This master's theses was carried out on assignment from Stockholm Vatten AB as a part of a project developing new waste water treatment techniques. The goal of the theisis has been to evaluate an anaerobic membrane bioreactor for treatment of waste water from Hammarby Sjöstad. The bioreactor has not been heated and the main interest has been to study the gas production, power consumption and the reduction of organic matter and nutrients.The system has been completed with a reverse osmosis unit and a total of four batch runs have been made with good results. The use of reverse osmosis allows nutrient in the waste water to be reintroduced into circulation as the reverse osmosis concentrate can be used as crop nutrient.The membrane unit is of VSEP ("Vibratory Shear Enhanced Processing") type and an extensive membrane test has been conducted. This so called L-test helped determine the most suitable type of membrane for the system to allow a higher ±ux and thus lower power consumption.

SAPA´s resource of waste heat is the basis for this thesis to investigate the possibility of energy assets in their cooling water and possible uses for it. The energy in the waste water is greater than the current need which has three uses which are (1) heating the factory, (2) converting liquid propane to propane gas and (3) local domestic heating. The average energy load that is available is 1, 7 MW and the average temperature in the cooling water is 41°C. The total energy load at dimensioning out side temperature is approximately 1,6 MW for the three current uses. The temperature is currently too low to be used directly in the existing systems so an upgrade is needed.

The report comprises two separate parts:part 1:  Temperature needs for district heating in the paint shop for axles in building 210part 2:  Energy and low temperature waste heat solutions in heating and cooling systems for   building 64 with surroundingsThe paint shop for axles in part 1 has air quality requirements in places for coating of axles. Toachieve desired air properties there are different process ventilation systems, which consist ofventilation coils for heating and cooling, plus air humidifier. The ventilations coils for heating usedistrict heating. Today the ventilation coils use water of 100°C to achieve necessary air demands inthe coating boxes. This part of the report investigates whether the existing system would achievethe air requirements with a water temperature of 75°C instead of 100°C in the ventilation coilsduring the coldest parts of the year.

Hammarby Sjöstad is a new district in southern Stockholm. A main objective with the Sjöstad project was to halve the environmental impact compared to other construction work. The environmental goals involve a halved water consumption rate, a local treatment of storm water and trials aiming to extract nutrients from the waste water. Sjöstadsverket is an experimental treatment plant used for testing new treatment processes for domestic waste water from Hammarby Sjöstad. The results are to be compared with the conventional process used at Henrikdals treatment plant today.

Titel: Waste Management ? Förbättringsförslag av återvinningsprocessen inom hemelektronikbranschen. Bakgrund: I en bransch som kännetecknas av snabb teknologisk utveckling är det viktigt att se till att de produkter som kommer ut på marknaden också tas om hand på ett bra sätt i slutet av sitt funktionella liv. Hur ser återvinningsprocessen hos företagen ut idag och vad kan göras för att minska de växande problem som framkommer i samband med den ökade konsumtionen? Genom att granska fenomenet Waste Management avser uppsatsen angripa slöseri i logistikflödet och finna förbättringar av dagens återvinningsprocess av uttjänta hemelektronikprodukter.

A bioslurry reactor was built for the bioremediation of TNT contaminated waste from the demilitarization industry. The field test was conducted at Vingåkersverken in Vingåker, Sweden, to see if results from laboratory studies could be repeated in a full scale reactor. The goal of the project was to optimize the reactor to such a degree that it could be used to handle the waste produced at Vingåkersverken and also that this technique could be applied for remediation of contaminated soils. Unfortunately the samples taken during the full scale field test were destroyed by the shipping company and no analysis was possible. A later attempt by the Biorex research group has also been unsuccessful to reduce the amount of TNT using the bioreactor.

