This paper describes a factor analysis applied at the data of the European Union structural indicators. These are the official indicators for wealth and economic development in the European Union with main use to evaluate the outcomes of the year 2000 Lisbon goals for making the European Union the world?s strongest economy by 2010. The purpose of the data is to serve for comparing and ?learning by doing?-policies, but have, due to size and format, so far been hard to use for a good compare between member countries.

 Avregleringen av Sveriges järnväg ledde till att Statens Järnvägar delades upp i olika företag, SJ AB bildades som har i uppgift att bedriva lönsam persontrafik. Avregleringen har haft en stor påverkan på hur SJ bedriver sin verksamhet idag samt lett till att komplicerade ägarförhållanden har uppstått i Hagalund. Hagalund är SJ?s största depåanläggning för underhåll av fordon.I samråd med SJ?s Division Fordon och Divisionen för Planering och Trafikledning har vi fått i uppdrag att undersöka hur SJ påverkas om de införskaffar en depå i egen regi. Vi har valt att undersöka SJ ur ett värdekedjeperspektiv.

During the 19-century a global warming has been observed, which includes increases in global air and ocean temperatures, widespread melting of ice and snow, and rising global sea level. There is a clear connection between emissions of greenhouse gases caused by the human and the increase in temperature. Climatic changes caused by global warming can be stopped trough decreased emission of fossil fuels, for example by an increased use of biogas. Biogas is a renewable energy source which is produced through anaerobic (oxygen free) digestion of organic material. The gas is a mixture of methane (CH4) and carbon dioxide (CO2) and can be among others used as fuel in vehicles.

The aim of the present study was to investigate the effect on growth of foals on two different diets, either a forage-based diet or a diet containing approx. 40 % concentrate. The report also includes a review of the pertinent literature on the effects of diet on mares? milk and growth of horses. The hypothesis of the study was that a forage based diet will result in a similar growth pattern as a diet including more concentrates if the diets contain the same amount of energy, crude protein, lysine, calcium and phosphorous.

Drain water heat recovery is an uncommon measure in multi-unit residential buildings. There istechnology available for the purpose but the knowing and experience of the heat recovery systems islittle. The purpose of this thesis is to evaluate the future potential of drain water heat recovery inmulti-unit residential buildings.A major part of the multi-unit residential buildings in Sweden were built during modernismen andrekordåren (1940?1975). Many of the buildings have worn out drain and water supply systems andmany are in need of a general refurbishment.

This thesis examines how to improve the exhibition of products within retail for clothes and gift articles. The purpose is to investigate and test how light sources and different directions of light affect how the products are perceived regarding their exhibition. Our question formulations are:To what degree does the level of light in combination with the background of the interior design of a shop affect whether a product is perceived more or less attractive?What can we recommend to make the exhibition of products more attractive? From our observations shops nowadays have relatively high levels of light when they expose products on vertical areas. We have looked on the recommendation from ?Energimyndigheten? in order to see what they think is important when designing retail lightening.

The aim with this thesis is to make a comparison between forcing tulips in a hydroponic system and the forcing off tulips that have been planted in soil. The results are mostly based on interviews with six Dutch and one Swedish tulip forcer and the managing director at the Horticultural Research Centre, Proeftuin Zwaagdijke, in the Netherlands. There are benefits and disadvantages with both methods. Tulip bulbs planted in soil seem to get a brighter colour after forcing, compared with those forced ?in water?.

All new households were to be constructed with "near zero energy house standards" (NZE-house) by the year of 2020. The ambition to construct energy-efficient buildings had to increase rapidly in the spring of 2013.The purpose of this report was to increase the interest for building contractors to construct apartment buildings with passive house standards. By locating and evaluating experiences from an existing passive house a case study including interviews, field visits and document analysis was made. Research of literature regarding other passive houses in Sweden also helped to answer the following questions:- What positive and negative experiences have the study of the passive house meant to the involved stakeholders and residents?- What improvements can be made based on identified experiences?- How can an apartment building be designed as a passive house based on possible improvements?By collecting good and bad experiences, as well as improvements and potential design proposals, a diagram was created designed as a tool for developers when constructing apartment buildings with passive house standards.

In the last few years people have become more and more aware of how humanity is affecting the climate. In the direction of reducing the greenhouse gases is to design engines with higher tensile properties and reduced weight, in order to achieve lower fuel consumption and cleaner fuel incineration in today's truck engines.In order to achieve these requirements it?s necessary to increase the combustion pressure in the engine. This requires higher tensile properties and high thermal conductivity of the engine material. The department of Component Technology at the University of Jönköping in collaboration with Volvo Powertrain AB, Scania CV AB and DAROS Piston Rings AB has been commissioned to develop this material and to find knowledge of material properties used in truck engines and piston rings used for marine applications.The purpose with this work is to analyze the tensile properties of a series of cast iron, cast under different metallurgical conditions.Four different series of cast irons have been analyzed from four points of view, carbon concentration, nodularity, amount inoculation and cooling rate.After the tensile test all specimen data was analyzed in a mathematic calculation program called Matlab 2006a.

