A one-cylinder research engine has been used for studies with a Diesel Dual Fuel concept (DDF). DDF is a concept that utilizes a pilot diesel injection to ignite a homogenous natural gas/air mixture. Emissions and engine efficiency have been analyzed in an emission cycle called European Stationary Cycle (ESC) and the knock/pre-ignition problems with this type of engine have been investigated.At low and mid torque levels, an early diesel injection around 60 crank angles degrees (CAD) before top dead center (TDC) was used. At these loads raw NOxemissions was below EURO 6 level (0.2 g/kWh). NOxwas at EURO 5 level over the complete ESC without after treatment and with SCR at high loads it should be possible to reach EURO 6.One issue with DDF is the high HC emission levels.

During the autumn 2009, a 15 hp degree project was accomplished. The objective of the study was to describe different equipment alternatives, suitable for fresh market apple harvest. A field study was conducted during the harvest period to evaluate the efficiency (kg / person/ hour), using the different equipment. Four different systems are described in the study; Pick-ing-bag, Picking-train, Pluk-O-Trak and the Conveyor Harvester. The information about the systems is based on interviews with growers together with previous studies.

In a time when concern for the environment is a topic that is met with both love and hatred, organic goods and services become increasingly common on the market. Communication efforts with the purpose of increasing the proportion of organic products consumed are being conducted by both private and public actors. However, achieving attitudinal and behavioral change within complex areas such as this comes with many difficulties.Within public opinion change, a common way of achieving a change in behavior is to use fear appeals and scare tactics. Earlier studies have shown that messages prompting a low level of fear can be more effective than messages prompting a high level of fear, since a high level of fear tends to raise defense mechanisms in the consumer. The purpose of this essay is to examine whether fear and defense mechanisms is a problem when it comes to making consumers choose organic products, as well as studying whether messages prompting low levels of fear are more effective than those prompting high levels of fear.This quantitative study is conducted in the form of a questionnaire-based experiment, comparing the effectiveness of two messages prompting different levels of fear.

Feedback tools support electricity users within the Swedish residential sector to increase their knowledge of electricity and the electricity market as well as to become more aware of their electricity consumption, which in turn encourages a reduction and an increased flexibility of electricity use. The primary aim of this study is to identify and analyse how existing feedback tools can be improved, to ensure that they contribute efficiently to the achievement of the EU objectives congruent with a more sustainable energy system in 2030, emphasizing: greenhouse gas reduction, increased energy efficiency and an increased share of renewable energy. In order to reach the primary aim of this study, existing feedback tools have been identified and mapped and interviews with feedback tools providers have been conducted. The study is limited to three research areas: the practical functions of feedback tools, available technology and the use of feedback tools.The use of more efficient feedback tools will provide an increased success rate for energy management, which includes both behavioural changes and energy efficiency. According to the results from the interviews conducted for this study, an increased use and user frequency is important to utilise the energy management potential.

The purpose of this thesis is to assist the Swedish energy company NIBE Energy Systems in their studies of adaptive regulation applicable to electrical water heaters. Due to coming energy classifications of these appliances in the European Union, NIBE Energy Systems needs to use adaptive regulation, called Smart Control, to keep their products in the best possible energy class and remain competitive to the market. By using this Smart Control regulation a 2-3 % improve-ment of efficiency can be credited the system. This is a small number, but heavily needed, since the energy classes are based on the idea that the European Union is provided with electricity from coal condensate power resulting in a 40 % maximum efficiency. Furthermore, doing noth-ing will result in some water heaters not being approved to use on the market from 2015 due to low efficiency.

Background and problem: The background to this study is the organizations increased difficulty to retain employees in the organization when more and more employees today choose to do their career in several organizations. The problem to keep the employees in the organization leads to several problems where the loss of experience reduces efficiency and increased risks and cost associated with recruitment are some problems that arise. The problem therefore faced for this study is: How can opportunities for career development within an organization created to get employees to stay over time?Purpose and method: The purpose for this study is to describe how organizations can create opportunities for the development of career that gets employees to stay within the same organization and make their career in this organization. The method used for this study is a qualitative approach where data is collected through semi-structured interviews in a case study.Empiricism: The empirical result have shown there are four factors that an organization should overhaul to create an opportunity for the development of a career that gets employees to stay in an organization over time.