The aim of this study is to describe ideas put forward by Sweden Democrats (Swedish: Sverigedemokraterna) about Christianity in Sweden and the Church of Sweden as a Folk Church, a church for a whole people, and how the political party uses Christianity as a part of constructing a Swedish identity. The investigation is based on official documents, newspaper articles, statements and political motions which are analysed using a form of text analysis called idea analysis. The theoretical frame of the investigation is founded on Claire Mitchell?s theory about religious content in ethnic identities and Einar Billing?s and Johan Alfred Eklund?s thoughts about what makes the Church of Sweden a Folk Church.The investigation shows, among other things, that the Sweden Democrats? view of the Church of Sweden is similar to the thoughts of Eklund but they differ in their lack of references to theology. The investigation also shows that Christianity serves as an important marker for the Sweden Democrats in creating a Swedish identity. .

Göteborg Energi has a surplus of district heating during spring, summer and fall. The heat surplus is due to a constant production of waste heat from oil refineries and heat from waste incineration over the year. It would be desirable to increase the demand for heat and the uptime for the newly built combined heat and power generation plant, Rya Kraftvärmeverk. One alternative could be to integrate Rya Kraftvärmeverk with a pellet production facility. By producing heat, electricity and pellet in a joint process the energy use can be decreased.

In the pilot plant at Hammarby Sjöstad, Sjöstadsverket, several new methods are tested in order to achieve a good use of resources. When a new technique is considered it is often the performance of the technique itself, under given conditions, that is evaluated. However, in order to evaluate the overall function the whole picture is needed. With a system analysis it becomes possible to make a comparison where all the positive aspects are put up against the negative ones, for the technique itself as well as its requirements. In this way the influence that minor components have on an entire system can be considered.This report presents a system analysis of an anaerobic membrane reactor (MBR) with a VSEP-membrane (Vibratory Shear Enhanced Process).

The concept of sustainable development has been pervasive in recent years and many organizations choose to implement sustainability and adapt their activities accordingly. The purpose of this study have been to explore how a collaboration on the use of waste materials may look to analyze what influences cooperation. A case study has been carried out examining a Swedish state regional project aimed at creating partnerships between actors and utilizing textile waste with the help of design. The study was conducted using qualitative methods and the collection of data has been done through interviews and by examining documents. The results show that there are seven key factors that affect cooperation: expectations, commitment, internal communication, a strong non-profit actor, individual treatment, personal networks and the diversity of actors.

Global warming is a huge issue that humans have contributed to through over-exploitation of natural resources and extensive usage of fossil fuels. Now more than ever, we need to embrace a recycle thinking and reuse our waste, for example through producing biogas from our food waste. The purpose of this report was therefore to identify the energy usage and emissions resulting from the biogas chain which spans from Solna Stad to Uppsala Vatten. Furthermore, potential efficiency improvements were to be identified and proposed. This report focused mainly on the first part of the biogas chain that includes the collection of the food waste and the reloading process.

In this study potential health risks for employees in connection with handling of bottom ash and bottom ash water at a Municipal Waste Incineration (MWI) plant have been investigated. Air surrounding the bottom ash and the bottom ash water has been examined. MWI is one of the primary ways to manage solid household waste, and bottom ash is the main solid residue produced by the incineration process. Bottom ash constitutes about 15-20% of the original waste. The bottom ash is extinguished in a water bath (bottom ash water).The study was carried out in a MWI plant in Karlstad, Sweden.

The municipality of Västervik, with support from Envipro Miljöteknik AB, is carrying out a main study of the minefields at Gladhammar. Mining of iron, copper and cobalt under different periods from the 16th century until the end of the 19th century has led to discharges of metals to the lakes situated downstream. The aim of the main study is to investigate the possibilities to reduce the environmental load on the surrounding ground and water caused by heavy metals from the mine. The present report is a part of the main study. The aim of the work is to investigate the geochemistry of the groundwater.

The purpose with this thesis is to analyse different factors that can explain district heating prices for energy companies in Sweden. We are further interested in examining if the prices is affected by the use of industrial waste heat in their production and the company?s ownership structure. The method applied is a multiple regression analysis using a panel data set of 50 companies over 5 years (2008-2012). The data used is yearly data obtained from the Swedish district heating association.

The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.