Swedish Armed Forces are according to their development planning process taking actions to establish a new joint unit (SWEWOSE), with electronic warfare capability. SWEWOSÉ S main task will be designated to produce electronic warfare libraries for electronic warfare systems within the armed forces. The unit shall have capability to support with libraries in any state of conflict situation even if the supported unit with library needs conducting operations abroad.This essay examines the requirements that justify the establishment of a new unit in times when the armed forces conducting reorganizations and cutbacks in both economy and personnel.The possibilities to buy complete system solutions from an external supplier are examined. But also what kind of library support model that is to prefer according to the demands that the Swedish Armed Forces desired, in terms of capability in platform protection and battle space awareness.The results show that the demands that the Swedish Armed Forces has decided, best will be ful-filled and justified by a national electronic warfare unit, with library production as a main task..

When planning new wind farms, the cost for the internal electrical grid is estimated to account for 8-9 % of the total investment cost. On top of that, the cost for accumulated reduced income over several years (due to electrical losses), has to be added. The economic lifespan is relatively long (about 20 years) which means that an error in the loss calculation could lead to a bad decision basis. The accumulated reduced incomes due to electrical losses can be higher than the initial investment cost for the internal electrical grid.Today, Statkraft Sweden is using a template number when estimating the electrical losses in a wind farm. The actual losses are probably lower than the template number which could lead to an unnecessary high loss cost when planning a new wind farm.The aim of this M.Sc.

This study describes and reviews horse stable equipment from companies who builds and sells the equipment. In the study the companies various equipment was compared with regulations in the law of prevention of cruelty to animals. The purpose with this study was to find out if the companies stable equipment are approved according to the regulations within this area. The study used at five randomly picked companies.This study showed that three of the five examined companies refered, in one way or another, to the law of prevention of cruelty to animals on their website. Unfortunately not any of the companies referred to todays existing law of prevention of cruelty to animals.

This report, written by Ma?ns Ridze?n and Jonas Stenberg, presents the thesis carried out the spring of 2012. The authors met the first time in 2008, when they started their studies at Uppsala University. Since then they have completed various projects, both within and without the university. This study is based on a theory that was first conceived when Jonas Stenberg did his internship in the summer of 2010.

Individual identification of pigs could be used in commercial herds for production monitoring, disease monitoring and breeding evaluation. This study investigates the possibility of using microchips designed for dogs and cats to identify individual pigs from birth, through rearing to carcass at the slaughter plant. Two different sizes of microchips, and two different ages of the pigs at injection were tested. Castrates and gilts from ten litters were evenly distributed between chip sizes and injection ages. All pigs were identity marked with both electronic ear tags and injected with microchips.

The purpose of this essay is to draw attention to the obstacles that affects the internal trade of waste within the EU. The essay doesn?t in any way encourage pollution or illegal handling of waste but unfortunately there are large profits to be made from illegal destruction and recycling of waste and especially hazardous wastes. Therefore the dependable companies handling waste must access a market with fast and flexible (but predictable) regulations as well as lower transaction costs to help make the environment better and encourage a strive for increased recycling. There are examples where some waste only can be sent to a land-fill within the country but could be recycled in other EU-countries.

The evaluation of the function of the feeding of sheep herds is suggested to involve the work effort, the fulfilment of the nutrient needs of the sheep and the feed waste. Mechanisation of the feeding can be very simple or include high degrees of mechanisation. Three different farms, representing different levels of mechanisation are presented. Descriptions and analysis of the feeding systems including mechanisation, work effort and estimations of the feed waste are made on each farm. The herd with the most advanced feed mechanisation included a rolling feed band and mix wagon. The other farms were partly or little mechanised including ad lib feeding from big bales and manual distribution of hay and concentrates. The most mechanised farm was able to feed a large herd of sheep at a low work effort and little feed waste. However, the investment in machinery has to be weighed against the improved efficiency.

