AbstractThe future of ethanol is depending on good solutions for the production. ENA energy power plant produces electrical power and district heating by heating biofuel. By building an integrated bioenergy plant surplus steam could be used to produce ethanol as fuel to vehicle.This would mean that ethanol is produced renewable energy and the energy for the process derives from the surplus of power.  ENA energy, MDH (the University of Mälardalen) and the energy authority has initiated a research project were different bioenergy combinations integrate with existing power plant.  As a part of the project which size an integrated factory should be to gain the best efficiency for the plant was investigated. Consideration will be taken to the cost of the production in order to be competitive to the price of imported ethanol.  Etanolens framtid vilar på bra lösningar för framställning.  I ENA energi kraftverk i Enköping produceras el och fjärrvärme genom eldning av biobränsle.  Genom att bygga ett integrerat bioenergikraftverk där skulle man kunna använda överskottsånga till att framställa etanol som fordonsbränsle.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

Val av sparform vid ägande i aktier har blivit allt mer aktuellt sedan det år 2012 infördes en ny sparform. Beskattningsskillnader mellan de tre nuvarande sparformerna har lett till konfunderade och osäkra aktieägare. Att optimalt val av sparform beror på ett flertal föränderliga och individuella faktorer gör att ett generellt och entydigt svar saknas.Denna rapport ska på uppdrag av ett mindre förvaltningsföretag med anledning av ovanstående, ta fram ett matematiskt verktyg vilket illustrativt ska rekommendera val av sparform utifrån olika antaganden. Rekommendationerna ska leda till att aktieportföljens avkastning efter skatt maximeras. Vidare ska rekommendationer kring implementation av den matematiska modellen i företagets verksamhet ges, där fokus ligger på ökat kundvärde.Modellen som togs fram kan utefter aktieägarens förväntade årsavkastning, förväntad prognos över statslåneräntan, placeringshorisont samt individuellt courtage rekommendera vilken sparform som ska väljas, samt när och till vilken sparform ett byte ska ske, för att därigenom maximera avkastningen efter skatt, givet att byte av sparform enbart tillåts vid årsskiftet.

Swedish forests are dominated by just two conifer species Norway spruce and Scotch pine. They are not able to achieve the highest possible production or fulfill industry demands for raw materials. The introduction of exotic conifers can potentially meet these shortcomings and present a relevant solution. This study was conducted in a block experiment with ten blocks planted in 1987 by SCA in North Sweden. The objective of the block experiment was to study if Black spruce is an appropriate alternative to Lodgepole pine, Norway spruce and Scotch pine on different site classes.

During half a century the society has been changed from an industrial to knowledge-driven society. Industry companies have standardized requirements and companies that works with development in production has unique qualifications. The public employment office was created during a time that each tailored to then general requirements were dominating and the adaptation average appropriate worker and appropriate work where general. When the monopoly was stopped, crew companies begun to settle down on the market that flexibly adapt themselves to carried out now specialized needs that require sophisticated adaptation average work and job seekers. Companies lose the confidence for the public employment office and politicians threaten the organization with big closure.

Today's unsustainable resource use is influenced by many factors. One key factor isproduction methods and patterns. Trough change of production patterns enterprises can bepart of the solution to a more sustainable society. This case study has analyzed environmentalperformance of the printer company Edita Västra Aros Ltd (EVA), who has gained awards forits environmental work, and what driving forces they have had during this work. The survey isbased on a qualitative method and the collected data consists of documents and staffinterviews, which have been analyzed with content analysis.

This master's theses was carried out on assignment from Stockholm Vatten AB as a part of a project developing new waste water treatment techniques. The goal of the theisis has been to evaluate an anaerobic membrane bioreactor for treatment of waste water from Hammarby Sjöstad. The bioreactor has not been heated and the main interest has been to study the gas production, power consumption and the reduction of organic matter and nutrients.The system has been completed with a reverse osmosis unit and a total of four batch runs have been made with good results. The use of reverse osmosis allows nutrient in the waste water to be reintroduced into circulation as the reverse osmosis concentrate can be used as crop nutrient.The membrane unit is of VSEP ("Vibratory Shear Enhanced Processing") type and an extensive membrane test has been conducted. This so called L-test helped determine the most suitable type of membrane for the system to allow a higher ±ux and thus lower power consumption.

The purpose of this literature review was from dairy cows? behaviour and welfare point ofview describe how feed bunk and cubicles in a loose house system should be designed. Todaydairy cows in Sweden and in the world have high demands because of a high milk production,stress and higher risk of being afflicted with diseases. Through selection in breeding the bestquality can be performed, but high demands of the environment for the dairy cow is above allalso important for a good welfare and for a good milk production. Feed bunks and cubiclesare just some parts to be designed in the best way for a good animal welfare.

