Syftet med denna studie var dels att undersöka användning av symptomfrågeformulär vid bedömning av ögontorrhet, dels att titta närmare på vilken metod och/eller vilka kombinationer av tester svenska optiker föredrar för bedömning av ögontorrhet.Metoder: Två olika typer av symptomfrågeformulär, den ena publicerad av The Canadian Dry Eye Epidemiology Society (CANDEES) och den andra med hjälp av Ocular Surface Disease Index (OSDI), översattes till svenska och distribuerades slumpmässigt bland patienter från en optikerpraktik i Kalmar. Dessutom har en webbaserad enkät skickats till 800 optiker för att undersöka deras förstahandsval av test för utvärdering av ögontorrhet. Deras andra, tredje och respektive fjärde val har också noterats, liksom eventuella ytterligare kommentarer.Resultat: Åttiofem patienter svarade på åtminstone ett av frågeformulären, varav 34% (17/50) CANDEES och 32,7% (16/49) OSDI respondenter uppgav att de hade milda till svåra symptom på torra ögon. Av de 800 e-postmeddelanden som skickades ut, svarade bara 64 (8%) optiker. Symptomfrågeformulär används oftast som enda testdiagnostik (42,2%).

Effects of Menstrual Cycle and Oral Contraceptives on Sport Performance During the menstrual cycle, there is a variation of the female steriod hormones estrogen and progestogen. These hormones has mainly reproduktive functions, but do also affect other physiological systems, which may have an influence on athletic performance. The use of oral contraceptives among female athletes matches the use among the general population. There is a concern among female athletes and there coaches weather oral contraceptives can affect the performance. The purpose of this litterature review is to determine the effect of the menstrual cycle and the use of oral contraceptives on athletic performance.

This thesis was done after a request from the county?s administrative board of Västmanland to provide the board with a better understanding of how green areas have changed within Västerås municipality over time.The purpose and goal of this study was thus to measure and analyze how much of the green areas within Västerås municipality that have disappeared during the past one hundred years as well as to provide a review of previous studies regarding the importance of green areas for humans as well as the biological diversity.In order to answer these questions I have in this study used a combination of a literature study, cartographic analysis as well as a time series analysis. The computer software used to do the measurements of the green areas was ArcGIS which is a geographical information system.In the cartographic and times series anlaysis measurements and analysis was made of the district map of 1911, the economic map of 1950 and the property map of 2011. The measurements show that the municipality has grown with 46,3 km2 over the last one hundred years. New neighborhoods? have emerged and the municipality has expanded.

This thesis is performed in cooperation with Prodelox AB and JTI (Swedish Institute of Agricultural and Environmental Engineering). The purpose of the project is to generate and develop a WC-technique with a closet sewer that keeps a higher TS-substance than 1.5 %. The WC-technique is mainly directed towards permanent households in sparsely-populated areas and cabins. The goal is to generate concepts of toilets with an extremely low use of water in terms of flushing. The design should be appealing and touch more senses than only the visual.

This thesis deals with the numerical 3D simulation of a four stroke, spark-ignited, internalcombustion engine, which is mounted on a high performance motorcycle. The work, carried outin collaboration with Politecnico di Milano and MV Agusta, focuses on the simulation of theintake, compression and expansion stroke, including combustion simulation, using an opensource CFD code.Simulation of internal combustion engines offers a great challenge in the field of CFD research.Moving boundaries of the solution domain, caused by the motion of the piston and valves, leadsto deformation of the computational grid, with decreasing quality of the solution as result. Basedon this, a previously developed mesh motion strategy was employed where a number of meshesare used to cover the whole simulation cycle. Within each mesh interval the internal cell pointsof the mesh are moved to account for the boundary motion of the piston and valves. This strategywas previously applied to simplified geometries as well as real engine geometries.

In the production of pulp, paper and cardboard, a large amount of water is used daily. The water has to be purified in the internal purifying plant before it reaches the receiving body of water. In the biological purifying stage at the Stora Enso Skoghall mill, an aerated basin is used where the microorganisms, using oxygen, oxidize the organic material to carbon dioxide. The air is pumped from the bottom of the basin and the oxygen can then be transported from the air bubbles to the water through diffusion. The problem with aeration of waste water from the forest industry is that wood residues, such as fatty acids, are making the transport of oxygen in water more difficult.

I och med Landscape Urbanism har landskapsbegreppet sedan en tid upplevt en hausse inom arkitektur- och stadsbyggnadsdiskurs. I och med denna nya uppmärksamhet för landskapet har ett nytt behov uppstått: att diskutera vad som egentligen menas när man använder detta mångtydiga begrepp. Med detta fokus behandlar denna uppsats komplikationerna som uppstår när ordet landskap och dess ofta motstridiga betydelser används utan att kommunicera vad som avses. Med utgångspunkt i lingvistiska teorier hävdar jag därför att språket och således semantiken, ordens innebörd, är av yttersta vikt för att formulera och konstruera nya stadsbyggnadsteorier såsom Landscape Urbanism. För vad betyder egentligen Landscape inom Landscape Urbanism? Hur kommer det sig att ordet dels används för att referera till ytorna ?mellan husen?, men även används som ett begrepp som beskriver hela stadens dynamik? Hur kan dessa mycket olika tolkningar av ordet landskap existera under en och samma paroll ? Landscape Urbanism? Denna uppsats behandlar dessa olika tolkningar, men presenterar även ett sätt att hantera detta till synes alldagliga men mångfacetterade ord. Due to Landscape Urbanism the term landscape has experienced a recent hausse within architecture and urban design discourse.

