The concept of sustainable development is a challenge that demands cooperation from all levels of society for it to be successful. The focus for this thesis is how politicians within the local councils understand the concept of sustainable development and how they implement it in political decision-making.The basis for the study is a questionnaire that was distributed to 303 local politicians in three municipalities of varying size in Southern Sweden. The study concentrates on departments within the local councils that are directly connected to the Swedish environmental law and the Swedish planning and construction law. One of the primary goals with the aforementioned laws is the achievement of sustainable development within one generation.The outcome of the study was that over half of the local politicians could correctly define sustainable development according to the World Commission on Environment and Development?s (WCED) definition.

Glulam is a product that was engineered to make use of timber in a more efficient way. Bychoosing timber of similar quality and discarding natural defects during production, thedevelopment of a stronger cross-section is achieved.Carbon fiber is a relatively new material with a high tension capacity. This feature is used toexamine how the bending capacity of the beams improve by adhering carbon fiber laminateson the lower edge of the beamsThe strength of the material is tested with three experiments: carbon fiber on the bottom of thebeam (a), carbon fiber attached to the lower sides of the beam (b) and carbon fiber in thebeam, covered with a layer of wood (c)The results show that the first case, where the carbon fiber is attached to the bottom of thebeam, gave the best result with an increase in capacity of 59 % compared to the nonreinforcedcontrol. The other two cases also show an improvement in capacity, beam-type 3had a capacity increase of 47% and beam-type 4 increased with 25 %Tests were also made with glulam beams reinforced with fiberglass, but these tests were notanalyzed in depth because the purpose was to compare the capacity to carbon fiber. Thisbeam improved its capacity by 40.3%.The tests show that carbon fiber as a reinforcement material for glulam is a good choice whenthere is a requirement for stronger cross-sections in both new production and renovation ofold buildings.

One of the biggest changes which have affected businesses during the last ten years is the accelerating speed at which Internet technology and e-commerce has developed. If Internet earlier was used in the purpose to entertain it is now accepted as an essential business tool and companies are investing more of its resources in e-commerce activities. Everyone ?has to be on the net? today but that implies a challenge in matching e-solutions to the company?s business goals. It is necessary to have clear goals, carry out research and plan a strategy in order to operate an optimal e-commerce website for the company?s needs.The purpose with this dissertation was to see how well companies adjust to new demands in the rapidly changing e-environment.

According to the Employment Protection Act, the permanent employment is the main condition of employment in Sweden. Nevertheless, nowadays a large number of employers choose to apply other conditions of employment than the permanent employment in their businesses. The rapid technical development and the demands for shorter perspective investment in companies on the Swedish labour market have started the requirement for a more flexible workforce. On-call employment is one of the conditions of employment that is increasing the most. This condition of employment is adjusted by the parties on the labour market.

The aim of this Masters thesis is to examine ideas used to legitimate Swedish digital libraries, with a focus on the cultural heritage, their relation to cultural policy and an eventual crisis within the latter. Which ideas are linked to digitalisation? How do the arguments for creating digital libraries differ between central actors? How do the digital libraries relate to cultural policy and an eventual legitimacy crisis? These are the questions this thesis seeks to answer. The theoretical starting-point consists of a legitimacy discussion and its connection to Swedish cultural policy. The method used is idea analysis.

Svenskt Rockarkiv is an organization located in Hultsfred, Sweden. Its goal is to collect and document the history of Swedish rock music. The archive contains several types of documentation, such as audio recordings, photographs, posters, video recordings and books representing Swedish rock music history. In order to store information about the audio recordings in the archive, Svenskt Rockarkiv uses a SQL Server 2000 database and a client application written in Microsoft.NET C# and Windows Forms. The purpose of this degree project is to audit the database and windows client, since the organization has needs of new functionality.

