This thesis project has focused on studying ÅF?s business concept Energy Collaboration, which is their way of selling energy efficiency services. Thereforeongoing projects have been analyzed. The purpose was to determine achieved energy efficiency, costs and profitability for the studied projects. It was concluded that the Energy Collaboration is a good way of selling energy efficiency services, since the customer takes no risk and energy savings of about 15-25 % can be achieved with simple measures.

Storm water is rain and melted snow that runs off, primarily from impervious surfaces.Future storm water management is facing the challenges of increased precipitation, asclimate changes, and increased areas of impervious surfaces due to the expansion anddensification of the cities. Impervious surfaces reduce the potential for water to infiltratein the ground leading to increased surface runoff and higher peak discharge.The runoff coefficient is closely related to the percentage of impervious surfaces andrepresents the maximum percentage of a catchment that can contribute to runoff. In thisstudy, the objective was to evaluate the weighted runoff coefficient for three differenturban types; apartment buildings, townhouses and residential areas and a comparisonbetween today and the 1970`s was made.The runoff coefficient was determined by manual mapping of the different surface typesin each area based on data in the form of orthophotos and aerial photographs. The surfacetypes that were mapped were asphalt, permeable areas, tiles, sand/gravel and roof.Tiles and sand/gravel were the most difficult surface types to map. In order to see towhat extent these categories influenced the weighted runoff coefficient a sensitivityanalysis was carried out and the runoff coefficient based on surface type was changed indifferent scenarios.The results of the sensitivity analysis showed that the surface types tiles and sand/gravelhad little impact on the weighted runoff coefficient which in mainly due to the fact thatthe percentage of these surfaces types of the total area is small.The result of the study showed that the largest change in the runoff coefficient occurredin residential areas where the increase in the percentage of impervious surfaces causedby new roofs in the form of porches and garages and from paved or tiled driveways.

With the globalization, companies in the West chose to shift production to developing countries to cut down costs. This had a major impact when child labor and very poor working conditions in these factories were discovered and led many companies to take responsibility for their suppliers and the employees by adopting voluntary so-called Codes of Conduct.There is a subtle balance to enforce improvement of working conditions for employees at suppliers´ factories and to keep costs down. On the one hand, companies would like to conduct extensive audits at their suppliers to ensure code of conduct compliance and thus protect their legitimacy. On the other hand, audits are expensive so companies would like to minimize audits to keep costs down. Companies thus have to strike a delicate balance in relation to how many and what suppliers they choose to audit.

The purpose of this study is to illustrate if structural factors to welfare indicators and the internal organisation of handle social assistance in combination with dominating ways of living with their values and norms can be used to explain why the costs of social assistance are low in Säffle township. The character of this study is exploratory, though important aspects in this case was unknown. The empiricism come from descriptive secondary statistics and from qualitative interwievs with three inhabitants in Säffle, whom are experts which means they know the township of Säffle and it´s inhabitants well. Säffle has been studied from four perspectives, of which the first two have a top- or macroperspective. In the study appears two divergent pictures.

The task for this thesis is to design a tool that is used to cut-out preforms of thermoplastic adhesive and also to make an estimate of costs for the stamping tool. The tool is used in the repair process at the MCM production line. The result of gathered information has affected how the design of the stamping tool has developed. The handling of thermoplastic adhesive in the repair process is one of the factors that influenced the design. The adhesive is sensitive for exposure to moisture. Therefore an automated feeding system of the adhesive is not recommended. The users wished for an automated stamping tool.

Uppsatsen är ett examensarbete på 22,5 hp, som kom till på uppdrag av SONO inredningar och Tranås skolmöbler och har utförts av Sara Storm, student på Produktdesignprogrammet vid Malmö högskola, under våren 2012. Arbetet behandlar klassrummens ljudmiljö i låg- och mellanstadieskolor samt hur elever sitter i sina stolar. Kan en elevstol bidra till en bättre ljudmiljö i klassrum och erbjuda en bra ergonomisk sittkomfort för eleven? Resultatet blev en stol, där material och konstruktionslösningar reducerar buller och med sin vippfunktion möjliggör ett flexibelt sittande..

In Sweden, there an increasing need for transport and this leads directly to fuel demand of the transport sector is expected to increase. Both politicians and industry believes that renewable fuels are a realistic and significant method to reduce the transport sector's environmental impact. This study aims to document the Swedish haulage contractor?s attitude to biodiesel. Also to document the strengths and weaknesses of biodiesel, based on opinions from the ultimate consumers.

