The Kedertruss is the loadbearing part in the Keder weatherprotectionsystem and it has been analyzed concerning its loadbearing capacity. The Kedertruss is produced and manufactured by Wilhelm Layher GmbH & Co. KG and this report has been made for their Swedish division Layher AB.  The Kedertruss, designed in Germany according to German designcode, has been recalculated concerning Swedish conditions according to Eurocodes and a ongoing European standardization project. The two-dimensional program Winstatik Frame Analysis has been used for evaluation of load effects. Capacity has been calculated by hand-calculations and it has been verified that the Kedertruss in its larger spans isn?t able to withstand the loads.

The objective of this M. Eng. Diploma work was to validate the new version, CASMO-5M, and compare the results with CASMO-4E, by using the same input in both programs. The tasks that were included in this work was to compare TIP-measures, k-effective curves (warm), k-effective curves (cold), the effect of void on k-effective, the isothermal temperature coefficient (ITC), the moderator temperature coefficient (MTC), damping ratio calculations, internal effect in a fuel bundle of a BA-rod, the speed of BA-out burn, impact of xenon, falling control rod, margins and isotopes.The TIP-measures showed that the differences were small for all reactors, at most, 6% nodal improvement by C5M (Casmo-5M) for Oskarshamn 3. The warm measurements of k-effective showed that C5M had a higher value for all cycles of Oskarshamn 1, 2 and 3 in comparison to C4E (Casmo-4E).

The objective of this study was to determine the mineral content in ten New Zealand monofloral honeys, in order to distinguish whether New Zealand monofloral honeys are a good source of minerals compared to honeys from other parts of the world. The ten monofloral honeys were collected from a local honey factory (Airborne Honey Ltd, Leeston), Clover, Honeydew, Kamahi, Manuka, Nodding Thistle, Rata, Rewarewa, Tawari, Thyme and Vipers Bugloss honeys were been investigated. The water content, water activity, pH, conductivity, colour and mineral content were evaluated. The water activity was averaged for all the ten New Zealand monofloral honeys and set to 0.59 aw, which indicates a high stability and long shelf life as a food stuff. A strong correlation between total mineral content, pH, conductivity and colour was obtained.

The county hospital of Dalarna has for the last couple of years carried through a process of digitalization. The result is that within the county it exists image plate systems from two different manufacturers. In an attempt to create a tool for dose optimization and dose surveillance the county of Dalarna would like to investigate if the exposure index from Agfa and Fuji is suitable as a dose indicator. An investigation of the exposure index, S, from Fuji has already been done. This thesis has been continuing the investigation by evaluating the stability of the exposure index, lgM, from Agfa.

The intention of this study was to create an understanding of how multi-professional interaction could convert into inter-professional collaboration, which takes advantage of and acknowledges the individual professional identity. The intention was to understand the meaning of collaboration through the study of meetings between professionals who use different symbol systems. In particular, we wanted to study inter-professional interaction from a symbolic interactional perspective with a focus on Self, Identity, Symbols, Meaning and Professional community. The employed method was semi-structured interviews with ten questions. A convenience sample was used to identify working groups composed of different professions, such as teachers, social workers and therapy assistants.

Background and purpose: Volleyball requires a lot of the human body, andeffective core stability is necessary for the athlete. Our muscles cooperate as achain of motions and core stabilization is the base for the moving muscles.The most well-known stabilization muscle is m.transversus abdominis (TrA).The purpose of the present study was to evaluate the function of TrA inSwedish female elite volleyball players and to observe the influence of eightweeks of stabilization exercise on the TrA. Method: 10 female elitevolleyball players (mean age 24,7 years, range 18-31 years) participated inthe study. TrA was measured in supine position with a pressure biofeedbackunit. Subjects were instructed to draw in the abdominal wall without movingthe pelvis and hold for 10 seconds.

This is a work that look at the factors that affect future monthly costs when buying a house in Sweden and which options are the most financially favorable over a 30 year period. The work also examines whether it is economically beneficial to invest in a low-energy house regardless of geographic location in Sweden, and discuss about whether a calculation template can help individuals to choose more environmentally friendly options. The work has been limited so that a certain number of predetermined factors and its measurable values have been developed with the help of a literature study. The factors chosen are building type, climate, heating systems, loan interest rates, energy prices, energy price increases, inflation rates and down payment. These are then combined into 72 different calculation cases which get put in a calculation model made in excel.

