Studies show that 10-15 percent of Sweden's population, 65 years or older are estimated to have depression or depression symptoms. The symptoms of depression among elderly people are less than symptoms of young people. This could cause that elderly people with depression are not always discovered. Studies show that elderly people who live in residential homes show more signs of depression than elderly people living at home. If elderly people live in a supporting environment, can it prevent that a depression developed.The prevention of depression among elderly people is a topic that is not discussed among previously research.

The main project Dry preservation of food waste from households includes a new technique concerning drying and storage of dried biowaste as well as a study of the sorting of household waste and further usage of the dried biowaste. A question asked in the project is, can the dried biowaste be used as a soil amendment? If organic waste is used as a soil amendment, precaution concerning hygienic safety risks has to be accounted for. The objective of this M. Sc.

The study aims to reduce energy consumption in apartment buildings where individual metering and charging of heat is applied. The aim is to develop planning and design for individual metering and charging in apartment buildings.The study is based on literature review, interviews and case study that include analysis of existing documents. Interviews were carried out with the property developer and the involved consultants who planned the apartment building Yasuragi. To investigate the differences the condominium association has noted in heat consumption between flats, the debit values of the heat were used to discern which houses that were furthest from the average consumption. On these flats there were temperature measurements and thermal photo shoots made for discriminating behavior and possible construction techniques which could be the explanation for the heat spread.Boverket shows that the consumption of heat can be reduced by 10-20% after insertion of individual metering and charging in an apartment block.

This degree project handles acoustic measurements of the heat pump EcoAir 107, made by Enertech CTC AB. The sound from the three sound sources of the heat pump, fan, compressor and four way valve, have been measured to find out how they affect the total sound level of the product.Measures to attenuate the sound level have been developed and tested. By comparing these with the sound of the heat pump, in its original state, we have found out the measures which have best effects.The best attenuating measures came to be: taped openings and holes around the compressor space, isolating the top and the bottom of the whole construction, support of the fan bottom part and shielding of the sound source with a screen at a distance of 110 mmThese measures have been tested together and an average attenuation of the total sound level with 3,9 dB have been accomplished. In the front of the fan where the continuous sound is the strongest, the attenuation was 4,7 dB.This project is meant to be used as a guide by Enertech CTC AB:s during their future developing process..

Swedish Armed Forces are according to their development planning process taking actions to establish a new joint unit (SWEWOSE), with electronic warfare capability. SWEWOSÉ S main task will be designated to produce electronic warfare libraries for electronic warfare systems within the armed forces. The unit shall have capability to support with libraries in any state of conflict situation even if the supported unit with library needs conducting operations abroad.This essay examines the requirements that justify the establishment of a new unit in times when the armed forces conducting reorganizations and cutbacks in both economy and personnel.The possibilities to buy complete system solutions from an external supplier are examined. But also what kind of library support model that is to prefer according to the demands that the Swedish Armed Forces desired, in terms of capability in platform protection and battle space awareness.The results show that the demands that the Swedish Armed Forces has decided, best will be ful-filled and justified by a national electronic warfare unit, with library production as a main task..

This study is based on the public eldercare assistances administrators and unit managers perspective. The purpose of this study is to describe and understand how the assistance administrator and unit manager approach elderly needs, who can be harder to accommodate as well as alternative providers that also can meet the needs of the elderly. It is important to gain more knowledge about how assistance administrators and unit managers look at these aspects, what their attitude and approach is towards them. This is important to learn more about because the assistance administrators and unit managers have discretion in their work and the power to change and affect the elderlys situation in a significant way. They decide on actions and design implementation to meet the needs of the elderly and enable them a reasonable standard of living.The choice of method used in this study was qualitative through semi-structured interviews, conducted with assistance officers and unit managers.

This report is made as a literature review, focusing on the work done to increase understanding of efficiency in the categories of substations and secondary heating systems, with respect to the deviation from the theoretically possible cooling off in the distribution network as well as the economic benefit that appear. The main purpose of a considerable part of the literature used in this report addresses the issue of identifying individual causes of reduced cooling in district heating systems. These literature resources have been compiled and summarized as part of the report.The technology of district heating is associated with benefits such as better use of the energy in a fuel. This is the case of cogeneration plants where serial generation of electricity and thermal energy increases efficiency compared with the parallel generation where heat is generated locally and electricity is generated centrally. Serial generation thus allows for lower primary energy demand.

