The collective agreement contains many important provisions concerning the relationship between employers and employees. When a collective agreement applies in the workplace, both employers and employees are bound by it. However, only employers of those two, can take part in the collective agreement, and therefore negotiate the content of it.The purpose of this study is to answer the following question: Why are rules that has been interpreted in collective agreements not expressed in writing? Therefore, the Swedish collective agreement system will be examined, and a distinction between types of silent regulations will be made to find causes. The potential for workers to act on a collective agreement with quiet regulations will also be examined.Collective agreements are signed on three levels: central, union and local levels.

Estimation of the variation in the integrated hydraulic conductivity around the Tunåsen infiltration facility - An investigation of the effects of uncertainties in existing informationAlmost half of Sweden?s drinking water volume is produced from groundwater. The main fraction of this is extracted from eskers, some of which allow for very large extraction rates. Despite this, the groundwater volume is not sufficient in some areas. This has led to an extensive use of artificial recharge.In Uppsala, the total volume added through artificial recharge is divided between four infiltration facilities.

The purpose of the thesis Masculinities ? Gender and its Impact on the Social conditions of individuals is to perform a critical study of how gendered norms influence the social conditions of individuals. This has been done by a problematization and the attempt to answer the question of how the hegemonical masculinity can be analyzed as a discourse, and how the structural aspects of this discourse inflict on the social conditions of masculinities.The question was divided into the analytical themes: the boarders of the discourse, the institutionalization of the discourse, the actuation of the discourse and the agents of the discourse. The theoretical frame is constituted by the theory of discourse by Michel Foucault, the theory of the hegemonical masculinity by R.W. Connell and a subversive identity theory by Judith Butler.

Feline odontoclastic resorptive lesion (FORL) is a tooth disease affecting both domestic and wild cats. Although FORL was described as early as the 1920´s, the etiology is still unclear. Several hypotheses have been presented but different studies have obtained contradictory results, and today there is no generally accepted etiology. Teeth affected by FORL are characterized by root resorption with progressive destruction of the tooth structure and alveolar bone as a consequence of clast cell activity. The disease is considered very painful when reaching a certain stage.

The building sector accounted for around a fourth of the total energy usage in Sweden in year 2010 (Energimyndigheten, 2012). Therefore it has become very interesting to achieve a lower energy usage in residential buildings. One way to achieve that is to build so called passive houses. By being very well insulated and have low leakage through the walls, they can reduce the energy usage for heating with a substantial amount. The first passive house was built during the 90?s in Germany; and in Sweden the first passive house was built in Gothenburg 2001.

This is a qualitative case study about tourists and boat migrants in movement to and in place on the Canary Islands, Spain. The aim is to study how these two groups of guests are treated differently, either as guests or strangers, based on how they move, illegally or legally, where they come from and where they have rights to go. To analyze the case I use theories of how differences in ethnicity, culture and religion etc. are created and recreated in society in interactions among humans and in the politics - the politics of difference. The politics of difference creates and recreates categories of mobility such as tourists and boat migrants.

The aim of this paper is to empirically examine the ideological trends and positioning of the Swedish liberal party with the Danish social liberal party. This paper also aims to analyze the reasons behind the trends. By examine the development in these two Nordic liberal sisterparties, this paper contributes to our understanding of why and how party change is initiated. The paper commences with an intuitive notion that the Swedish party has in fact, made a lurch towards the right, during the past ten to fifteen years while the Danish party has retained their social-liberal position in the centre of the Danish political spectrum. The questions then asked are: can this hypothesis be verified empirically? If so, how can this phenomenon of divergence, be explained?The method used in this thesis is process-tracing and the empirical material does to a large extent rely on interviews with central agents as they are specified in the theory of each party.

The spatial population structure of the saprotrophic basidiomycete Tulostoma brumale was investigated at a site in south eastern Sweden. Sporocarps were mapped and collected, and somatic incompatibility tests between mycelial cultures cultivated from the sporocarps were used to identify genets. Calculations of the size and numbers of genets and their distribution were performed. The spatial distribution of the tested sporocarps and the identified genets are presented graphically in a grid. The total number of identified genets within the investigated area (1210 m2) was 27 based on 48 tested sporocarps.

