In Sweden, a big part of the energy use is used in the housing sector. Political goals and targets are set up which the housing sector needs to work towards. Apartment buildings are a major part of the housing sector in Sweden and therefore reduction of energy use in these kinds of buildings are key to lower the energy use in Sweden. But there are not only political incentives to reduce the energy use. Some energy?saving measures are directly profitable and should thus be performed.

The guest harbor on Utö, Utö Gästhamn, is currently using electricity for heating all of the water used in the showers and taps. Because of the large amount of visitors, especially during the summer months, the hot water usage gets very high and that is also the case for the electrical bills. During the year of 2011 the cost of electricity for Utö Gästhamn reached a total of 257 500 kr. Out of these 257 500 kr approximately 142 000 kr, 55 % of the total cost, were because of the water heating.The report is the result of a cooperation with Skärgårdsstiftelsen, the Green Islands-project and Utö Gästhamn where the mutual goal is to dimension a solar energy system, to promote the sustainable development.Initially the different techniques for the solar energy system are researched. The techniques are plane solar collectors, evacuated tube collectors, pool collectors and photovoltaic cells.

This thesis investigates techniques for stealth hydroacoustic communication using spread spectrum. The Swedish naval defense organisations have a vision that all their units should be able to communicate with each other, even between underwater vehicles. But the properties of water makes it a complex channel to use for wireless communications. Radiomagnetic waves have very limited range in water, therefore acoustic waves are used. In this report the basics of wireless communication systems are described including source coding, channel coding, modulation techniques as well as different techniques for spread spectrum.

This report is about the experiments with mixing of the separated water and the vacuum pump seal water at Hellisheiði power plant. This is done to prevent silica scaling and clogging in pipes and reinjection wells as well as eliminating vacuum pump seal water from the plant. The experiments were done in four stages: the first stage comprised of tests with different flows of separated water at 70°C, the second stage was carried out by mixing the separated water at 70°C and the seal water with different amounts of the seal water, the third and the fourth stages were like the first and second but with the separated water at 120°C. The results show that this method is good if the mixture is around 50/50 separated water and seal water, to control the silica scaling in the separated water and to be able to reinject the seal water with the separated water. This does not eliminate the silica scaling in all of the separated water because the amount of separated water is much more than the amount of seal water that comes from the plant. .

This examination work on studies and research in articles is mostly from other countries. The purpose of the examination work have been to find out if there are any means you can work with to find out when its time to start irrigation, how they works and if they are credible. In Sweden there is not many means for decide when it?s time to irrigate and how much water you should appear. Swedish farmers think they have so much experience that they don?t need techniques like this.

Poly- and perfluoroalkyl substances (PFASs) are a group of environmental contaminants that have gained increasing attention due to their potential to bioaccumulate, environmental persistence and potential toxicity. PFASs have been found in surface water, sediment, air, soil, sludge and ice caps globally, as well as in wildlife and humans. Furthermore, PFASs have also been detected in drinking water, leading to raised concerns for human health, since drinking water is one of the most significant sources of PFASs for the general population. Conventional water treatment techniques have shown to be ineffective removing PFASs, highlighting the importance for further research to develop efficient removal techniques. The aim of this study was to investigate the removal efficiency of PFASs in water using two treatment techniques; granular activated carbon (GAC), type Filtrasorb 400®, and anion exchange (AE), type Purolite A-600. Additionally, the effect of dissolved organic carbon (DOC) on removal efficiency was studied.

We all know that water is very important for both animals and humans. When we are weaning the piglets from the sow we must guarantee that the piglets can start to drink more water instead of sow milk. The first thing to check is always the quality of the water that is to be used. To secure that, you must take a water sample. If the water is inadequate it can bring a lot of problems and diseases.

Water is an important food and an important natural resource. In order to protect these are the Environmental Code and the EU directive given to water protection and related water protection regulations will be established for all water sources until 2010. Those who will prepare a water protection and related water protection regulations is the municipality or person responsible for water supply. The person then decides and declares the area as water protection and related water protection regulations are municipal or provincial government. The idea of creating a water protection is to protect the water supply and the body of water against pollution caused by point sources, diffuse sources and accidents combined.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

Chile and Santiago are struggling with heavy environmental problems as a consequence of urbanisation and industrialisation. In the Santiago region the air is seriously contaminated and most of the rivers are classified as heavily polluted.The aim of this thesis is to survey the industrial fluid waste situation in the Santiago region and to make suggestions on technological improvements or process changes. The purpose is also to study five different enterprises more closely and to give more detailed suggestions for improvement. Another purpose is to summarize relevant Chilean legislation.Information, provided by the supervisory authority, about the release of industrial wastewater to rivers has been analysed. Deep interviews have been made with authorities and consultants.

Understory vegetation and fungi are regarded as important ecological drivers of processes like productivity and nutrient cycling in boreal forests. Whilst those processes are linked to soil water content, relatively little is known about the sources of soil water for these forest components. During early autumn in boreal forests, temperature falls and large events of rain are frequent which may influence soil water availability. To better understand the autumn plant-soil-fungi water relationships in this ecosystem, I used stable isotopes techniques in this study to examine the water sources for ericaceous shrubs and fungi in a Scots pine forest following a large, early autumn rain event. I hypothesize that ericaceous shrubs of two functional groups (evergreen vs.

The purpose of this report is to explore how modern technology can work againstolder craft techniques. The focus of the research will depend on what conditions areoptimal for cutting marquetry with laser technology. In my work I account for thehistorical background of the various techniques and then through own practical testsexamine whether the laser technology can complement the traditional techniques..

 This degree project aims at developing a concept for how to use solar energy to pump up water. The target audience is people living in areas where the functioning of the electricity and water network is absent. In these areas, the hand-powered water pump is the most common technology. The degree project's goal is to find an economically viable alternative to the time consuming hand-powered water pumps. The power comes from solar energy.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.