The purpose of the project was to exam steams ability to sterilize carrots infected withLactobacillus plantarum. The project was a cowork with Brämhults Juice AB. They hadobserved an increase of Lactobacillus in the production of carrot juice during the summer. Tokeep the flavour of fresh fruits, the juice is treated carefully with heat. This means that thejuice only stays fresh for a few days, around two weeks for an unopened package and threedays for an opened package.In an attempt to remove the remaining Lactobacillus of the carrots, steam is tested as an extrastep in the production of juice.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

SAPA´s resource of waste heat is the basis for this thesis to investigate the possibility of energy assets in their cooling water and possible uses for it. The energy in the waste water is greater than the current need which has three uses which are (1) heating the factory, (2) converting liquid propane to propane gas and (3) local domestic heating. The average energy load that is available is 1, 7 MW and the average temperature in the cooling water is 41°C. The total energy load at dimensioning out side temperature is approximately 1,6 MW for the three current uses. The temperature is currently too low to be used directly in the existing systems so an upgrade is needed.

The study examines how efficiency and effectiveness are measured in charity organizations in Sweden. The rules of Svensk Insamlingskontroll, Årsredovisningslagen and Bokföringslagen make up the accounting framework upon which efficiency and effectiveness are measured in charity organizations. The study is based upon interviews with the sector's main actors: Svensk Insamlingskontroll, Frivilligorganisationernas insamlingsråd, auditors and the charity organizations themselves. The interviews are supplemented by studies of the guidelines issued by Svensk Insamlingskontroll. Today's measure of efficiency is the percentage of a charity organization's income that benefits their goals, called nyckeltalet.

Although Lean has received an increased amount of attention in the service context, research still has not established how successfully Lean manages to increase service productivity; since service productivity consists of both efficiency and quality. Research regarding productivity discusses the risk of a tradeoff between efficiency and quality in service production processes. Therefore, this thesis aims to explore if the tradeoff in a production setting with low variability in demand and low customer participation exists, after Lean has been implemented. With a qualitative approach, a case study has been conducted at Scandinavian Airlines Ground Handling to evaluate the effects of Lean in the baggage handling process. The result of the study shows that the tradeoff has not been overcome; efficiency has increased at the expense of quality.

During the year of 2008, a powerful earthquake hit the southern part of Iceland, which changed the geothermal conditions in the area around the city of Hveragerdi. Elevated soil temperatures in a nearby forest plantation have contributed to a unique opportunity for researchers to study how an increased soil temperature affects the boreal forest ecosystem, something that partly can be connected to the climate changes which are happening today. The boreal forest is representing a carbon sink and a buffert for the emissions that occurs. Changes in this ecosystem will for that reason contribute to major impact for the global carbon cycle. To study the impact of how elevated soil temperatures affects different processes in a plantation of Sitka spruce, studies were made on the photosynthesis of the trees and the respiration from the soil.

In a time when milk producing farm businesses face decline in profitability it is of great importance to examine how the situation can be improved. This thesis is a study off efficiency in milk producing farm businesses represented by Swedish, Dutch and German farms. The aim of this study is to investigate whether any differences exist between companies in these countries. Moreover, the study includes a mapping of a number of factors that determine how efficient milk production can be managed. This mapping is based on a literature review on prior efficiency studies followed by qualitative interviews with milk production advisors as well as a questionnaire sent out to dairy farmers in Sweden.

The report is about efficiency of a current production group where there is no clear production flow and there are some buffers between the operations. The efficiency is done with the help of a tool that is calledWork process of flow production which is used by Atlas Copco CTO. The most obviously results are that the lead time drops from 25 hours to 425 minutes and that the balancing loss decreases from 85 % to 8 %. The report focus on decreasing transports, decreasing buffers, more reliability in lead time and quality. And a more stimulating labour content for the workers is another result..

This thesis investigates how the level of implementation of New Public Management affects an organization?s efficiency. According to theory, a high level of implementation leads to a more efficient organization. This thesis is based on two case studies conducted on two units within Stockholms Stad. One of the units shows a high level of implementation of NPM and a high level of efficiency.

The increasing threat of climate change has led to a increased need for models to predict future climat. In these models the changes in the soil carbon pools due to changes in microbiel degradation of the organic matter can lead to both positive and negative feedback-effects. There is however a lack of consensues on the temperature respons on degradation soil organic matter. This paper aim to give a better understanding on the factors controlling the temperature respons. The factors studied were the carbon substrate qualitity and the physiological status of the microorganisms.

A district heating plant has the advantage that it can take advantage of the waste heat from industries and use of cheap fuels to produce heat. But for the long term is competitive requires that energy is also saved in district heating plants. One way to save energy in a district heating system is to increasing cooling to the return temperature. This leads to less power needed to drive the distribution pumps,  and that more energy could be extracted from the same amount of fuel by an improved flue gas condensation.In Karlskoga the return temperature into the district heating plant is high. They would therefore reduce the return temperature in order to extract more energy from the flue gases.

The control of indoor temperature must be able to handle large time constants and both measureable disturbances like outdoor temperature, and non-measurable disturbances, like waste heat from appliances. Due to cheaper microcontrollers (small computers with designated tasks) with better performance, more advanced and computation-demanding methods for control can be used.In this thesis, Generalized Predictive Control (GPC) has been implemented and tested on a theoretically derived model of a house. GPC states that a model of the system is estimated in every sample, and the control is carried out simultaneously, based on predictions of the model. Disturbances like solar radiation can be estimated and used in the control as well. The control signals are determined by quadratic programming, which makes it possible to consider conditions, for example limitations on the control signals.GPC requires a number of parameters to be defined, like model order and control signal penalty, but is relatively robust for variations in them.

The objective of this study is to determine if and how Swedish businesses measure the efficiency of their purchasing departments.In this study I have interviewed six medium to large successful companies and asked them· Which ratios they use to measure the efficiency of their purchasing departments· Why they use these ratios and· How the results of these measurements are usedI can conclude that although there are no ratios or other measurements that directly measure the efficiency of purchasing indirect measures do exist.The measures applied are usually the result of demands from management and the results are reported back to management and used to follow development within a particular field of purchasing. Benchmarking, especially external benchmarking, is unusual..

Climate on earth is getting warmer, which effects earth?s energy balance and so forth the ocean and atmospheric circulation.  In many sub-polar regions on the northern hemisphere changes due to warming of the climate can be observed. Some examples that already have been observed are shifts in tree line, towards higher altitudes and latitudes, increased ablation of Swedish glaciers and melting of the permafrost on the Siberian tundra. In Sweden climate change scenarios tell us that it will become warmer and that a higher amount of precipitation in form of rain will be an effect from this. To study climate changes in Sweden, transition zones are useful in order to observe changes in distribution of species and animal populations.

In this thesis a possible cost effective runner change of some of the units in the hydroelectric power station Olidan is investigated. The possibility to drive a unit at the same efficiency point through a change of the turbine shaft speed and the rate of discharge is tested. Furthermore the theories behind model testing, determination of efficiency increase from model to prototype and efficiency measurements shall be discussed and analyzed with Olidan as a starting point.A predicted curve has been built on information from model tests and field measurements on the existing runners and runner data from the test of the new model. The predicted curve shows the difference in efficiency between an existing runner and a modern one. It is the difference in efficiency that is used in the calculations that are to show whether changing to a pair of new runners will be cost effective or not.