Due to higher standards of living around the world, greater industries and larger infrastructures causes an increase of the global energy consumption. This harvest of energy puts a great stress on the global environment. With this development, it becomes increasingly important to utilize energy resources in the best possible way.Fans are components that are often used in the industry and in households. A common problem is that the fan is oversized. An oversized fan causes an excessive flow, which has to be adjusted in order to achieve the correct flow.

Previous research has suggested that there is a strong and positive relationship between being an entrepreneur and possessing a high degree of subjective well-being as well as job satisfaction. The big five personality traits have also been argued to be significantly related to both subjective well-being and job satisfaction. Little is however known if personality affects entrepreneurs and regular employees differently. In this paper the impact of personality traits on the cognitive part of subjective well-being as well as job satisfaction are investigated separately among entrepreneurs and regular employees. This is done through OLS-regressions using a Swedish nationally representative survey Employment, Material Resources, and Political Preferences (EMRAPP), where entrepreneurs were oversampled in order to be able to compare entrepreneurs (N = 2483) and regular employees (N = 2642).

The need for snow-free surfaces at squares, bus stops, platforms, car parks and sports facilities increases and at the same time energy price rise and the environment is becoming a hotter issue. The construction of the ground heating systems often lack thermal insulation under the heating pipes, which means that the heat from the pipes not only warm up the soil surface but also heats the surrounding soil. The insulation also has more features, by insulating the risk of frost damage is minimized. The goal of this report is to demonstrate the large heat loss and energy costs in the absence of insulation under the heating system.The report begins with a scientific way to study and treating the soil heating system uses, and the theory involved. Furthermore it also deals with different routing principles of heat pipes depending on the facility.All calculations are made with so called finite element method (FEM), in COMSOL Multiphysics 3,5a, where models are created with different conditions.

The Kedertruss is the loadbearing part in the Keder weatherprotectionsystem and it has been analyzed concerning its loadbearing capacity. The Kedertruss is produced and manufactured by Wilhelm Layher GmbH & Co. KG and this report has been made for their Swedish division Layher AB.  The Kedertruss, designed in Germany according to German designcode, has been recalculated concerning Swedish conditions according to Eurocodes and a ongoing European standardization project. The two-dimensional program Winstatik Frame Analysis has been used for evaluation of load effects. Capacity has been calculated by hand-calculations and it has been verified that the Kedertruss in its larger spans isn?t able to withstand the loads.

The focus of this thesis is on what is considered to be a suitable foster home. For the study to be carried out an application had to be made to get access to the foster home assessments in a medium-sized municipality in Sweden. With the support of attachment theory and theory of standards different categories have been picked out and analyzed in foster home assessements that have been approved. The conclusion to what is considered to be a suitable foster home is a complex issue, as there are many factors that are interacting. Social workers seem to focus on the importance of a family?s ability to provide some kind of stability and security for a child who is considered to be placed within their home.

Title: Kvarteret Tvättstugan, an apartment building with massive wood construction. A thesis about acoustic and fire requirements and a comparison of energy and moisture aspects. Earlier restrictions in the Swedish legislation have resulted that only a small percentage of the apartment buildings that have been built are designed with a massive wood construction. It has been allowed to build unrestricted with wood since 1994 as long as the function of requirements are fulfilled. This change in the rules together with the great environmental benefits of wood has led to that more companies choose to build apartment buildings with wood. One of these companies is Folkhem Production AB.

The task given to us was to develop an industrial wheel with new thinking in terms of fresh design and construction, with the ability to brake. While the produced wheels of today only own the property of total braking, a wish was made to integrate the ability of directional locking.The time spent working with the project has been filled with multiple sketches of ideas and function analysis.Choices of material and ways of construction have been verified by calculations, tests and prototype building. The goal of this thesis has been to develop a unique caster with well thought-out design that would be adaptable to different areas of applications.The result was a hubless wheel with the ability of directional locking before total braking.A prototype of the wheel has been made to show the design and functions..

Problems with wild boars are increasing in Sweden and some people argue that the wild boar population must decrease. This is mostly the opinion by farmers, while the hunters want more wild boars in Sweden. Today the population is the strongest in the south of Sweden and in the eastern parts of the country. However the population is growing stronger in other parts of Sweden as well. The population origins from these areas where they escaped from pens around 1970.