As a result of an increased consumption, waste volumes has grown steadily throughout the 1900s, and this puts great demands on an efficient and ecological sustainable waste management on both local and national level. In order to evaluate collection and disposal of household waste, a large number of Sweden´s municipalities are using waste analyses. The overall aim of this study has been to summarize and assess results from waste analyses executed in Härjedalen´s municipality during the years 2007-2011.The evaluation has given information about the household waste´s composition, quantity and change in time. The report´s objective has been to create a basis which the municipality can use in planning of future information efforts and other measures, and give some proposals on how these can be designed and targeted. Therefore, the report also highlights research on motivations factors that affects environmentally conscious behavior such as recycling, and how different instruments like information can be used to promote this.

Each year, the coffee machines at Ericsson in Kista produce around 100 tons of ground coffee waste.The companies Coor Service Management, Löfbergs Lila and Selecta are all responsible for differentstages in the logistical chain in delivering coffee and, together with Ericsson, they want to increasetheir environmental benefit. The plan is to produce biogas through anaerobic digestion instead ofincinerating the coffee waste in a heating plant. The results are to be presented as different businesscases in which different biogas plants are compared with the reference case (heating plant),comparing costs and environmental impacts.There are two major environmental benefits from producing biogas; reduced carbon dioxideemissions from when fossile fule is replaced by carbon neutral biogas, and reduced emissions fromreturning digestate from the bio reactor to farmland instead of using industrial fertelizer.In order to determine the biogas potential in coffee waste, a couple of properties had to bedetermined in a laboratory. Properties such as the dry substance content, heating value, moisturecontent and ash content. The results show that 100 tons coffee waste could produce around 16 500Nm3 biogas which would contain 163 MWh.The biogas reactor and upgrade plant both need energy gas to function and uses around 14 MWh ofthe produced gas.

This thesis concerns waste management on construction sites and was conducted on behalf of ICA Fastigheter.Areas of concern:How can an environmentally-efficient waste management system on construction sites be defined? What potential exists for exploiting the waste resources that are generated?How can the waste management be optimised by reducing the quantity of waste and by optimal sorting?How can the client of a project influence the waste management?The purpose of the work was to investigate sustainable waste management in the building and construction sector and to highlight waste as a resource from an environmental and economic perspective.The aim of the work was to define an environmentally-efficient waste management system, to analyse the potential that exists in waste management and to draw up guidelines for optimal waste management.The method consisted of a literature study, two visits to construction sites and four interviews.An environmentally-efficient waste management system means that the waste is managed in the following order of priority:Prevention     Reuse  Recycling     Energy recoveryLandfill     The prevention of waste is an important area that has not been adequately explored by the building and construction industry. The quantities of waste could decrease with the implementation of measures such as ordering materials in the dimensions required, prefabricated components, logistics centres with Just-In-Time deliveries, less and improved packaging and less wrapping. The reuse of waste materials and temporary apparatus as well as the use of a return pallet system are examples of reuse that reduces the quantities of waste.In most cases the source sorting work is a matter of course and the proportion going to landfill is down at a low level. The source sorting can be optimised by sorting all materials that can be reused and recycled to use them as a resource.

The waste fractions offered to households in Sweden differ depending on where you live. The responsibility for the waste are grounded by the Swedish law where the municipality are responsible for the collection of household waste and FTI are responsible for collecting all packages and papers that the households sorts out. A new waste regulation is under consideration where the responsibility for the household waste may change. The bulky waste from households is collected at recycling centers where the households leave it in different containers for different fractions. These recycling centers are formed different and the fractions offered in them also differ depending on in what municipality they are located.

The purpose of this report was to identify the current waste management of non-hazardous construction and demolition waste in a few Swedish construction companies, based on the different steps in the waste hierarchy with a focus on waste prevention, reuse and recycle. Additionally, the purpose was to attempt identifying opportunities, obstacles and as well as to propose possible solutions from an environmental perspective. The method used was a qualitative study using interviews conducted through emails and phone with employees occupying positions that could answer this reports questions. The results of this report indicates that waste management of construction and demolition waste has improved, and less waste goes into landfills. The concern is that the overall amount of waste being produced is not decreasing, thus calling for actions preventing the production of waste.