Results have shown that flow batteries may be a solution in the future as an effective and environmental friendly method to an energy storage system (ESS). The technology is reliable and has a high efficiency that comes with low energy losses and a long lifetime. The range of possible fields is suitable for cutting energy peaks in the power grid, by always have a ready and available energy storage that balances the production. By comparing the advantages of flow batteries with conventional batteries it is mainly the fact that they can conserve energy for a long time without being self-discharged thanks to that the storage capacity is in principle endless and limited by the size of the electrolytes tanks that makes them a great energy storage system. The batteries won?t take any damage or decrease in performance when charging or discharging it or if you exhausts it to 100 % and leave it discharged for a long time.

ABSTRACTThe aim of the observation study was to examine the dental hygienists working tasks and the time they used carrying them out. Four dental hygienists where observed during four days each. The total time the dental hygienists used with patients during sixteen fulltime days come to a sum of 89 hours of the possible 111 hours. Twelve hours was late cancels and time when patients didn?t come to their appointment and ten hours were used for meetings.

Stormwater run-off from surfaces such as roads or rooftops is often polluted with heavy metals and nutrients. Many of these substances can cause great damage in biota if they end up in the recipient. In Sweden constructed wetlands and ponds for treatment of stormwater are frequently used, since research has shown that these treatment ponds are reducing stormwater pollution considerably to a low cost. The knowledge of these pollutant removal mechanisms and how follow-up and assessment of the ponds should be performed is still limited.To determine the pollutant removal efficiency of the stormwater ponds it is recommended that flow-weighted water samples are collected from both the inflow and the outflow of the pond. This method demands considerable resources of time and money for installations and analysis.

AbstractEmbla 5 is an office building which has done a large improvement. The clients of this building has made an order of WSP and the student Anders Kempe to calculate the use of energy for the building, and after that result proposing further measures which can decrease the energy use of Embla 5.The ground for this report is when calculation of the present energy use of the building is stated. To make that information of a number of parameters such as envelope, the heating system and ventilation has been located and set in to the simulation program IDA ICE which calculate the energy use.To improve the energy use further this project has been concentrated to change the system of ventilation. Today the ventilation system is of the kind CAV (constant air volume) and the air flow is dimensioned for after recommendations from BBR and Arbetsmiljöverket in the office spaces. Consider that Embla 5  is an office building where the people only staying for 8-10 hours/day so was the ide to see how much energy saving if the air flow is reduced the time people not being in the building.

In Sweden the residential and commercial sector is a major user of energy, why the Swedish government has set a specific goal to half the energy usage in buildings by 2050, compared to 1995. The Swedish Energy Agency has therefore started the campaign ?Halvera Mera? to encourage demonstration projects that will show how to renovate in an energy efficient way, and in doing so prove that it is possible to reduce a building?s energy usage by half and still make a profit. These projects are intended to serve as good examples and give inspiration to residential owners to perform energy efficient renovations. To make sure that these projects serve their purpose, it is important to know what will inspire and what will impede a residential owner to invest in energy efficiency improvements.

For a long time I have felt that there is a lack of time planning productson the market that attracts me to use them. Therefore I wantedto explore the possibilities of developing something that I reallywanted to use.At first I tried to come up with a more general tool for planningand structuring time, different from the products that are alreadyavailable. But soon I found it more interesting to see myself as theprimary user. This way I felt that I could experiment more and Ididn?t have to take things like production, cost and possible targetgroups into consideration.As I set out with an aim to try and understand my own problemswith planning and structuring time the project became a very personalone.

This study was made for the round wood transport company MT Transport AB. Time studies were made in order to analyze time consumption on the mill site for timber trucks delivering round wood at the Södra Cell Mörrum mill. The most interesting was to see how much of the time spent at the factory that was waiting time. In three weeks the study was going on and the drivers were clocking it themselves..

Partnering is a collaboration method where the contractor and the client work together, based on a mutual trust towards each other and with a common goal for the project. The method originates from the United States where it was early adapted by the U.S. Army Corps of Engineers. It later spread internationally where the United Kingdom and Denmark were early in Europe to see the potential with partnering, to help aid with the issues they were having where construction projects kept running late, going over budget and lacked in quality. By using partnering you can achieve a shorter building time, improved work relationships and enhanced efficiency and cost effectiveness.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.