By our employer Camatec Industriteknik AB have we been given the assignment to continue with the previous work ?Design of strip feeder?. Our goal with this work is to come up with a design basis for a strip feeder.Functionally a strip feeder consists of two rollers which with the aid of the friction between the strip and the coating on the roller create a strip force that pulls the strip through the working progress.Demands on this project:? 10 ? 600 mm in strip width and 0,1-1 mm in strip thickness.? Minimum 30m/min in production speed.? A maximum strip force on 30-40 kN.? The cost of the strip feeder?s components is to be considered of economy and quality.The need of a strip feeder occurs when the coil doesn?t manage to feed or pull the strip before or after a working process. The strip can otherwise be exposed by a permanent yield deformation or a change in the strip material if it?s pulled trough the working process only by the on ? and of-coils.

The Goal with this Master of Science thesis is to expand the possible turbine efficiencymeasurements on an exhaust turbocharger. It was done as a part of the CICERO competencecentre. To feed the turbine with air a special flow rig has been used. Instead of loading theturbine by just restricting the compressor flow a docking system for an electrical dynamometer isdesigned to use the dynamometer as an additional loading source. By using an electricaldynamometer as loading device for the turbine, measurements are not depending on compressorperformance.A large part of the work consists in designing accessories for the dynamometer.

Acupuncture has been used for thousands of years in China. Written documents concerning veterinary acupuncture has been found dated around 650 B.C. Acupuncture has gained greater acceptance in the western world the last decades and many countries have established their own veterinary acupuncture organizations. Many studies report good results after acupuncture treatment and back pain in horses is considered a good indication for acupuncture treatment. In studies published, the results are subjectively evaluated. To get a qualitative, scientific evaluation of acupuncture treatment, objective measurements, control groups and statistical analysis are needed. This pilot study presents a case where acupuncture has been used for treatment in a horse that was diagnosed with back pain.

During the years 1950-75 was the construction of building apartments in high speed. A rapidly growing reconstruction requirement is the consequence of the rapid construction speed in these years. The technical lifetime of the different parts of the buildings is about to end and the needs for reconstruction is huge. One of Sweden's national environmental objectives is to reduce the urge of energy in buildings. This calls for radical measures to implement energy efficiency of existing assistance particularly in the assistance that is now facing reconstruction.

By conducting interviews, studies as well as scanning the current scientific landscape, this paper examines the opportunities of increasing current capacity within the public transportation system in Stockholm with simple financial means for the benefit of the travelers. The paper focuses on the central station of the subway system and how adjustments of processes carried out in relation to the turnstiles could increase performance within areas of interest, given the preferences of the travelers. The theoretical framework of the paper includes models from the field of capacity management as well as theories related to the pedestrian behavior. Applying these theories and models to the collected data, the paper derives some main conclusions. First of, people using the public transportations system, and especially the subway, consider speed and dependability as the most important performance objectives for the caretakers of the public transportation system, SL and MTR to master.

The simple view of reading is a theory in which reading is divided into decoding and linguistic comprehension. The theory has been used to explain and to subgroup reading disabilities. Research has also investigated if additional factors are of relevance to reading. In the present study, decoding was divided into the factors orthographic decoding and phonological decoding, while comprehension was divided into word comprehension and grammatical comprehension. The purpose was to analyze these factors and their contribution to reading ability in children in fourth grade: one group with reading difficulties (n=36) and one group with typical reading ability (n=36).

In today's agriculture efficiency and the capacity of tools and machinery are crucial. In this work we investigate whether it is possible to enhance the capacity of sowing by increasing the work speed of seeders, how seed technology affects seed placement, and if there is any difference between two different brands of seeders and their sow techniques. The seeders we have chosen to compare are Väderstad Rapid drill and Amazon Cirrus drill. The tillage capacity of the seeders and their traction power needs were examined as well.Väderstad Rapid and Amazon Cirrus were tested in a randomized block design with four replicates at three different speeds, 8 km/h, 12 km/h and 15 km/h. The seed placement at the different speeds was examined by dividing the seedbed into four different zones from its surface to its bottom.