Högbytorp is Ragn-Sells? largest waste facility and it is located north of Stockholm. There is an old landfill still in use, but at the end of this year it will be closed. The waste deposited on the landfill can, through decomposition, give rise to a large amount of methane gas, which is an energy rich gas that can be used for heat and electricity production. To receive a relatively large amount of gas, the decomposition requires a high moisture content in the waste.

Vattenfall Heat Uppsala runs the waste incineration plant in Uppsala, which produces district heating, process steam, district cooling and electricity. Vattenfall Heat Uppsala has decided to introduce an energy management system with the aim to increase the energy efficiency of the plant. The basis in such a system is to make an energy mapping.In this thesis an energy mapping has been performed at the waste incineration plant with the aim to identify and determine the size of energy flows. The investigated energy flows are used fuel, produced and used steam, produced district heating and cooling. Also the use of electricity to run the processes has been investigated.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

This report describes the building of a computer model that makes it possible to simulate the thermal climate in a greenhouse. The computer model is built on the physical theory of heat exchange that occur in a greenhouse, such as radiation and convective heat exchange. The model also includes the heat storage that is active in a greenhouse.The computer model is used to simulate the thermal climate in a greenhouse under three periods, winter, spring and summer. It also investigates which effect a concrete wall has on the thermal climate in a greenhouse. The purpose of putting a concrete wall in the greenhouse model is to investigate the possibility to store heat during the day and then use this heat when the temperature drops during the night.The result from the simulations shows that a concrete wall levels the big difference in temperature that normally occurs under a day in a greenhouse.

The purpose of this report is to find a model of statistics for construction and demolition waste, which makes it useful for the local manager at the building site. The intention with the model is that it will be used as a support of the local manager, to direct his project towards reduced strain of the environment. The model will also be used to make it easier to control that the claims from authority and aims for the environment are achieved. To familiarise with the subject waste handling within the building and construction sectorI have done a literature search. I have also been studying rules and regulations regarding the waste handling.

Modern technology and fast development of heat pumps, the hunt for savings in energy consumption and the strive for environmentally friendly energy sources, convenience, and financial profit, have made heat pumps a reasonable alternative for the heating of houses.When the heat pump starts it will consume a considerable amount of current, which may result in a short-lived voltage-drop if the power grid is weak compared to the start-up current.The company Fortum Distribution which owns and administrates electrical network is interested in an investigation that deals with heat pumps affect on the quality of electricity.The purpose of this investigation is to study fast electrical fluctuations (flicker) as a result of start-up currents for single as well as multiple heat pumps on the same electrical station and from this evaluate whether there will be any problems installing heat pumps..

This study has examined if importation of waste for energy recovery can reduce the climate impacts of Waste Management Systems. Using Systems Analysis this study will try to examine the complex waste systems in a systematical and strictly logical way to see how these systems interact and affect each other. Specifically examining the climate impact of waste management systems in England. The traditional way of handling waste in England is through Landfills. Land filling leads to emissions of the greenhouse gas Methane. The EU has put in place a landfill directive that is supposed to lead the member states away from land filling as a method of waste management. Today in Sweden there is a competition for the waste available for incineration. The worsening economical situation together with less product packaging and an increase in source separation leads to a lack of waste available for incineration.

This rapport is result of a project. The purpose of which was to design a circuit that is used in a heat glove. The heat glove is the technical aid which provides heat inside a glove.It is specially suited for old people who have problems with cold hands because of decreased blood circulation.There already was an old circuit in the glove that gives a constant current which develops heat from battery to glove through a circuit. The temperature is between 32 and 34 degrees.The problem with the existing circuit was to regulate the temperature. There is only on/off switch and there is no way to adjust desirable value of the temperature.In order to solve the problem the old circuit was investigated.

The purpose of this study is to compare the energy related and environmental consequences of implementing optical sorting as a means of waste collection with those of reducing food waste. In addition to studying the possibility of implementing optical sorting in downtown Stockholm, the yielded amounts of energy from waste collection and reduced wastage will be calculated. This is done by way of literature reviews and interviews. The amount of energy that can be generated through optical sorting and biogas production via anaerobic digestion in downtown Stockholm is 29-44 TJ/year, compared to 118 TJ/year saved by completely eliminating food waste. The generated biogas can replace fossil fuels, but the required food waste contributes to increased greenhouse gas emissions as well as reduced bio diversity and eutrophication during the wasted food?s lifecycle.