Swedish Trotting association was formed in 1925. They are the ones who design the regulations concerning what is permissible and not permissible for the horse, driver and trainer, when they have a license at a Swedish racing track. The Veterinary department of Swedish Trotting association decides in consultation with representatives from veterinaries around the country what is allowed and not allowed, based proven experience, combined with the availability of scientific data and Veterinary Department's own assessment. After stricter regulations for good animal welfare from the Swedish government, Swedish Trotting association is going to work out a workable model for how new equipment can be tested in the future to see how the equipment affects the horse. In the future, all equipment will be objectively tested before approved. The purpose of this work was to develop a well-functioning model for this. The research-question for this work is: Is this study design a well-functioning model of how the equipment should be tested in the future? The equipment used for designing this model was bitless bridle with a bit.

The purpose of the project has been to work out recommendations that reduce the energy-related costs and environmental impact of HPW Fresh & Dry Ltd., a fruit drying factory in Ghana. The factory produces electricity with diesel and biogas but also purchases electricity from the national electricity company. Heat for the drying process is produced from biogas, kerosene and solar panels. In the project the energy system was analyzed by measuring production and consumption of heat and electricity. The project results show that the factory can become self-sufficient on heat if the available energy is used more efficient. The production units for both electricity and heat have low efficiencies.

Active work to increase the efficiency of energy use is taking place in Sweden and throughout all of Europe. Electricity is an important part in our society?s energy system which means that the electrical grid operators and associated therewith has a central role in this work. Monitoring and controlling the electrical grids are managed from the distribution system operator?s DC, dispatch center.The aim of this report is to examine how the operations in a typical DC on the Swedish electricity distribution network will look like in five to ten years.

The aim of this two years master´s thesis is to examine discourses about electronic books in relation to libraries that occur in the Swedish library journal Biblioteksbladet by using critical discourse analysis (CDA). The thesis also aims to discuss changes in the discourse practice, and discuss the relationship between discourse practice and social practice in the field of library and information science (LIS). A main point of CDA is that language is a form of social practice that helps shape social reality. Furthermore the concept of ideology, as understood with-in CDA, brings understanding to the way discursive events help reproduce and transform social relations of pow-er. The text samples span from 2005 up to and including 2011 and were examined by using Norman Fairclough´s three-dimensional conception of discourse, which allows for interpretation of text on a linguistic, discursive and social level.The result of the analysis showed that there are several different discourses about electronic books and li-braries, none of which can be said to be particularly representative.

The E-department at GETRAG All Wheel Drive in Köping have problems with the efficiency on parts of their production equipment. The equipment with the most significant efficiency problems are four automated multifunctional production cells that produces housing for rear drive units. The major part of the problem is the large amount of small stops that causes the low efficiency.The department already worked with logging of interruptions and efficiency calculations before this project started. However this work was not done to the extent considered necessary for a systematic follow-up of the interruptions.The aim of this paper is to point out a more effective and systematic way to work with logging of interruptions and the follow-up. In addition the equipment were studied with a method for efficiency calculation that ? if used properly- is a more powerful and a visually better method than the one used by the company today.As the initial current state analysis of the equipment was made a lack of documented knowledge about the equipment was discovered.

The production costs have steadily increased within the construction industry during the 21st century. Voices are raised meaning that the construction industry is too unsuccessful in making the production more efficient and to develop it?s way of working. One way to deal with the production costs is to minimise the waste, with waste meaning activities that doesn?t add value to the finished product.

According to recent statistics the construction industry is responsible for the largest waste discharges of both dangerous and non-dangerous waste, when disregarding the "non-dangerous" amount of granite waste produced by the mining industry and the waste produced by the pulp and paper industry. Preventive work within waste management is an ongoing practice so to be able to reduce negative environmental effects. One of the most common actions for the companies to take is to separate the different kinds of waste from one another at the construction site. Although by working with the problem in earlier stages of the process a large amount of the waste could already have been reduced.Companies in the construction business that are actively working to decrease environmental impact in their operations often use an EMS (Environmental Management System). By using environmental management as method the company can manage their environmental work so that actions can be taken where they are needed the most.

The world?s growing need for energy together with a desire to ward off the worst consequences of global climate change has resulted in a never seen desire to invest resources in renewable energy sources. Biogas production through anaerobic digestion is one of those growing energy sources. In Sweden there are over two hundred plants that uses this biological process to break down organic substances while producing carbon dioxide and the energy-rich gas methane.This master?s thesis has focused on development of the mixture of different organic substances that is treated at a specific plant, namely Mosserud biogas plant.