The waste of material is a big expense for manufacture companies caused by lack of quality. The cost by lack of quality often totaled to a big percentage share of the turnover when all cost related to lack of quality is included. New manufacturing systems like Lean production or Just In Time demands better internal quality for the manufacturer. To make those manufacturing system with small and none buffer stock successful the quality improvement continuously have to be developed.Measuring of waste of material in Bubs Candy?s factory where not simple due to the products does not have a permanent weight during the manufacturing process.

Today`s society requires that municipalities focus must be more on effectivity and quality. Because of this it is important for municipalities to look after the controlling systems. Many municipalities choose to adopt models that reflect the efficacy. The municipality of Vellinge has chosen to implement balanced scorecard in all their efficacies. We found it interesting when it was exposed that 70 % of all implementations of balanced scorecard fails.

This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

ABSTRACTIntroduction: Violence towards employees in the psychiatric ward is increasing at an alarming rate. Reports concerning the effect on the staff?s psychological health are disturbing. These workforces are those most affected by brutality and for ages it has been looked upon as a part of the psychiatric line of work. This viciousness is threatening the safety for both the personnel and the patients.

Forest management plans have been sold to private forest owners by wood supplying companies for a long time. These plans are considered to be effi-cient tools to identify measures and wood volumes, and are simply a starting point for discussions between private forest owners and round wood pur-chasers. However, large variations are observed between different purchas-ers, in their usage of the plans. The purpose of this report is to identify to what extent a forest management plan can promote an increase in the amount of wood which a round wood purchaser can obtain and to find differences in the way of using the plans between different wood purchasers. Furthermore, the purpose is also to ana-lyse if varying owner structures can be underlie variations in the selling of forest management plans. Qualitative interviews with nine of Stora Enso?s round wood purchasers were performed.

As a result of global competition, companies within the automotive industry are required to improve their production systems to achieve sustainable and competitive production. To attain operational excellence, companies have adopted concepts like lean and World Class Manufacturing (WCM).In order to deliver, companies need to increase the availability and reliability of production equipment. This demands focus on both operational and strategic maintenance, and efficient equipment acquisition and management. The main objective of this thesis is to identify processes and success factors that are necessary for improved maintenance performance. By conducting a case study and by performing a literature review, the following has been studied: 1) how companies within the automotive industry work with maintenance and maintenance strategies, 2) implementation of maintenance strategies, and 3) new acquisition and spare parts management for maintenance. The results show that basic maintenance concepts and related terms are well defined in the literature.

Title: A study about conditions for leadership in knowledge-intensive firms.Authors: Cecilia Ekström and Niklas SandbergKeywords: Leadership, knowledge-intensive firm, hierarchies, followers.Background: Leadership is becoming one of our greatest social myths and is considered a total solution for many problems that occur in an organization. The view of leadership is usually from a top-down perspective, which contributes to an often underestimated view of the follower. Just as it is important to understand the leader's view of leadership, it is important to understand how employees view the structure from which the leader derives its legitimacy. The existing conditions in knowledge-intensive firms, such as autonomy, place special demands on the formal leadership.Purpose: The purpose of this study takes an employee perspective, to understand what the conditions are for formal leadership in knowledge-intensive firms.Method: A qualitative research method was used and empirical material was collected through interviews with employees in knowledge-intensive firms. The empirical material was analyzed by the respondents? mental images which were set against the theoretical framework of the thesis.Conclusions: The conditions for formal leadership in knowledge-intensive firms make it advantageous to have a leader with a withdrawn role.

The dairy cow?s ability to resume estrus after calving and to conceive is affected by their metabolic status after calving. For high yielding cows there is a high risk that the feed intake will not be sufficient to cope with the increased energy demands after calving, and the cow will end up in a state of negative energy balance. Energy balance can be measured in various ways, for example by body condition score or by plasma concentration of several metabolic hormones and metabolites. After calving, endocrine pathways stimulate tissue mobilization; insulin signaling is blocked, the concentration of insulin-like growth factor-1(IGF-1) and leptin decreases, and the concentration of growth hormone (GH) increases.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.