Today there are many applications of digital terrain models (DTM) and the requirements of low uncertainty increases. Most of the DTM are produced with Global Navigation Satellite System (GNSS), terrestrial laser scanning (TLS), airborne laser scanning (ALS) and total stations. Guidelines for the preparation and verification of DTM are found in Swedish Standards Institute ? Technical Specifications (SIS-TS) 21144:2007 and SIS-TS 21145:2007. These were defined in collaboration between Swedish National Rail Administration, Banverket, and Swedish Road Administration, Vägverket, to satisfy the needs of requirement formulations in the production of DTM planning, design and construction. The purpose of this paper is to produce and control DTM over Åkermans kulle, located west of the University of Gävle, according to SIS TS 21144:2007 using GNSS with network-RTK, TLS and ALS.

Beef production in Sweden has traditionally been about rearing of dairy calves to slaughter. With reduced number of dairy cows and accordingly less dairy calves for slaughter, there has been a need for new forms of beef production in Sweden. In Västerbotten there are good conditions for beef production with a high feeding level of roughage due to favourable climate. The aim of this thesis is to, through interviews with ten farmers with beef production in Västerbotten, study what and with how much they feed their animals and link the results to production level. The thesis begins with a literature review where the general feeding standards and feeding recommendations for beef cows and growing cattle are examined.

Detta examensarbete har utförts vid Linköpings universitet i samarbete med Scania Transmission i Södertälje och behandlar kravsättning av ytstrukturer samt processer för hårdbearbetning av kugghjul och axlar. Aktuella artikelritningar innefattar endast krav för Ra-värde, den aritmetiska medelavvikelsen för ytjämnhetsprofilen (R-profilen). Förslag på nya parametrar enligt av Scania tillämpade SS-EN ISO standards har tagits fram, detta för att ge en noggrannare beskrivning av vilken ytstruktur som skall uppnås. Resultatet är generellt tillämpningsbart men fokuseras mot kugghjulens hål, plan och diametrar. Vidare presenteras en jämförelse mellan metoder så att transmissionsverkstäderna kan tillverka kugghjul/axlar på ett kostnadseffektivare sätt.

Chinas government has a multifunctional program for a more sustainable forestry since 2000. This six key forest programs goal is to develop a more sustainable forest sector but also take environment consideration. The state forest administration in China has decided to create 5.8 million hectare of fast growing and high yield forest. Eucalyptus has showed to have good properties for pulp and timber production and therefore Eucalyptus plantations are under development in costal areas in southern China. By adding extra nutrients, growth can be enhanced in Eucalyptus plantations.

There have previously been very few studies of forests on Seram Island in the Eastern Indonesian archipelago and none before on lowland limestone primary forests. The COLUPSIA project on collaborative land use planning has therefore chosen Seram as one of two project sites. The objective of the COLUPSIA project is to establish collaborative and equitable land use planning. In order to achieve its objective the COLUPSIA project aims to improve understanding of traditional resource management and how it interacts with governmental systems, as well as enhancing knowledge about tropical landscapes and ecosystem services.The aim of this study was to contribute to the COLUPSIA project through describing lowland limestone forest on Seram Island in respect to (1) forest structure, (2) tree species richness and (3) tree species composition. We set up 5 plots, each of 0.2 ha, at one site, Mawalai, and collected data on tree variables (tree diameter ?10 cm) as well as for some other life forms and environmental data.

The degree project is performed at Metso Kamfab. The production is aimed on machines everything from handling of fiber to paper pulp. Metso Fiber and Kamfab are using Pro/Engineer for design and blueprint production. The processing department types the NC-programs in notepad on the basis of the blueprints, the CAD-dates that already is there are not used. The aim with the work is to study if Kamfab can use CAM-system for processing and production of programs for their NC-machines.

A problem in the field of district heating is the oil burners needed to provide power when a peak load occurs. One possible way of reducing the needed amount of oil is to reduce the power demand for space heating in the district-heating substations when the need for district heating water exceeds a certain limit. This can be done by use of a locally working controller function.In this Thesis the options concerning load priority are evaluated. To evaluate the potential for using controller functions concerning peak load priority an experiment was brought out in a chosen district-heating substation. The impact on the indoor thermal comfort during a heat reduction was also taken into account.

Abstract The accident in 1986 at the nuclear power station in Chernobyl, Ukraine, dispersed radioactive cesium over large areas of Europe. The half life of 137Cs is 30 years and this radionuclide also behaves like potassium, which means that it can easily be taken up by the vegetation or be adsorbed in to the structure of clays, principally illitic clays. When radiocesium decays ionizing radiation is emitted, which is harmful to humans that are exposed, either directly or indirectly through food intake. It is there-fore important to know what happens to the cesium that is dispersed into the environ-ment. In this project a simulation model was constructed to simulate the adsorption and transport of radiocesium in the soil and plant uptake.