Introduction:A good work environment and good resources among district nurses? and general nurses? are important in the provision of good nursing care. For patient security it is also very important that resources and time are used in an appropriate way. A lot of time is spent on non-core activity, for example administration takes more and more time, which can result in feelings of stress.Aim:The aim was to describe how district nurses? and nurses? in primary care perceived their work environment, how their worktime content was distributed and if there was some connection between perceived work environment and the distribution of work time.Methods:A mapping of the content of the work was made in two parts.

Due to increasing regulations regarding new diesel vehicles particulate matteremissions the new Scania truck, Scania Euro 6, has been equipped with a particulatefilter. This component effectively stores the particles in the exhaust gas but must becleaned in order to prevent itself from clogging. The filter is cleaned through aprocess named regeneration which is a thermodynamic process in which thetemperature of the filter is raised through fuel supplied to the exhaust gas.The purpose of this thesis is to contribute to the development of improved controlstrategies of the temperature during the regeneration process through thedevelopment of model-based controllers. These controllers are designed in order tohave good performance in stationary as well as automatic regeneration.In order to develop these model-based controllers a model of the system isconstructed. The model is described as a linear thermodynamic grey-box model withflow varying parameters, showing good results in validation.The model provides a simulation environment during the controller design, which isfocused around the development of linear regulators with the exhaust gas mass flowas a scheduling variable whose size determines controllers? mode of operation.

In this thesis, the Train Power System Simulator (TPSS) has been compared and verified with the commercial simulator TracFeed® Simulation (TracFeed). The basis for the comparison was a given part of the Swedish railway system, with steel transportation trains. Primarily, emphasis was placed on running time and energy consumption in simulation results. Two transformer systems were analyzed, booster and auto transformers. The high voltage transmission line, parallel to the railroad track, was disconnected in some simulations.

This Master?s Thesis aims to investigate and assess the methods used to decrease the discharge ofmetals, primarily copper, from the water purification plant at Assa Industries plating factory inEskilstuna.Literature studies of the purification methods precipitation, ion exchange, evaporation, reverseosmosis and electrolysis has been done to appraise the adequacy of the technique. Thesetechniques are commonly used for purification of industrial waste water.Assa has four plating lines: the Trumline, the big Zinkline, the new Zinkline and the Decorativeline. The new Zinkline is the most modern of the four lines and purification is done byrecirculation over an ion exchange unit. The demand for fresh water is thereby heavily reduced.The Trumline, the big Zinkline and the Decorative line all use older techniques.

This report is part of the major thesis carried out at Stoneridge Electronics in Bromma,Stockholm during autumn and winter 2005-2006. The background to the thesis is the trendwithin the automotive industry where color displays have become more common for presentationof information to the driver, a trend that has come to the commercial vehicle market. Thepurpose of the thesis has been to evaluate whether programmable logic, with respect to FPGAtechnology, could be suitable for display control and graphics generation of these more complexcolor displays in automotive environment.Within the scope of the thesis the FPGA technology has been investigated, i.e. whatopportunities and threats there are with aspect to environmental and security requirements. Inaddition, the market of FPGAs and pre-built IP-cores has been investigated.

Background: Practical blood flow restriction (pBFR) combined with resistance training has been proven to facilitate muscle strength despite training at low intensity. However, research investigating the effects of long-term pBFR-training and its periodization with strength training (ST) at a higher intensity is lacking, as well as the effects of occlusion training on blood lactate levels (BLL) over time.Purpose: To compare the effects of 2 weeks of pBFR training followed by 2 weeks of ST (BFR-ST) with 2 weeks of ST followed by 2 weeks of pBFR training (ST-BFR) on anaerobic performace and BLL.Method: 5 adults (age 23 ± 2 years) with a minimum of 1 year of ST experience were recruited and randomized into BFR-ST (n=2) or ST-BFR (n=3). Anaerobic performance was measured using a 30-s Wingate-test and BLL samples were collected <1 and 5 minutes post-Wingate. Data and samples were collected before the intervention and after the 2 protocols.Results: No differences were seen between groups in anaerobic output or BLL after 4 weeks of training (p>0,1 for all values). A decrease in time to peak power (tPP) were seen in both groups with an advantage for BFR-ST (-37 ± 8 %) over ST-BFR (-27 ± 22 %).

The company is currently in a stage of improvement and has therefore taken the help of students at School of Engineering, Jonkoping University. The current production is batch, production layout is fixed. A bottleneck is created after the first station which leads to large efficiency loss.  The meaning of this report was to provide a layout suggestion with balanced workstations to a new production line. The conditions were that the production line would be one-way, driven by customers order and meet a demand of 40 products per week.

