Emotron is a company specialised in developing, producing and marketing equipment to con-trol, monitor and protect processes and machinery driven by electric motors, with an applica-tion focus. Examples of uses for their products are fans, pumps, lifts and cranes.The project is to look at Emotrons end of line test. The company has seen that at the final test-ing there is a bottleneck that restricts the outflow and prevents an increase in the number of tested products.The purpose of this project is to review how Emotrons end-of-line test works today and if there is a possibility to make the test more efficient in such a way that the quality is not at risk, while increasing the outflow of tested products.The projects first step is to look at and analyse what is causing the bottleneck at the end-of-line. When the analysis is complete, the next step is to review whether there is a possibility to solve the bottleneck and if so in what way can this be done. Emotrons most overall objective of the project is to increase the outflow of the number of tested products without jeopardizing the quality.An analysis has been made on frequency inverters, soft starters and shaft power monitors.

BACKGROUND: Today?s societal changes, including high rate of change and increasing information flows, are increasing the demand on the individual mental capacity. It becomes increasingly difficult to analytically process all the different dilemmas and everyday decisions as individuals have a limited mental capacity available to make these decisions. Thus, it has been suggested that ego-depleted relies more heavily on intuition, which is less burdensome, when making decision. However little is known about to what extent intuitive decisions differ from analytic.

Nutrient enrichment is the main cause of the increasing eutrophication process in the Baltic Sea during last century. A prerequisite counteract this process the load of nutrients to the Sea must be investigated. The large contribution of nutrients to the Sea is caused by emission from the rivers within the drainage basin. For the total emission of nutrient into the Sea the retention process in the rivers has big influence. This process in the river system has been assumed as a not important part of the nutrient cycle.

The goal for this master thesis project has been to investigate the power quality in adistribution grid, which has a high fraction of dispersed power production due towindmills. The study has been done on a grid in Laholm South of Halmstad, whereapproximately 45 windmills are connected to the distribution grid owned by SHKEnergi. The investigation has been focused on to two radialy fed 20 kV lines, wheretwelve windmills are connected.Voltage variations have been studied by creating a model of the grid in the simulationprogram SIMPOW. The largest deviation that has been found in any point of the gridis ±1.9 % of the nominal voltage. This deviation is a result of varying powergeneration from the windmills and the voltage regulation at the connection point ofthe line.

The goal of this thesis is to design an attachment between a duct and a pod. A pod is what could be compared to an outboard engine for larger vessels. The pod is placed on the outside of the ship?s hull and can rotate 360 ?. A duct is a large steel ring that can be placed around the propeller on the pod to increasethe propulsion force of the ship in lower velocities.

The energy sector is facing an impending paradigm shift. Today?s technology enables the end-user to generate their own energy locally at home. Furthermore, recently developed storage technologies make it possible to balance energy demand with stored energy and integrate district heating with the local power grid. This means that in the future heat and electric power will interact and energy flows is converted over energy boundaries.

Hydropower is an important source of energy in Sweden and accounts for about 46 % of the total energy production. Sweden has about 1 200 hydropower plants and with the intention of raising the pressure head of the water and to store water, dams are built by the power plants. The storage reservoirs make it possible to adjust the energy production by demand and season. Dams in connection to the reservoirs are subjected to additional loading during periods of high floods or when an icecap in the winter is formed on the reservoirs. In order to maintain the dam safety, the power companies in Sweden are working with guidelines for dam safety from RIDAS.

The Goal with this Master of Science thesis is to expand the possible turbine efficiencymeasurements on an exhaust turbocharger. It was done as a part of the CICERO competencecentre. To feed the turbine with air a special flow rig has been used. Instead of loading theturbine by just restricting the compressor flow a docking system for an electrical dynamometer isdesigned to use the dynamometer as an additional loading source. By using an electricaldynamometer as loading device for the turbine, measurements are not depending on compressorperformance.A large part of the work consists in designing accessories for the dynamometer.

In Sweden, the eutrophication of lakes, water courses and the coastal areas is considered the major threat to aquatic ecosystems and therefore actions taken to reduce the nutrient load to aquatic system including the Baltic Sea has high priority. There are many different sources of phosphorous and nitrogen and domestic wastewater is one contributing factor to the high load. Especially waste water from households that is not connected to municipal sewage treatment or a local small scale plant with appropriate nutrient removal efficiency is considered a problem. These types of households are quite common in rural areas in Sweden and in areas where summer houses has been converted to permanent living. Swedish legislation now permit the municipalities to decide in which areas within the municipality higher demands of the local small scale treatment facility should be met by the households (i.e.