Extended Producer Responsibility (ERP) is a form of product take-back regulation that requires the producers to manage their products at the end of life. By internalising the products? entire life cycle costs into the market price the ultimate objective of such regulations is to reduce the environmental burden from the products. This Master´s thesis seeks to examine if the total life cycle cost of a product actually is borne by the producer, and if not, predict who will then take this cost. This is done by analysing the market for take-back activities in three different categories of products; electrical and electronic equipment, cars and wind power stations.

 IAS 40 allows two methods of valuation for investment properties, fair value model and cost model. The purpose of this paper is to investigate what drive property companies to disclose their investment properties at fair value. In order to understand their choice, we use accounting choice theory and the three factors this theory describes, information asymmetry, allowing opportunism and agency costs. To answer our purpose, we have from a qualitative approach performed semi-structured interviews with respondents from five of the largest listed property companies in Sweden. The results suggest that firms have chosen the method that is most effective in the valuation of investment properties.

Datorspel har under början av 2000-talet tagit världen med storm. Fenomenet har exploderat från att vara en angelägenhet främst för de redan frälsta till en internationell miljardindustri. Sverige är en av de bästa länderna i världen på datorspelsutveckling. Alla som vill kan dock inte genast ta del av underhållningen. Ett funktionshinder kan försvåra eller helt förstöra spelupplevelsen.

An important task for Region Skåne is to allocate resources to the health care districts. From 1999 to 2002 Region Skåne used needs-based resource allocation as a model for allocating resources. In a needs-based resource allocation individuals with the same socioeconomic and demographic characteristics are assumed to have the same level of need and are therefore allocated the same amount of resources. During the period of needs-based resource allocation a matrix model was used as a method. In the matrix model individuals were divided into cells after each combination of the socioeconomic and demographic variables.

The aim of this thesis was to answer a number of questions about the environmental consequences of aircraft de-icing. A further aim was to suggest how the environmental consequences due to the release of de-icing fluids can be measured and reduced.The main impact of the aircraft de-icing on the environment is due to the large oxygen demand for the degradation of glycol based de-icing fluids which are released in the environment. The effect of the increase in oxygen demand depends on where the degradation occurs in the ecosystem. In a sensitive ecosystem, the large demand of oxygen could provide an anaerobic environment which would be harmful for many types of organisms.In order to reduce the negative effects of the applied de-icing fluid, there is some type of collection system at every regular airport in Sweden. The methods of collection can be divided into two general groups, hydrological isolation or vacuum sweeper trucks.

Many IT projects that have been developed in recent years are often considered to be unsuccessful. According to a study by Exido up to the 72% of all IT projects are considered to be failed. A failed IT projects means that the organizations that have ordered the new system may have higher costs or/and the system will not be ready in time. If costs are too high the new system might not be installed in the organization or if the system is not completed within the specified time frame the organization can become stagnant.In this paper we conduct an investigation of the failure of IT projects there we will examine where, in the systems development lifecycle four different phases, projects fail. We will conduct an empirical study of each phase, where we describe the key steps in the process; we will also investigate failed IT projects that are linked to the current phase.

Buildings worldwide account for 40 % of the total energy use. Climate change is of increasing importance, but few are willing to reduce their standard of living or get a higher cost for the change. Energy efficiency of existing buildings gives the greatest benefit economically and environmentally. The real estate company Klövern AB manages 46 properties in Karlstad. Heating is the major cost of the total operating costs of real estate. Rising energy prices increase the need for Klövern AB to improve energy efficiency and to investigate alternative sources of heat.

To be competitive in the corporate climate of today it is important to have effective logistic activities. A common resource within the internal logistics is forklift trucks, which are used to lift and transport material. It becomes more and more important to decide whether to buy, lease or rent the forklifts to obtain an optimal economic situation. Many companies have issues with internal pricing. It is difficult to price products and services correctly. It is common to price the overall instead of what it really costs.The purpose of the thesis is to present a model for the acquisition of forklifts for internal logistic operations, regarding financing and internal pricing, to obtain economic effectiveness and an optimal forklift fleet size. The study focused on a specific research question, and for this purpose interviews with experts were held, observations were made and a literature study was done.