This report is commissioned by the Water and Sewage Agency in The City of Mariehamn, Åland. The basic aim is to investigate positive or negative effects of a relocation of the sewage pipe from a wastewater treatment plant, Lotsbroverket. The environmental licence of Lotsbroverket is to be revised and The Environmental Appeal Board at Åland?s Government and Administrative Board has made demands that several possible locations in an outer water area should be examined. The present location of the sewage pipe is in Svibyviken, which has been classified as an ?inner water area?.The objective of this work is to study to which extent the nutrient loading from Lotsbroverket influence the environmental conditions in Svibyviken, and to investigate the suitability of different locations of the wastewater pipe from Lotsbroverket.The way a coastal area looks, i.e., its morphometry, determines to a large extent its ecological characteristics.

This thesis work has been carried out at the consultant company Pöyry Sweden AB in Norrköping, whom performs the task for E.ON heating Sweden AB, Händelöverket in Norrköping. The report shows methods to manufacture slurry consisting of fly ash and water. The slurry shall be pumped into several former oil storage rock shelters that E.ON has put into operation for the specific purpose. The ash mixture also develops hydrogen gas in contact with water.The work has aimed to produce different suggestions of methods and equipment that can be used for the objective. Mixing method and security issues were in centre while working with the suggestions.

A renewed application for environmental permit for the Hovgården landfill in Uppsala shall be submitted before December 2004, therefore the municipality of Uppsala needs improved knowledge of the contents, mostly organic compounds in the leachate and they also want to find a method to minimize the emissions of these compounds. The purpose of this study was to find a practical and economical method based on chemical oxidation using oxidants. The oxidants investigated are Fenton's reagent, hydrogen peroxide, Oxypro, potassium permanganate and potassium persulfate. The study was made on untreated leachate and leachate that has been treated in an aerated dam followed by sedimentation dams collected from the Hovgården landfill, and alson on sludge water from sludge storage cells. The effects of the five oxidants have been established by analysing the UV absorbance at the wavelengths 253,7 nm and 260,0 nm at different pH values. The UV absorbance was used to indicate the amount of aromatic hydrocarbons in the water. Also analyses of iron and manganese were done after the experiments with potassium permanganate, hydrogen peroxide and Fenton's reagent.

For several years Uppsala University together with several companies has been involved in a WISENET project aimed at improving railway transport security. By placing a sensor system near the wheels of each wagon, the temperature of the bearings can be measured and transmitted to a collector placed centrally on the wagon. This in turn transmits the collected data to RFID receivers placed intermittently along the railway.As the signals are transmitted wirelessly, problems may occur as the antennas get dirty or coated with ice and snow. To determine the effects of these coatings, several tests were performed examining the reflection coefficient S11, the impedance Z11 and the efficiency eta of an antenna, and how they varied when various coatings were placed over the antenna. Examined coatings were ice, snow and water to determine the effects of weather, and various metal-based coatings: powdered iron both pure and partially oxidized, and iron ore granules.

Running water-pathways have played an important roll in Sweden and frequently been manipulated. One profound change was made during the period of logging when streams were cleared from obstacles as big boulders, sharp bends and side-streams. Dams and different constructions gave control of the stream water and the streams became channel-like with a homogen structure. This interference gave problems for many fish populations and resulted in a shortage of feeding habitat, over-wintering habitat, spawning habitat, unnatural flow regimes, sedimentation, unnatural temperature fluctuations. Many of these historical changes of the watersheds are now subjects for restoration, ie., bring back the streams to what we believed it was before the change. However, what once existed in terms of complexity is now gone and difficult toreplace.

Saab Training Systems (STS) in Huskvarna is manufacturing material for educationalpurposes to armies worldwide. They are now implementing parts of the Lean productionconcept in their organisation.One part of the work with Lean production is to eliminate waste. To be able to identify waste,value stream mapping is a good tool and also what we used in our thesis. To gain a betterefficiency in the production of Personnel Detector Device (PDD) flow was one of our goals.The PDD is a harness used during battle training which registers if the user is being hit by itsenemy.Our work with the thesis started up with a short education in Lean production and in valuestream mapping (VSM). The work proceeded with a VSM of the production flow of the PDD,interviews were made and studies of literature were done to gain greater knowledge of thesubject and solve the task.The VSM resulted in five areas which were followed up out of those six we identified.

