The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

WSP building physics in Stockholm has certified the preschool Temmelburken in Bromma with the system of certification Miljöbyggnad. The rating of the building became BRONZE. In this thesis the preschool has been investigated with respect to the three areas: thermal climate, use of energy and improving of the level of certification. The thermal climate at the preschool has been investigated by a questionnaire survey and by measurements in order to do comparisons between the results from the two investigations as well as with the results of the simulations that WSP has done at the certification of the preschool. The differences between the results from the simulations and the questionnaire survey for winter as well as from the measurement performed with a comfort meter the 19th of March are concidered to be reasonably small since they give rise to the same rating according to Miljöbyggnad.   Operational data for the use of energy for the preschool have been obtained in order to do comparisons with simulations performed by WSP and Svenska Besiktningar AB. The comparison shows that the simulated values for the specific use of energy are lower than what the real specific use of energy would be for the preschool, since just the operational data for the heat energy is higher than the simulated values. At the investigation of the possibility of improving the level of certification it was found that the rating of the preschool can be raised from BRONZE to SILVER by improving the ratings of the ?thermal climate summer? and the ?daylight?.

Denna rapport tar upp problem med revisionskontroll i realtidsbaserade kollaborativa system. Enligt Fan & Sun (2012a); Fan & Sun (2012b) behöver man bryta kraven som definerar realtidsbaserade system för att uppnå detta.Den stubbaserade lösningen som beskrivs i rapporten lyckas minska antalet fel i testfallen som utförts i fallstudierna. Genom att implementera personliga editeringsflikar och stubbar är det möjligt att ha revisisionskontroll i ett realtidsbaserat system. Dock för att detta ska vara effektivt och användbart bör detta endast användas i specifika fall och med noggrann granskning.Fallstudien som genomförts visar inte på några imponerande siffror men en förbättring är fortfarande möjlig vid specifika fall..

In order to attract talented consultants, Sigma, a consultant company, wanted an online game for recruitment. In the game, potential employees? skills could be tested to determine whether they are qualified for the job. This paper presents a general technique for creating such a recruitment game. The report generalizes the recruitment game to a level-based game for the web, where a player should be able to progress from one level to the next by solving a given problem.

The objective of this work was to evaluate and implement a number of energy saving functions for a specific embedded system. The functions were then grouped into a number of energy levels with known properties in terms of functionality, energy consumption, and transition time between the levels.The embedded system consisted of an AT91 ARM9 processor, GSM/GPRS modem, display, Ethernet and other peripheral units. Some energy saving methods that were considered were suspend to RAM, suspend to disk, frequency scaling, and methods for saving energy in the modem, Ethernet, USB and display backlight. The functions were grouped into levels and an interface was specified for controlling the energy level.It proved possible to get known properties within the defined energy levels, even though the paritioning of functions into these levels proved to be sub-optimal in a typical application usage scenario because it was designed for mainly energy consumption, not usage.The final result is a number of energy saving functions grouped into levels, which are controllable via an application interface. Each of the levels have a known energy consumption in both loaded and un-loaded mode..

This essay focuses on the term usability while conducting a user centred system design. Usabilitymeans to what extent a user can use a product to achieve effectiveness, efficiency and satisfaction.Development using a user centered system design means that knowledge about the end-users andit?s opinions becomes a crucial part of the development process. The question of this essay is if usinguser centred system design will lead to good usability.We used methods from a user centered system design point of view while developing an applicationfor a Swedish bookstore company called Bokia AB. This included user and task analysis following by aclose relationship between the developers and end-users by using sketches and showing themprototypes of the system while collecting feedback.After concluding our case study we determined that using methods from user centered systemdesign could be used as a great tool to further improve the usability and to improve an applicationssuccess chances..

Wastewater handling of private sewage systems has become an all increasing matter. In Stockholm region the 90 000 private sewage systems contribute with larger phosphorus flows to the Baltic Sea than the two biggest sewage plants in the area, Henriksdal and Käppala, contribute together, even though these two plants purify wastewater from more than one million inhabitants. When summer house areas turn into areas for permanent living ? transition areas ? the load on the existing systems increases, systems that already often are unsatisfying. In those areas it is not clear what the best system choice is; On-site systems for single households; Local collective systems or Connection to central systems.

Because of a more globalised world the national states have been forced to make structural changes at both national, regional and local level to cope with different challenges. The regional community has become an important area which has resulted in a policy of more self governing, both for the regional and the local level.The aim of the thesis is to study the relation between regional and local level in the partnerships organisation. To fulfil the aim of the thesis, a case study of Region Skåne is used. The analyse is based on expressions such as cooperation, conflict, power and influence.The result of the thesis confirms that the opinion between the regional and the local level is very different. The representatives from Region Skåne experience the cooperation as quite good because it creates an opportunity for discussions and a possibility to learn from the other actors which in turn creates a qualification in the exchange of knowledge.

There are records of lowering of the water level in a lot of the Swedish lakes from the middleof the 1700th century. The aim was gaining more areable land to meet the needs of more foodto support the expanding population. In areas with top soil which contents of clay or loam asin the southwest of Scania in southern Sweden this was proven to be a successful wayexpanding the total outcome of the harvest.The studied area in the northeast of Scania, though, consists of morain with a lot of mires -much less nutritious conditions. When the water level is lowered the atmosphere gets accessto the peat. The dissolving of the organic matter that has been suppressed by the lack ofoxygene below water level continues.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

This paper aims to find out how to implement an information security management (ISMS) system that is based on ISO/IEC 27001-standard into a small organization with high employee turnover. The standard employs the PDCA-method as a course of action for implementing the standard. The reason for implementing such a system is to introduce information security to the organization and to maintain it despite the changes in management. The paper based it?s survey on a case study of a student nation in Uppsala, Sweden.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.