This thesis work has been carried out at the consultant company Pöyry Sweden AB in Norrköping, whom performs the task for E.ON heating Sweden AB, Händelöverket in Norrköping. The report shows methods to manufacture slurry consisting of fly ash and water. The slurry shall be pumped into several former oil storage rock shelters that E.ON has put into operation for the specific purpose. The ash mixture also develops hydrogen gas in contact with water.The work has aimed to produce different suggestions of methods and equipment that can be used for the objective. Mixing method and security issues were in centre while working with the suggestions.

The purpose of this master?s thesis is to contribute to the development of business relationships between a supplier and its customers. The research area and research problem was further developed into three research questions. The research questions concerns the following subjects: the substance of business relationships and dimensions within relationships management that can be used in order to contribute to the development of a company?s business relationships.

Traditionally, rolling mills use emulsions based on a mixture of oil and water for lubrication. Since two years ago SAPA has been using (instead of oil) a synthetic lubricant so called conditional emulsion for hot-rolling of aluminum. This lubricant is water based and homogenous at ambient temperature, but switches to a two-phase system at heating above the cloud point.This project aims to validate and if necessary modify an existing HPLC method for quantifying two out of three key components (A, B and C) in the conditional emulsion. Attempts to develop a method to quantify the pH adjusting components, X and Y were also made. These two methods are required to optimize the lubricant.Due to the complexity of the components, it has been difficult to present a method for quantification, and HPLC with ELS detection was chosen after a long series of trials.

Med ett energikombinat vid Lillesjöverket vill Uddevalla Energi energieffektivisera samt sänka temperatur på återkommande fjärrvärmevatten, för att kunna utnyttja rökgaskondensorn effektivare. Uppdraget var att utreda mängden tillgänglig energi under sommarhalvåret och utföra en matematisk kalkyl som ska ligga till grund för val av tork. Valet stod mellan två alternativ av tork där storlek på värmeväxlararea och investeringskostnad skilde dem åt. Sedan följde dimensionering av fjärrvärmeledning samt cirkulationspump från fjärrvärmenätet till tork. Syftet var att ge Uddevalla Energi ett tekniskt beslutsunderlag för val av storlek på tork samt dimensionering av energiöverföring till densamma.

This report describes the construction of a climate-cabinet for testing of HV-cards (High Voltage) produced at VG Scienta. The main part of the report describes all the different components of the cabinet. The most important parts are a PID regulator from Eurotherm model 2408, a solid state contactor (SSC), a thermocouple, a finned resistor from DBK and different fans. The report even includes the connection between components by cable wiring, isolation, grounding, fuses and shaping of metal goods.As the cabinet also communicates with a computer, the report includes the solution of the data communication using the software iTools from Eurotherm. The communication part includes information about a converter that converts EIA422 to USB.The cabinet was produced at a company, called VG Scienta, in Uppsala during the spring 2010.

This study has been carried out in the spring of 2014 on behalf of PQR Consult AB in Stockholm. The aim of the study has been to analyse the energy usage of the building Skarpövägen 1 in order to explore the possibilites of saving energy by using appropriate equipment. These possible solutions have been simulated by using the programe IDA Indoor Climate and Energy, combined with a life cycle cost analysis. The laundry building, Skarövägen 23, has also been analysed due to its high amount of energy usage. The result of the energy analysis showed that the energy usage was much higher than the energy declaration.

This report contains a study of replacing nuclear power with biofuel. The nuclear plant, OKG north of Oskarshamn in Sweden has been chosen and an extensive literature study about the nuclear plant has been implemented. The main aspect of this report is the availability of biofuels and whether it would be economically sustainable. Sweden?s most common biofuels are examined with regard to scope of use and potential.

The purpose of this work is to study a circulation project in Enköping municipality, where the society?s rest products are used to make beneficial products. In Enköping the rest products from waste treatment plants and private sewers are used to fertilize and irrigate Salix plantations that later are harvested and burned at the local combined heating and power plant, ENA Energy AB, to produce electricity and heat. Possibilities to apply this kind of project ona municipality in Russia are also explored.Guryevsk municipality in Kaliningrad region was chosen since there is a need to improve energy systems and reduce emissions to water and air. This municipality strives to become environmentally friendly.