Nature and culture are often described as opposites, but at the same time nature is often de-scribed as culture and past. This essay examines how nature and the past are culture. I study how 51 people make shifting distinctions between nature and the past in relation to culture, the present and the future. By using the concept of Orientation of Sarah Ahmed I analyze how the informants direct themselves against nature, past and culture through a questionnaire, ob-servations and walk-alongs. I discuss how their ideas about nature and the past differ with their different starting points and are shaped through their physical meetings with them.

Nature and culture are often described as opposites, but at the same time nature is often de-scribed as culture and past. This essay examines how nature and the past are culture. I study how 51 people make shifting distinctions between nature and the past in relation to culture, the present and the future. By using the concept of Orientation of Sarah Ahmed I analyze how the informants direct themselves against nature, past and culture through a questionnaire, ob-servations and walk-alongs. I discuss how their ideas about nature and the past differ with their different starting points and are shaped through their physical meetings with them.

Performance of an intersection affects the total travel time in a traffic network. An intersection with good performance can easily be described by its contribution to lower travel time than in a comparable intersection. The travel time is of importance in the cost calculations when a specific intersection is to be chosen and designed. It is important to be able to make correct and precise performance calculations so that the cost calculations will not be incorrect. For that purpose the software Capcal, which is a traffic model for intersection analysis on performance, is used in Sweden.

The aim of the present study was to estimate the correlation between Euro NCAP pedestrian rating scores and injury outcome in real-life car to pedestrian crashes, with special focus on long-term disability. The study also surveyed most frequently injured body regions and risk differences for specific elements of pedestrians hit by cars. Another aim was to determine whether Brake Assist systems affect the injury outcome in real-life car to pedestrian crashes and to estimate the effect in injury reduction of a high Euro NCAP ranking score combined with Brake Assist.In the current study, the Euro NCAP pedestrian scoring was compared with the real-life outcome in pedestrian crashes that occurred in Sweden 2003-2010. The real-life crash data was obtained from the data acquisition system STRADA, which combines police records and hospital admission data. The medical data consisted of International Statistical Classification of Diseases and Related Health Problems (ICD) diagnoses and Abbreviated Injury Scale (AIS) scoring.

This thesis assignment at C-level is focused on calculation models and prediction methodswhish can be used in the stage we call ?prospecting? of possible windmill locations. Thelocation is southeast of Halmstad at the Farm ?Stjernarpsgods?. The rapport has two mainareas directed towards this task.

In 1996 a hunting test for British gun dogs was started in Sweden, based on a similar one al-ready in place in Norway. The aim of the new test was to describe the hunting ability of the dog and to use the results as a basis for selection. However, up to now, no genetic study of these data has been done. Therefore the aim of this study was to estimate genetic parameters for the traits measured in the hunting test and to investigate whether the traits can summarized into fewer overall measures. Data from trails of British gundogs between 1996 and 2005 in Sweden were used to estimate genetic parameters and environmental effects in hunting performance. British gundogs consist of five different breeds: Pointer, English setter (ES), Gordon setter (GS), Irish red setter (Irl S) and Irish red and white setter.

AbstractSAAB has for a long time used user controlled pilot models in ARES. ARES is a simulation tool used in the desktop environment for simulations and calculations of the JAS 39 Gripen fighter and other aircraft. ARES stands for ?Aircraft Rigid body Engineering Simulation?. To work with these pilot models has been both time-consuming and inefficient.

This report deals with the modeling of a part of the communication system based on the IEEE 802.11a standard which represents the next generation of wireless LAN with greater scalability, better interference immunity and significantly higher speed, up to 54 Mbps. 802.11a uses Orthogonal Frequency Division Multiplexing (OFDM) where modulation is performed by an IFFT and the demodulation by an FFT. After modeling the FFT in Matlab and C, the FFT implementation has been validated using a soft microprocessor core by Xilinx (Microblaze) and the results were compared..