This report is the result of a master thesis at the Department of Mechanical Engineering, Division of Industrial and Economical Development, at Linköping University of Technology. The project was carried out on behalf of Fanerami AB, Mjölby and includes 20 weeks of full time schedule work.Cabinets with vertical mounted roller shutters all share the same problem, namely weight balancing. A roller shutter has an equilibrium area where the sum of the different forces acting on the shutter equals zero. As the shutter leaves that area it will pick up speed as it falls towards the bottom. When the shutter hits the bottom of the cabinet there is a potential risk of getting fingers caught and in this project a solution to prevent this from happening was to be presented.In this project, three concepts have been generated with the following different purposes:?In concept 1 the risk of getting any fingers caught when the shutter closes was to be eliminated in an efficient and inexpensive way.?In concept 2 the roller shutter had to be balanced at all time providing the possibility to keep the cabinet open in any position.?The last and most challenging task was to create a remote controlled TV cabinet.

Until 2020, 49% of Sweden's use of energy must derive from renewable sources. Greenhouse gases must as well decline with 40% compared to 1990 as a part of Sweden's 16 environmental objectives. Biogas is part of the effort to achieve these objectives, but as the demand for biogas increases, more substrates are needed to meet the demand. The purpose is to investigate the conditions for pea residue as substrate by performing lab-scale mesophilic digestion with different fractions and notch lengths and then to summarize pea residue as a substrate for biogas production. During anaerobic digestion, 1000 ml bottles were used as reactors for digestion.

The Swedish road transport sector relies almost completely on fossil fuels. In 2007, as much as 96 percent of the total sales of fuels was made up of petrol and diesel, while at the same time the share of total emissions of greenhouse gases in Sweden that came from road transports amounted to close to 30 per cent. Sweden is by no means worse off than any other European country in these respects. In order to address the questions of high oil dependence and CO2 emissions the European Commission has proposed a reinforcement of the legislative framework, with a 10 percent minimum for the market share of biofuels in 2020. Furthermore, the proposed target is binding for the member states, unlike the current voluntary target of 5.75 percent by 2010. More than doubling the usage of biofuels in only a bit more than a decade will most likely not be possible without policy interventions.

This paper is based on a literature review and interviews made with managers in small-scale nurseries for pot plant production. The review helped to identify the worst occupational hazards in pot plant production. The interviews provided a way to investigate how the nurseries act so as to avoid the worst hazards and what they do to even out work intensive periods during the season in order to get a more even distribution of work over the year. According to available statistics problems with back and shoulders are the most common of the physical disorders and the risk for occupational accidents are high for greenhouse workers. Most of the occupational injuries are connected to musculoskeletal problems. The handling of material is often manual and involves frequent lifting and carrying of heavy loads, the strenuous work postures and static muscular tensions these repetitive tasks are associated with causes straining and overloading.

Syftet med detta examensarbete har främst varit att förbättra inomhusklimatet i byggnaden Greenhouse, tillhörande företaget IVT Värmepumpar i Tranås. De anställda upplever problem med värme i byggnadens utbildningslokaler främst under sommarhalvåret. Tid har även lagts på att ta fram åtgärder som sänker byggnadens energianvändning i form av el och värme.Då examensarbetet utfördes under hösten användes ett simuleringsprogram för att få en bild av inomhusklimatet under sommarhalvåret. En modell av byggnaden byggdes upp i simulationsprogrammet, komplett med ventilations- och värmesystem.För att validera modellen som konstruerats utfördes flertalet mätningar under en veckas tid. Simuleringsmodellen kalibrerades sedan mot dessa mätningar för att efterlikna de verkliga förhållandena i så stor mån som möjligt.

The competitive nature of the automotive industry has always implied a necessity to improve product development concerning time-to-market, cost and product quality. As capacity of computer-aided engineering (CAE) tools has evolved, so has the strive for simulation-driven design. Virtual durability testing using full vehicle models is one of many challenges posed in front of vehicle manufacturers when computer simulations are given a key role in product development.This thesis has been initiated as a preliminary step towards implementing dynamic virtual durability testing in the development of buses and coaches at Scania. The objective has been to assess the predictability of a full vehicle coach model and to what level of precision structural loads can be predicted. Previously performed proving ground testing of a Scania Touring coach has been the basis for the modelling and simulations in this thesis.A virtual model of the Scania Touring coach has been created in multi-body simulation software package MSC.Adams.