Traditionally, rolling mills use emulsions based on a mixture of oil and water for lubrication. Since two years ago SAPA has been using (instead of oil) a synthetic lubricant so called conditional emulsion for hot-rolling of aluminum. This lubricant is water based and homogenous at ambient temperature, but switches to a two-phase system at heating above the cloud point.This project aims to validate and if necessary modify an existing HPLC method for quantifying two out of three key components (A, B and C) in the conditional emulsion. Attempts to develop a method to quantify the pH adjusting components, X and Y were also made. These two methods are required to optimize the lubricant.Due to the complexity of the components, it has been difficult to present a method for quantification, and HPLC with ELS detection was chosen after a long series of trials.

The purpose of the work is to analyze and balance an assembly line at Fläkt Woods in Jönköping. The work is going to answer the questions about today?s throughput time, how much waste that occurs, number of staff at the assembly line, how the supply of material works and possible improvements that can be made at the work stations. The work is also going to give a proposal of improve-ments that can be made.The methods used to get the result include observations and measurements, con-versations with technicians and operators and also data from Fläkt Woods? data-base.Large variations in throughput time are measured during the measure period, from 3 hours up to 5 hours and 35 minutes.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production.The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with thenmeasured time of usage.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production. The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with the measured time of usage.

When the producers? responsibility for packaging was introduced in Sweden in 1994 the industry set up public recycling stations to facilitate the collection of the waste material. In order to establish recycling stations at suitable locations the municipalities assist the industry?s service organization for operation of the recycling stations, the Package and Newspaper Collection Service (Förpacknings- och tidningsinsamlingen, FTI). The objectives of this thesis are to improve the service of the public recycling stations within Lidingö town and to increase the accessibility to these stations for the inhabitants of Lidingö.

Interference in an ecosystem means a disturbance. When harvesting, forest roads have to be build to cope with heavy duty vehicles. Crossing brooks can not always be avoided. In this case bridges or culverts have to be built. There are many different kinds of culverts and depending on what type you choose and how you place the culvert, the watercourse and the water organisms can be harmed in different ways.

The construction industry can contribute to a healthier sustainable community. A development that is going on right now is by using more prefabricated volume- and plan elements on the construction sites. Building with this method not only provides a benefit to the environment, but also reduces production rates by taking up to 80 percent less time to build. By building in this way it will be easier to recycle and keep all the material that otherwise would go to waste. Also by building inside a protected environment, the material retains its good quality.This report will take forward proposals on further development of prefabricated volume element of wood, by first presenting this construction methods advantages and disadvantages..

Successful broiler production in hot climates requires knowledge of how birds are affected by heat stress. It is important with access to water and good ventilation to facilitate coping with the heat. It may be useful to reduce the consumption of feed during the hottest hours of the days, which together with a few hours of extra light available could improve both productivity and animal welfare. The vision in birds is superior to that of humans and most other mammals. Continuous light and light with low intensity can cause eye injuries, affect the eye development in young chicken negatively, as well as provide increased incidence of foot pad lesions. Access to light affects the production but also the welfare of birds.

The aim of this study is to investigate which communication strategies and channels the mu- nicipal company Falu Energi & Vatten should use in order to become more efficient in com- municating with citizens between 18 to 29 years old. The company is owned by the munici- pality of Falun and manages community services in electricity, district heating, fresh water, sewerage, metropolitan area network and waste disposal. The following theories have been used in the study: convergence culture, digital natives, information overload, communication strategies and uses & gratifications theory. The methods used in the study are 4 focus group interviews and one informant interview. The members of the focus groups where within the age range 18-29 years and lived in the city of Falun.