During springterm 2010 Erik Persson and Magnus Hansson performed their ThesisWork with DIAB Laholm, in Hallands County for University of Halmstad.The project has been a product development project without exterior customers. Thusit had a great emphasis on functionality and less emphasis on marketing and such.This reflects the ambition to develop machinery to be used within the productionfacilities of DIAB Laholm, not to be sold to exterior customers.Main objective has been to create machinery which enables the production ofrotational symmetric work pieces within a NC-milling machine with 5 axles. Thework pieces milled will be made of DIAB?s material Divyncell with varyingdensities.The project has followed Fredy Olssons method involving Principal ? Primary ?Manufacturing constructions. However a complete manufacturing construction hasnot been made since DIAB just wanted a good Primary construction which will serveas a base for finishing touches at DIAB.By the end of the project material including calculations has been sent to DIAB andthey will finish the work and manufacture the machine if they find economic viabilityin this.The work method has been suited for this by several reasons, it was created withthese projects in mind and it?s also the method most familiar to us..

The aim of this work is to demonstrate how the net present value (NPV) at the time of the first thinning depends on the spacing after pre-commercial thinning, and show how net value from first thinning in same stand is influenced. This study is performed with models based on non-distant dependent growth models for single trees. Two different growth models have been used, one for cleaning (pre-commercial thinning) and one for thinning. The first one yields stem density distributed over diameter classes. In the second one, (the thinning model), it is possible to choose when thinning should be done, the thinning method, thinning grade and numbers of thinning.

Purpose: The study examines the risk a rising from the acquisition of shares, and its relation to the expected return. We would like to see how a high-risk portfolio is related to a low-risk portfolio. Although studying the portfolios annual performance.Theory: The theories that have been used in the study are, Capital asset pricing model, CAPM and portfolio theory.Method: The study is based on a quantitative method, the time interval is from 2008 to 2010.The annual reports, historical stock prices for companies and the index are used to perform calculations based on the essay theories.Conclusion: The beta value has positive liner correlation with the expected return. When there are bad times in the world, the companies are negatively affected regardless of industry. The Portfolios developed in the same direction during the time period..

From January 1st 2011 the use of Eurocode will be mandatory for all constructionprojects. Eurocode is the common European set of struc-tural design codes which willreplace BKR (Boverkets Kon-struktionsregler). BKR is the Swedish set of structuraldesign codes that was used up until December 31 2010. For consulting firms this willcre-ate a need for them to invest in the standards and in education for thecoworkers. This will involve both time and costs for the company.The purpose and aim of this master thesis is the development of compute examplesand calculations aid by dimensioning with Euro-code.

This report aims to provide an insight into the particle physics of today, and into the research that goes on within the field. The focus is partly on the recent discovery of the Higgs boson, and partly on how software can be used to simulate processes in particle accelerators. Basic concepts of particle physics and the search for the Higgs boson are discussed, and experimental results, including those from the Large Hadron Collider, are compared with simulations made in MadGraph 5. Furthermore, simple new models of particle physics are created in FeynRules, in order to make simulations based on the models. To support the presentations of these aspects, some of the underlying theory is built from the ground up.

The aim of this study has been to discuss ideas of knowledge within classification theory and subject analysis in the light of theories of fundamental changes in the production of scientific knowledge. Guiding questions have been: How have the conditions of knowledge production changed? How has interdisciplinarity as part of this development evolved? What assumptions lie behind theories of classification and subject analysis? How do these stand in relation to the alleged changes in the production and understanding of science? Three works about the changing conditions for knowledge production and the growth of crossdisciplinarity have been presented and discussed. These works stress the loosening up of boundaries between traditional knowledge domains and open up for discussions about how to organize knowledge production in the light of these changes. In the study it is argued that their works also could open up for discussions about the way knowledge is organized for retrieval purposes.

During springterm 2010 Erik Persson and Magnus Hansson performed their ThesisWork with DIAB Laholm, in Hallands County for University of Halmstad.The project has been a product development project without exterior customers. Thusit had a great emphasis on functionality and less emphasis on marketing and such.This reflects the ambition to develop machinery to be used within the productionfacilities of DIAB Laholm, not to be sold to exterior customers.Main objective has been to create machinery which enables the production ofrotational symmetric work pieces within a NC-milling machine with 5 axles. Thework pieces milled will be made of DIAB?s material Divyncell with varyingdensities.The project has followed Fredy Olssons method involving Principal ? Primary ?Manufacturing constructions. However a complete manufacturing construction hasnot been made since DIAB just wanted a good Primary construction which will serveas a base for finishing touches at DIAB.By the end of the project material including calculations has been sent to DIAB andthey will finish the work and manufacture the machine if they find economic viabilityin this.The work method has been suited for this by several reasons, it was created withthese projects in mind and it?s also the method most familiar to us..