Background: Good communication is very important for the safety of patients in emergency situations. Few studies have been conducted regarding communication among health care staff. The aim of the present study was to investigate anesthetist nurses experience of communication among health care staff during a situation of emergency in a hospital ward.Methods: The study is explorative and based on interviews with six anesthetist nurses. A qualitative content analysis was used as an analyses model.Result: The six anesthetist nurses experienced structured communication as of great importance during an emergency situation. Three main categories appeared from the material: i) the importance of the organization ii) communication structure and communication patterns and iii) education and experience with nine subcategories.

During the last years, producers and consumers have become increasingly aware of food safety. Foodborne illness and foodborne injury are in best case unpleasant but they can also be fatal. HACCP (Hazard Analysis Critical Control Point) is a preventative food safety system which is aimed to guarantee production of safe food free from pathogens, foreign materials and substances with potential to cause adverse health effect. In order to succeed in developing, installing, monitoring and verifying a HACCP system, there is a mix of hurdles for the company to overcome. While larger food companies meet a difficult challenge, small and medium size enterprises often feel that the hurdles are almost impossible to manage.

This final thesis aim to create a support that can decrease the uncertainty when planning the cable drum flanges lines that produces cable drums in the interval 100 to 320cm in diameter at Vida Packaging in Hestra. The purpose attains through finding an optimal batch size that minimizes the total storage cost and order prime cost, without degenerate delivery capacity to the customer. Through survey the sale and stock balance development during 2005 and 2006 for cable drums in Hestra and give alternative suggestions how to plan the production after installing a new cable drum flanges line. The study also explores different ways of working during product change in existing nailing line, to minimize the order prime cost. Vida Packaging in Hestra is a part of the Vida group, which is Sweden?s largest privately owned sawmill group with seven sawmills placed all around southern Sweden.

The milk production per cow has increased considerably during the last 50 years and due to the breeding for higher milk production also brings decreased reproduction efficiency. In a Swedish study 1996 it was shown that on average only half of all estruses were detected. Every time a farmer fails to detect oestrus it costs the farmer about 1200 Swedish crones and the need of means of detecting oestrus is therofore large. With this study we wanted to investigate if heart rate respectively crystallisation of vaginal mucus (arborisation) could be useful means of detecting oestrus. We monitored two oestrus cycles in four heifers.

The purpose of this report was to identify the current waste management of non-hazardous construction and demolition waste in a few Swedish construction companies, based on the different steps in the waste hierarchy with a focus on waste prevention, reuse and recycle. Additionally, the purpose was to attempt identifying opportunities, obstacles and as well as to propose possible solutions from an environmental perspective. The method used was a qualitative study using interviews conducted through emails and phone with employees occupying positions that could answer this reports questions. The results of this report indicates that waste management of construction and demolition waste has improved, and less waste goes into landfills. The concern is that the overall amount of waste being produced is not decreasing, thus calling for actions preventing the production of waste.

AbstractThe future of ethanol is depending on good solutions for the production. ENA energy power plant produces electrical power and district heating by heating biofuel. By building an integrated bioenergy plant surplus steam could be used to produce ethanol as fuel to vehicle.This would mean that ethanol is produced renewable energy and the energy for the process derives from the surplus of power.  ENA energy, MDH (the University of Mälardalen) and the energy authority has initiated a research project were different bioenergy combinations integrate with existing power plant.  As a part of the project which size an integrated factory should be to gain the best efficiency for the plant was investigated. Consideration will be taken to the cost of the production in order to be competitive to the price of imported ethanol.  Etanolens framtid vilar på bra lösningar för framställning.  I ENA energi kraftverk i Enköping produceras el och fjärrvärme genom eldning av biobränsle.  Genom att bygga ett integrerat bioenergikraftverk där skulle man kunna använda överskottsånga till att framställa etanol som fordonsbränsle.

Lean Production är ett koncept som finns, i mer eller mindre utsträckning, i många företag idag. Konceptet bygger på ett antal principer bestående bland annat av standardiserade arbetsprocesser som syftar till att minska allt slöseri som inte tillför något värde för kunden. Att implementera konceptet i en verksamhet innebär en planerad organisationsförändring och kräver för ett lyckat resultat ett ledarskap som kan motivera de anställda. När ledarskap diskuteras i samband med organisationsförändringar, talas det ofta om transformativt- och transaktionellt ledarskap. Syftet med uppsatsen är att beskriva samt analysera vilka aspekter av ledarskap som är speciellt framträdande under olika implementeringsfaser av Lean Production. För att besvara detta, samlades empiri in genom semi-strukturerade intervjuer på fyra företag, verksamma inom tillverkningsindustrin i Sverige.