Pharmaceuticals that are found in marine ecosystems are a threatening environmental concern, which is known to harm both animal and plant life. One of the reasons for this problem is that the waste water treatment techniques are not optimized to clear waste water from its pharmaceuticals contain. In this master thesis four Swedish treatment wetlands were studied, and their ability to reduce numerous pharmaceuticals in waste water. The four treatment wetlands that were studied were those in Oxelösund, Trosa, Nynäshamn and Eskilstuna. Two ecotoxicological tests and chemical analysis were used.

The company Sol & Energiteknik wanted to examine the possibility to make a standardhouse totally energy independent. Based upon this I have, during the spring of 2007,examined the possibilities available at the market today through litterature studies, contactwith several companies and reading reports at the internet.The first thing to examine has been to determine the energy consumption for a standardhouse, and find out if there are better technologies to be used for energy conservation.My conclusion in this matter is that there are possibilities today for building a house moreenergy efficient.When I had reached the point at which my design for the house was decided, I also hadto choose the different products to use to produce energy as well as to store that energy.To produce heat and electricity to the house I decided to use a wind turbine and a solarwater heater.The most difficult part of designing a house that is energy independent is that theproduced energy must be stored somehow. Storing the heat is relatively easy beacuse theheat can be stored in a large water tank. The electricity is a bigger problem beacuse itmust be stored in batteries, which today are too expensive to be used in a standard house.In the future producing and storing hydrogen might be used to produce electricity, buttoday that technology is both expensive and not tested enough.My final conclusion is that a standard house can not be built to be totally energyindependent today, unless it is very expensive to connect the house to the electricitynetwork. As an alternative solution I came up with a proposal for a house which isconnected to the electricity network and have some amount of own produced energy.This house prooved to be a good investment if you choose to build it today, and it couldbe a very good investment in the long run beacuse energy prices increase every year..

Abstract: The purpose of this study is to examine whether companies listed at Nasdaq OMX Stockholm (Stockholmsbörsen) sanctioned by the legal unit Nasdaq OMX Disciplinary Committee (Disciplinnämnden), could be distinguished from the remaining companies that have not been sanctioned. As Stockholmsbörsen is the most influential unit when trading shares in Sweden, listed companies need to behave in legal aspects. Actions and decisions that affect investors do also influence the listed companies and their performance. Some companies might be tempted to manipulate financial statements and public information to retain stakeholders; other miss to report properly without being fraudulent. To control this, the legal unit Disciplinnämden is introduced.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The energy use in a workshop company has been examined in this work in order to find areas for energy efficiency improvement. The combined oil and electricity heating in the company were compared with other alternative heating systems including cooling of the premises in following combinations:Ground source heat pump for heating and coolingDistrict heating and absorption coolingDistrict heating and low temperate surface water coolingEnergy use, operation costs and carbon dioxide emissions were calculated for the current heating systems and the three alternatives including cooling. The ground source heat pump for heating and cooling decreases bought energy with 34 MWh annually compared to current heating only. The district heating and low temperate surface water cooling has the largest reduction of operation cost and carbon dioxide. The operation cost decreases with 42 kSEK and the carbon dioxide with 43 metric ton CO2 annually.

The need for snow-free surfaces at squares, bus stops, platforms, car parks and sports facilities increases and at the same time energy price rise and the environment is becoming a hotter issue. The construction of the ground heating systems often lack thermal insulation under the heating pipes, which means that the heat from the pipes not only warm up the soil surface but also heats the surrounding soil. The insulation also has more features, by insulating the risk of frost damage is minimized. The goal of this report is to demonstrate the large heat loss and energy costs in the absence of insulation under the heating system.The report begins with a scientific way to study and treating the soil heating system uses, and the theory involved. Furthermore it also deals with different routing principles of heat pipes depending on the facility.All calculations are made with so called finite element method (FEM), in COMSOL Multiphysics 3,5a, where models are created with different conditions.

