This paper evaluates the prospects for utilizing aquaculture effluents as a nutrient source in organic hydroponic, as is the case in aquaponics. The development of organic hydroponics is dependent on replacing synthetic fertilizers with organically derived nutrients, such as those found in aquaculture effluents. Also, in hydroponic cultivation the establishment of a plant pathogen suppressive micro flora is part of the plant protection strategy. Therefore, both nutritional and microbial qualities of aquaculture water and organic hydroponic nutri-ent solution were analyzed and compared. Results showed both aquaculture water and or-ganic hydroponic solution to be deficient in a number of essential elements, although or-ganic hydroponic solution was closer to recommendations.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

A third party access to district heating networks has been proposed in Sweden, to increase the competition on the district heating market. Such third party access could create opportunities for the agricultural sector as an energy producer. This study describes the technical, economical and environmental prerequisites for a farmer cluster to build and run a heating plant, fueled with local wood fuel. The heating plant in the described scenario is 8 MW and will supply a village of 1000 houses, and is fueled with wood chips exclusively. Supplying a heating plant with fuel puts high demands on the logistics, since there need to be a continuous flow of fuel. In the scenario, wood residues from felling and thinning is stored in stacks in the forest, and a few times a year chipped and transported to a storage area at the heating plant. In the study, an estimation of the profitability has been made by estimating the cost of the investment, personnel, operating and maintenance costs and costs for the fuel and ash handling.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

This paper appeals to professionals working with green questions. It intends to create a discussion about which plant species that can be established in a fieldlayer of a naturelike planting on fertile agricultural land. To initiate the essay, a studie of which values that can be connected with an establishment of a fieldlayer was performed . A part of Tor Nitzelius Park in Alnarp, a so called naturlike planting on fertile agricultural land, was used as a model for the choice of species. With the aid of soil values, photos and a list of current species, interviews with four ecologists were performed.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

Phosphorus is the single most potent contributor to eutrophication of freshwater and has also been shown to contribute to the toxic algae blooms in the Baltic sea. The dynamics and paths of losses of phosphorus from arable lands are not fully understood. It is known that phosphorus can be lost directly from plant material to water. In studies where plant material has been subjected to several freeze-thaw cycles, large amounts of phosphorus have been lost. Most studies have been conducted under field conditions, with many factors effecting the measured losses of phosphorus, such as weather and type of soil. This study was performed in a controlled environment without the presence of soil. Instead of soil, small glass beads were mixed with the plant materials in vessels, to make possible homogeneous leaching with water through the mixture of glass beads and plant materials. In this study, clover, ryegrass and dry straw were cut to pieces, approximately 2 cm long.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

This thesis discusses the global regime complex concerning the management of plant genetic resources for food and agriculture, and how different regimes concerning these resources cooperate or stand in opposition to each other. Because of changes in US patent law and the establishment of TRIPS, patent claims over plant genetic resources has increased dramatically globally. This, amongst other things, in turn has lead to the development of CBD which in turn lead to the creation of access and benefit laws in many countries. To create a free flow of genetic resources for food and agriculture the ITPGRFA, with its multilateral system, were negotiated. The aim of this thesis is to investigate which consequences the regime complex concerning plant genetic resources for food and agriculture can have on the rights of small farmers, agricultural research and food security in the global South.

In two feeding experiments Bacillus induced priming of plant defense was tested for its effect against the generalist insect pest Spodoptera littoralis. The main hypothesis for the study was that Bacillus induced priming would enable the plant Arabidopsis thaliana to defend itself better against this insect herbivore since this priming seems to involve jasmonic acid, known to be important for plant defense to insects. A secondary objective of the study was to examine if any differences in a primed defense capability could be seen between different natural genetic variants (ecotypes) of A. thaliana reflecting habitat differences in pest pressure. The methods used for plant cultivation and Bacillus inoculation were aimed at reflecting conditions that can be expected in an agricultural cropping system. This meant that all plants were cultivated in soil, and the feeding experiments were conducted with the plants growing intact in the soil system.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.