Regulations on the exhaust emissions of HD-diesel engines are becoming more and more stringent, and therefore, emission after-treatment systems are commonly used. These systems rely on catalytic conversion of NOx,CO , and HC emissions, and are thus dependant on temperature. At low load of the engine, exhaust temperatures are not sufficient for the after-treatment components. Therefore, means to increase the exhaust temperature while maintaining low emissions and fuel consumption are needed.The focus of this project has been to develop strategies for the lift profiles of exhaust and intake valves in the engine, with the goal to raise exhaust temperature in combination with low emissions and fuel consumption. The strategies have been tested in a single-cylinder research engine equipped with a hydraulic variable valve actuation system.

Detta examensarbete utgör resultatet av en studie på uppdrag av Volvo Cars Torslanda (VCT) i Göteborg. Syftet med studien har varit att undersöka produktflödena mellan VCT och dess leverantörer med hjälp av analyser. Dessutom utreds hur transporterna skulle kunna optimeras och vilka konsekvenser som uppstår. Beräkningar, diskussioner och analyser resulterar i rekommendationer för företaget.För att få mer kunskap om transportlogistik, produktionsekonomi och miljöpåverkan av transporter genomförs först en litteraturstudie. En granskning av nuläget beskriver hur situationen ser ut i dagsläget och ger även en detaljerad bild av flödena från leverantörer till VCT.Sex stycken flöden vars gods transporteras från leverantörer till VCT har undersökts.

Förmågan att prestera under akut eller kraftig stress är en förutsättning för en del yrken. Forskningsresultaten gällande hur stress påverkar prestation pekar åt olika håll. Denna studie undersökte sambandet mellan fysiologisk arousal och kognitiv problemlösningsförmåga under stress. Trettiotvå polisstudenter testades på Ravens test av flytande intelligens APM set II både före och efter att antingen ha sprungit i tjugo minuter eller haft en självskyddslektion på ca fyrtio minuter. Resultaten från en mixed ANOVA för beroende mätningar visade på en signifikant interaktionseffekt (F (30) = 6,547, p < 0,05) ? en ökning i prestationen hos självskyddsgruppen med arton procent och en minskning med femton procent hos löpningsgruppen.

To build high-rise buildings made of timber has for long been limited by national laws, due to the lack of knowledge in engineering solutions. Frame structures made of wood has for a long time been associated with major fire hazards and consequently lower safety and this connection is still being made today. The increased environmental awareness in recent years has contributed to the exploitation of indigenous building materials, including wood from our own Swedish forests and has become increasingly common. Increased knowledge about how structures behave in fire and how they can be protected in order to achieve safe timber structures has resulted in a growing interest in these structures in the construction industry. Research in the area is constantly updated and new laws allow any number of storeys in wooden buildings in Sweden as long as the performance requirements are fulfilled.The main part of this work has involved calculations of the fire resistance and load bearing capacity of floor and wall constructions.

AbstractThe tests work is about the subject "synergism of steel and concrete."The construction sector is in a strong competition and the different companies in the PrefabMarket has ever tried to develop new design solutions that are efficient and environmentallyfriendly.The purpose of this report is to highlight different aspects of interaction and size up a columndimension and to examine its efficiency and load capacity as Eurocode 3 and Eurocode 4. A sizing chart that describes the relationship between the torque and normal force shouldalso be made of the interaction . .

This report is of technical character and treats how to plan a small building in Borlänge, Sweden.The technical components that have been treated in the report are the construction, foundation,installations and thermic abilities of the house. In addition to planning this house the report alsocontains a part that deepens in net zero energy buildings. The purpose of the report is toinvestigate if the house in Borlänge can be constructed to meet net zero energy buildingdemands.Energy efficient houses such as passive- and net zero energy houses are showing more frequenton the market in Sweden. Ongoing climate changes and growing consciousness about theenvironment in society have contributed to that the environment is a well discussed topic. Toconsume small amounts of energy and at the same time produce local energy is thereforesomething that lies in the future and future houses.