BAE Systems Hägglunds has a long history of producing high performance terrain tracked vehicles (mostly for military applications), and they are now aiming at developing a tracked forwarder with similar techniques.The forwarder will be of series hybrid type where a diesel engine via a generator will power the motors (one for each drive wheel). Thanks to individually controlled motors and the gentle rubber tracks, this forwarder is calculated to have a considerably higher average speed in the terrain and to be more gentle to the soil. The forwarder with a weight of 11 metric tons and a load capacity of 15 metric tons is specified to have an average working speed of 7-10 km/h, a top speed in terrain of 15 km/h and a top speed on roads of 40 km/h.This master?s thesis aims at developing a conceptual design of the forwarder?s drive module which includes electric motor, gear unit, brake and drive wheel.To investigate if the requirements can be fulfilled a study of the dimensioning loading scenarios has been carried out. The resulting needs regarding the torque has been considered in order to determine the required gear ratios for different motor options.

Along with rising energy prices and increasing awareness of environmental issues, the criteria for buildings energy performance have been sharpened through the years. Today, ?passive house? and ?low energy house? are commonly used phrases in the construction industry and is expected to become increasingly common in the future.For houses with well-insulated building envelope the importance of well constructed details increases when minimizing the heat losses. Examples of these details are floor-wall junction and window openings in the wall. In such connections thermal bridges occur, which means that heat more easily is transported out of the building, compared to the rest of the building envelope.This report deals with detail solutions around windows and a comparison between a traditional slab and a foundation from Koljern consisting of foam glass.

Heat stress negatively influences the performance of dairy cattle such as lactation and reproduction. Heat stress can cause production losses as well as welfare problems. Years of research have shown that heat stress is a huge problem for dairy cattle in both the tropics and temperate zones but no such research have so far been done in northern European countries. It seems like shade is an important tool when improving pasture conditions and therefore deserves more attention. The aim with this study was to investigate whether there is a need of providing shade for grazing dairy cows during the summer in Sweden. Two groups of lactating Swedish Red dairy cows (n=15 per group) were kept on pasture.

Finnhamn is a small group of islands in the Stockholm archipelago. At Stora Jolpan, the biggest island, there is a hostel. The main building was built in 1915 and is called Utsikten. The purpose of this project is to on behalf of the Archipelago Foundation (Skärgårdsstiftelsen) find alternative systems that can replace the existing heating system of Utsikten (an oil-fired boiler and electricity heaters) to a system with renewable energy. The alternative system that this project focuses on is a system of solar collectors combined with a wood chip boiler.

Syftet med undersökningen är att arbeta fram en modell för hur företag bör arbeta innan, under och efter en kris för att bevara sitt varumärke. Studien baseras på en kvalitativ undersökning där primärdata insamlats via intervjuer med sex experter inom området kriskommunikation. Ett abduktivt tillvägagångssätt har används då fokus växlat mellan empiri och teori, men där största fokus legat på empirin. Teorin har insamlats via litteraturstudie där vetenskapliga artiklar hämtats från olika databaser, såsom google scholar och ABI/inform. Slutsatsen genererar i ett verktyg i form av en modell som ger riktlinjer på hur företag kan arbeta innan en kris för att förebygga och förbereda. Den visar även på hur företag arbetar under en kris för att minimera skadan av den samt hur de på bästa sätt kan återhämta sig från den.

Konkurrensen mellan hotellen idag ökar kraftigt. Hotellen måste fokusera på att verkligen göra gästerna nöjda för att de ska kunna konkurrera på marknaden. Oavsett hur bra service hotellen har så har det visat sig att misstag i servicen är oundvikliga, vilket ställer höga krav på hotellen att reparera sig från dessa misstag. För att hålla gäster nöjda krävs en god "service recovery", att vända missnöjda gäster till att bli nöjda. Receptionisterna är de personer som möter flest klagomål eftersom de interagerar med gästerna kontinuerligt.

HemoCue AB is a multinational corporation targeted on manufacturing point-of-care analysisinstruments for medical treatment. Their main product, the DM 201, is outdated and has bigissues gaining new market shares. For example, no medical treatment center in Sweden usesDM 201 frequently. The project of developing a new instrument to replace it was assignedtwo students at the development engineering program at Halmstad University. The projectalso included integration of the new platform for DM 202 to HemoCue AB:s remainingproducts.The project began by defining the different technical areas concerned.

The purpose of this thesis for Sapa Heat Transfer is to examine a furnace in which aluminium is pre-heated before hot rolling. The project is modeled in a computer environment in which the air flow in the furnace and the heat transfer to the aluminium solids are included. The computer environment and its governing equations, as well as boundary conditions and generalizations, are presented and explained.The simulations are based on two models. The first model has an asymmetric solid placement, which is how it looks in today's ovens. It is validated against collected data.