When establishing a groundwater protection area it is of great interest to be able to estimate the transit time of the groundwater from different places of the aquifer to the withdrawal well. These estimates can be uncertain due to heterogeneities in the aquifer. As a part of the work to develop methods for a more certain delineation of protection areas, a tracer test was performed in an esker located 25 kilometres NW of the town Uppsala.The purpose of this master thesis was to perform, describe and evaluate the tracer test. Travel times from the tracer test should then enable comparison against stochastic simulated travel times of the groundwater in the area.Three dyes (rhodamine WT, uranine and naphtionate) and a salt (NaBr) were used in the tracer test. The tracers were injected in four different wells located 25 meters from a pumping well.

Stump treatment today requires large quantities of clean water mixed with the protective product Rotstop, to fully cover the stump surface. In order to reduce the water consumption without reducing the coverage of the stump surface, the pressure in the stump treatment device can be increased. Therefore, the Phlebiopsis gigantea (Fr.) Jül. suspension used as a biological control agent to prevent Heterobasidion annosum (Fr.) Bref. infection was pressure-tested.

The continuous process of urbanization results in demands on research and development for ecological and sustainable city development. Because of this, the current systems for wastewater treatment may have to be improved. In order to evaluate new technologies for municipal wastewater treatment, a development project has been initiated for the new district Hammarby Sjöstad in Stockholm. The project is lead by the company Stockholm Water. High environmental standards have been put up for the district, as it must be twice as good as an ordinary new district.

The city of Uppsala and its surroundings are a very expansive area. A prerequisite for a sustainable development of the area is well-functioning supply of drinking water. In Uppsala municipality, the Uppsala esker and Vattholma esker are the groundwater storages for drinking water. Besides the eskers, other sources of qualitative groundwater in the Uppsala municipality are relatively poor and more than half of the area consists of ground conditions with a risk of saline groundwater. The neighbourhood of Vreta-Ytternäs is situated 10 km south of Uppsala, in the area with risk of saline groundwater but outside the municipal water supply.

Treatment wetlands been showed efficient for reducing pollutant in waste water. In Lajeado ? RS, Brazil the landfill has poor leachate water treatment. It is necessary to supplement the treatment plant because they need to reduce BOD, COD and nitrate of the water going to recipient. A subsurface flow wetland (SSF) can be a good choice.  In order to be able to design an efficient SSF it is important to understand how the grain sizes of a substrate affect the reducing of pollutants in waste water.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

The aim of this master thesis was to create a dynamic model for the processes in a solid fuel boiler of the moving grate type. Another aim with the model was to keep it as simple as possible but still able to catch the dynamics of the processes in the bedplate of the boiler. The creation of the model had its origin from drying and combustion equations used in earlier modeling work of boilers. The represented model has been used to simulate different kinds of disturbances in a boiler and different ways to control the boiler. These tests show that controlling a number of parameters in the bed of the boiler is an effective way to keep the grate stable during disturbances.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

This master?s thesis describes the development of a model of the catalystsystem aiming at control by an MPC. A well functioning model, which is suitable in control purpose, is important while emission legislation become more and more hard to fulfill for the car manufacturers. Much research has been done in the field of physical modeling of the system, but in this work a linear adaptive time discrete ARX-model is developed and validated.The systems tendency to change its dynamic during usage implies that the model must be adaptive. The developed model proved to be well functioning and shows promising conditions for the MPC design.

This report is about the impact climate change has on the water and sewage systems in general, and the situation in the municipality of Karlstad in particular. Which vulnerabilities are linked to water and sewage systems with regard to climate change and extreme weather situations, what are the possibilities to adapt the system to this and what significance does climate adaptation of the water and sewage systems have in relation to sustainable development?To answer these questions I have studied literature on the subject and interviewed several people who work with these types of questions. The answers I have received state that there are a multitude of vulnerabilities linked to the water- and sewage systems, but that there are also many strong interests which strive to take measures and adapt to a changed climate. I have also come to the conclusion that the starting points and views of the possibilities to act differs between the people that I have interviewed, but that theses problems are built into the concept of democracy..

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

Timber floating operations in Scandinavia during the 19th and 20th centuries has contributed to severe negative impacts on riverine ecosystems. Increase in water velocity and lack of stream bed heterogeneity as a result of stream channelization lead to increased bed load transport. Since availability and recruitment of new suitable spawning substrate in Scandinavian watercourses is sparse, spawning habitats for salmonids has become a scarce commodity. Lately, increasingly more attention has been given to the recreation and improvement of brown trout (Salmo trutta) spawning habitats in restoration projects. While much of the research on spawning habitat has been focused on evaluation of the influence that the constructed spawning grounds have on fish populations, few studies have been conducted to evaluate the persistence of these constructions over time. I evaluate erosion of constructed spawning beds as an effect of sediment transport attributable to water discharge.

Lake lowering in sulphide-rich areas is currently a major environmental impact for surface water. This study focuses on whether there is a relationship between a gradient of lake lowering and surface water impacts in areas of sulphide-rich sediments, in order to better understand their contribution of heavy metals and sulfuric acid. Also, is it a reasonable method to use the reduced lake area in order to quantify the gradient? The survey was conducted by collecting water samples from reference lakes and lowered lakes from south to north in coastal areas within the county of Västerbotten. Water samples were then analyzed for TOC, pH, conductivity, anions, base cations, alkalinity, acidity, sulfate, Al, Cd, Fe, Mn, Cu, Zn and Pb.

ICA vill utveckla sitt miljöarbete i vattenfrågor. Denna rapport syftar till att öka medvetenheten hos ICA om verksamhetens miljöpåverkan genom att analysera vattenfotavtrycket ? vanligen kallat Water Footprint ? för ett livsmedel. Vattenfotavtryck är ett verktyg inom miljösystemanalys som används för att kartlägga sambandet mellan produktion och konsumtion av produkter och vattenanvändning. Studien visade att vattenfotavtrycken är ungefär 14 500 liter/kg och 16 500 liter/kg för svensk respektive irländsk nötfärs.

Amongst the published literature researching wet cleaning of paper there is a limited amount of studies conducted researching the method simmering water treatment. There are even less studies conducted on how simmering water affects the paper being treated when used as a cleaning method. Despite the limited research, there are literary reviews describing the method and suggesting it as an alternative for conservation of paper with iron-gall ink. The following study will therefore be examining, the somewhat unusual method, simmering water treatment, and comparing it to one of the more common wet cleaning methods: immersion washing. This is done to compare how the different temperatures of the water affect the paper. The types of paper used in this study consists of three dyed and four undyed papers. All of the papers are new, apart from one sample originating from 1847.