Some people who recovered from exhaustion disorder report that their lives feel more meaningful after the disease than before, despite residual symptoms and difficulties. This experience of increased meaningfulness has been linked to sense of coherence, SOC. The research question was whether individuals with exhaustion disorder at onset has a weak SOC, and if there is a general increase towards a higher SOC value ??during the recovery process. In a cross-sectional study, data were gathered on the SOC value via the SOC 29 form.

This report, written by Ma?ns Ridze?n and Jonas Stenberg, presents the thesis carried out the spring of 2012. The authors met the first time in 2008, when they started their studies at Uppsala University. Since then they have completed various projects, both within and without the university. This study is based on a theory that was first conceived when Jonas Stenberg did his internship in the summer of 2010.

The purpose of this essay is to draw attention to the obstacles that affects the internal trade of waste within the EU. The essay doesn?t in any way encourage pollution or illegal handling of waste but unfortunately there are large profits to be made from illegal destruction and recycling of waste and especially hazardous wastes. Therefore the dependable companies handling waste must access a market with fast and flexible (but predictable) regulations as well as lower transaction costs to help make the environment better and encourage a strive for increased recycling. There are examples where some waste only can be sent to a land-fill within the country but could be recycled in other EU-countries.

The evaluation of the function of the feeding of sheep herds is suggested to involve the work effort, the fulfilment of the nutrient needs of the sheep and the feed waste. Mechanisation of the feeding can be very simple or include high degrees of mechanisation. Three different farms, representing different levels of mechanisation are presented. Descriptions and analysis of the feeding systems including mechanisation, work effort and estimations of the feed waste are made on each farm. The herd with the most advanced feed mechanisation included a rolling feed band and mix wagon. The other farms were partly or little mechanised including ad lib feeding from big bales and manual distribution of hay and concentrates. The most mechanised farm was able to feed a large herd of sheep at a low work effort and little feed waste. However, the investment in machinery has to be weighed against the improved efficiency.

An investigation of the heat impact of laser cutting on the material properties when producing tensile and impact test specimens of different steel types of varying thickness has been performed. The purpose of the thesis project was to provide recommendations regarding how much material that needs to be milled from the laser cut edge before tensile and impact tests. The study has been performed partly by investigating the test specimens by heat camera when the specimens were cut in the laser cutting line and partly by performing hardness tests, investigation by microscopy, and tolerance and roughness measurements and tensile tests of the laser cut material and material produced in the traditional multi operation machine. The results show that the heat affected zone in the thicker materials is greater than previously thought of, and that the currently used recommendation has to be adjusted. The study clearly shows that the thicker the material, the greater the heat affected zone, independently of the steel type, since the thicker material takes longer time to cut.

The production costs have steadily increased within the construction industry during the 21st century. Voices are raised meaning that the construction industry is too unsuccessful in making the production more efficient and to develop it?s way of working. One way to deal with the production costs is to minimise the waste, with waste meaning activities that doesn?t add value to the finished product.

According to recent statistics the construction industry is responsible for the largest waste discharges of both dangerous and non-dangerous waste, when disregarding the "non-dangerous" amount of granite waste produced by the mining industry and the waste produced by the pulp and paper industry. Preventive work within waste management is an ongoing practice so to be able to reduce negative environmental effects. One of the most common actions for the companies to take is to separate the different kinds of waste from one another at the construction site. Although by working with the problem in earlier stages of the process a large amount of the waste could already have been reduced.Companies in the construction business that are actively working to decrease environmental impact in their operations often use an EMS (Environmental Management System). By using environmental management as method the company can manage their environmental work so that actions can be taken where they are needed the most.

To achieve the requirements to decrease emissions of greenhouse gases by 20 % by 2020, Swedenneeds to increase its use of bioenergy. In doing so it seems natural that those who already haveaccess to large amounts of biofuels in the form of by-products such as straw, wood chips anddigestible materials take advantage of these assets locally. By combining production of heat withpower production at the farm it may be possible to not only reduce the direct use of fossil fuel forheating but also reduce energy costs.The purpose was to simulate different cases of using a small scale biofueled combined heat andpower plant for farm-based systems. A MatLab-model was developed and used to draw conclusionsabout the costs for production of heat and electricity with different conversion technologies.The model uses climate data to simulate the variations in heat energy demand on a day-to-day basis.The given heat demand is the base of the simulation and from this the possible electric output iscalculated. This study has focused on the impact of the following properties: electric-, heat- andtotal efficiency, fuel, fuel price and specific fuel requirements.