This bachelor essay is divided into two parts, the first being a construction of a single-familyhouse and the second an in-depth study of five different isolation materials, analysed from anenergy perspective.The first part, the construction of the single-family house, has been created from knowledgeacquired during three years of studying at KTH Royal institute of Technology in Stockholm, inthe program Architecture and the Built Environment. The constructed house is a one-floorhouse of 137m2with façade plaster, situated in Borlänge, Sweden. The house has a wooden framewhich is built on a on sight cast concrete foundation, on the ground. The house?s roof is a gableroof, which has an angle of 24 degrees.

Rapid population growth and the fact that phosphorous is a limited resource implies that the question regarding an efficient use of phosphorus is of great importance, and consequently,that the phosphorous use efficiency should be as high as possible. The view on phosphorous use efficiency, and how this is calculated, has varied over time. This has had great implications on what type of research that has been conducted, which have resulted in an inconsistency between the academic?s view on the subject and recommendations received by farmers. The purpose of this paper is to calculate the phosphorus use efficiency in the Swedish long term fertility experiments.

Millions of preselected progeny have been born since the development of The Beltsville Sperm Sexing Technology 1986. The method is based on flow cytometry and sorting is done on the basis of DNA difference of the X- and Y-chromosomes. Preselection of progeny provides an opportunity to obtain genetic gain and increased production as well as increased animal welfare and decreased environmental impact. However, the method is associated with low fertility, high costs and uncertainty whether the sorting process contributes to DNA damage and thereby results in genetically impaired progeny. Today, sex sorted sperm is only commercially available in the bovine industry, due to the fact that bull sperm is more suitable for selection than sperm from other species.

Starch is a naturally occurring substance in most plants and is used as energy storage. It is a component that mainly consists of amylose and amylopectin. Together they build a complex pattern which gives starch its specific properties. The proportion of amylose and amylopectin varies in different plants but generally starch consists of 25 % amylose and 75 % amylopectin. There have been discoveries of barley varieties containing 100 % amylopectin called ?waxy starches? or ?waxy barley? as well as varieties that have a high content of amylose, around 70 % and these are called ?amylotypes?.

Shock absorber units play a key role in establishing the driving dynamics and performance of automobiles. Öhlins Racing has manufactured high-tech automotive shock absorbers for over 30 years. Öhlins Racing?s advanced technology has contributed to over 200 world championships in automobile racing. Öhlin?s manufacturing process has long utilized automated fluid filling equipment during the final shock absorber unit assembly stage. The filling process consists of vacuum pumping the shock absorber unit and subsequent transfer of fluid. Vacuum pumping is necessary to remove residual air from the shock absorber unit prior to initiating the liquid filling stage. The presence of undesirable gases drastically compromises the performance of a shock absorber. The filling degree, defined as the final ratio of air to oil, is determined by the specific filling protocol as well as the specific equipment utilized.The current investigation aims to develop a viable technique to accurately determine residual air content in shock absorber units. If the filling degree can be appropriately quantified for a specific manufacturing process, then the air/oil ratio may be quantitatively related to shock absorber performance. The utilized measurement method must be completely integrated into the manufacturing process to guarantee shock absorber performance specifications according to the manufacturer?s standards. By utilizing the measurement method developed in this work, the manufacturing process, manufacturing equipment and product specifications can all be tailored to provide improved filling conditions.The developed measurement method provides accurate quantification of the filling degree under a wide range of processing conditions. The method establishes the relative quantity of air in the shock absorber unit by performing in-situ compressibility tests. The fill ratio can be controlled and varied by manipulating the vacuum pressure exerted during the filling process. Performance tests, however, indicate no correlation between filling degree and unit performance..

The purpose of this Masters thesis is to examine literature on current media events. We see a close relationship between this literature and the media society where we relate Manuel Castells theory of the network society. In this thesis we have chosen books which give different views on three major media events in Sweden: 1 the assassination of Anna Lindh, the former Swedish Minister for foreign Affairs; 2 the Knutby murder and; 3 the Tsunami disaster in Southeast Asia. These books combine fact and fiction in their writing which in media science is called faction. This form of writing has similarities to genres like new journalism and documentarism and can be problematic for the reader in terms of genre expectations because of the mix of fact and fiction.

This is a study, the purpose of which is to investigate how the construction company Sefab Bygg AB is able to increase its profitability and render a more efficient production process through logistic solutions. The study is made during one of Sefab´s present projects. The project includes sanitary renovation of 650 apartments in the co-operative Opalen in Norrköping.To find out whether changes of logistic routines are profitable or not, it?s necessary to evaluate the total cost of the changes. A total cost analysis is a mapping of all the costs for a particular material, on one hand for the present situation and on the other after the change.

This paper concerns the freedom of speech in our democracy and the principles underlying the restrictions. The study is aimed at using a descriptive theory to provide a useful basis for analyzing a justification of the role behind freedom of speech and its limitations. The analysis is made on the basis of the Swedish parliament debate in the form of motions and the non-governmental organization Swedish Helsinki Committee's report. The study has a focus on the law of hate speech and will be done with an idea centred analysis. On the basis of democratic theory, the central role of freedom of speech was clarified on the basis of a clear need for a reliable communication.