a number of leading Swedish Private Equity funds with investments in the biotech sector. The biotech sector is characterized by extensive research and development, and many biotech companies often lack income and other measurable financial parameters in the initial phase.