In Sweden, a big part of the energy use is used in the housing sector. Political goals and targets are set up which the housing sector needs to work towards. Apartment buildings are a major part of the housing sector in Sweden and therefore reduction of energy use in these kinds of buildings are key to lower the energy use in Sweden. But there are not only political incentives to reduce the energy use. Some energy?saving measures are directly profitable and should thus be performed.

Vattenfall district Heating power plant in Uppsala produces district cooling with absorption heat pumps which leads to a large amount of waste heat that has to be cooled with evaporative cooling towers. The Environmental Court has ordered Vattenfall to survey the possibilities to recover the heat, which is the focus of this thesis.The study begins with an overview of the system, and conditions and limitations for waste heat recovery is examined. In the next step alternatives to recycle the heat is evaluated, either by direct recovering or by upgrading.First, the technical possibility of each alternative is discussed, and then the operation time and the amount of recovered heat is calculated. Those alternatives which are possible are brought further to an economic analysis.The cost of investment for each alternative constitutes the basis for a present value analysis. The results are put together in a table where the total amount of recovered heat is compared with the present value for the different alternatives.

The Swedish parliament has decided that Sweden should increase its usage of renewable fuel sources to a level of 50% of the total energy consumption in Sweden by the year 2020. One way to reach that goal may be to increase the usage of stumps as a bio-fuel. In Sweden stump harvesting is possible on about 5-10% of the total harvested area and thus contribute with 1,3 - 2,6 TWh per year. An increase stump harvest doesn't come without its drawbacks for the environment. When harvesting stumps a tracked excavator is used to pry the stumps from the ground and then cut the stumps into smaller pieces.

The essay deals with the hill-fort on the mountain Halleberg, Sweden, its wall design, functionality, dating and its possible function as a central location and a place of worship of the ancestors.The Halleberg hill-fort consists of a 1500 meters long at times cohesive stonewalls which together blocked the mountain from its surroundings. Hallberg's natural vertical scree and cliffs along with the masonry blocked the whole mountain from the surroundings.The hill-forts, with few exceptions are largely not investigated archaeologically and its functionality and role in the ancient society is based on outdated research on the subject. The current archaeological interpretation is that hill-forts served as temporary defense in times of unrest or served as center of power for a social elite. The prevailing view in the archaeological sphere is that the hill-forts had a variety of functions and that its functionality and role in ancient society has varied.Halleberg´s strongest wall sections are at the mountain's south-eastern part where the natural driveway, Storgårdsklev is located. Along with the massive masonry of the walls in Bokedalen Storgårdsklev functioned as the hill-forts main entrance.

When drivers overnight in the truck lots of electric energy is consumed by heaters, fans, lights and other extra equipment. If the engine is not running, this energy is taken from the lead/acid batteries of the truck which then needs to be recharged during operating hours. The fact that the charge acceptance of the lead/acid batteries is dependent on the temperature makes it hard to fully recharge the batteries at lower temperatures. A negative charge balance can lead to starting problems within a few days use in cold climate.In this thesis work, the effects of different battery charging concept are evaluated on the most common Scania battery (175Ah). A battery model is implemented in Matlab and some simulations of charging are made.

Reptiles are animals than have been neglected in the research for all times. Some people have the opinion that these animals have fewer needs and demand less from their caretakers. The Aldabra Giant Tortoise lives on the Aldabra atoll outside the coast of Tanzania. The Aldabra tortoise population has varied throughout the years, but today the population is around 100.000 animals. The purpose of this study was to analyze the enclosure utilization of two Aldabra tortoises, a male and a female, at Parken Zoo in Eskilstuna, Sweden.

In 1886 Hans Hildebrand received a Bronze Age hoard found in a field that belonged to Eskelhem´s rectory. A record was made where Hildebrand presented and documented the artifacts. The following year Oscar Montelius reviewed the artifacts, which he described as horse gears. He compared the horse gears with similar artifacts found in Europe that roughly had the same dating in order to trace the origin of the hoard.  Montelius conclusion was that the hoard was created on Gotland around 500 BC.