Investment costs for eight different type housing systems for dairy cows has been calculated in order to compare the building costs as a function of herd size, shelter type and automatization. A commercial calculation programme for building was used and complemented with prices of equipments specific for dairy cow building. Herd sizes were 120, 250 and 400 cows. The milking equipments were automatic milking system (AMS), parallel parlour with 32 stalls (2x16) and rotary parlour with 24 stalls. Shelter was either insulated equipped with automatic cable driven scrapers on solid alleys, automatic feed wagon on rails, or uninsulated with manual manure handling and a tractor driven mobile mixer wagon on a drive-through feeding table. Building cost per cow or per kg milk was calculated using an average life time and 6 % interest rate and annual milk yield is 9 500 kg/cow and year. Structure effect 3-4 % higher for an insulated structure than in an uninsulated for 400 and 120 herd respectively. This is much lower compared to what is normally argued.

To design new and high tech products the engineers rely more and more on computer based simulations to investigate the properties and behavior for a component or system.To verify these computer based simulations the dynamic properties for the components of the drivetrain needs to be verified. Therefore measurements of the stiffness and vibrations for the rear axle has been performed. This report show how the measurements has been implemented and evaluated, along with some interesting results for the rear axles properties.The static stiffness for the drive shaft along with the axle-gear has been determined. It is found that the stiffness for the whole rear axle is near the stiffness for the drive shaft, which means that the drive shaft becomes the dominant component of the system and affects the rear axle stiffness the most. The measured stiffness of the driveshaft is close to its theoretical stiffness.The stiffness for solely the hypoid-gear have been calculated using the stiffness for the rear axle and driveshaft, and thus has a range for the stiffness of the hypoid gear been determined.The backlash for the whole rear axle and for some individual components has been determined, where the backlash between pinion and crown-wheel has negligible impact on the total backlash.Measurements of the crown-wheel and pinion movements have been conducted, where the direction of movement is consistent with the theoretical direction of the forces.The vibration measurements show that the vibrations are more severe at certain rotational speeds.

The purpose of this master's thesis is to study how librarians at public libraries make the literature with state supported distribution available through marketing. By qualitative interviews with nine heads of libraries the thesis examines how the library staff in each library market the state supported distribution by the Swedish Art Council. My theoretical framework is based on Philip Kotler's thesis on marketing. My conclusion is that the library staff rather market the library as whole, than focus on just one specific type of books. The attitudes toward the state supported distribution are a mixed one, but the library staff is glad for what is given..

erspective [80][upps-01.gif] This is a thesis on the Swedish Public Lending Right PLR, from a historical perspective. Some of the questions which are investigated in this thesis are: why did the State decide to introduce a PLR and why did it take about 20 years to make the decision? The question why the PLR was not introduced on a copyright basis is also discussed. The focus of this study is during the period of 1934-1956 and it is a literature-study. Mainly there are four reports made by different committees that have been examined.

Problem: Is the free cash flow a value relevant accounting measure in relation to the Swedish stock market?Objective: The aim is that by using an investment strategy to examine whether the free cash flow is an accounting measure that could be perceived as value relevant in relation to the Swedish stock market.Method: The paper is based on a quantitative survey of empirical evidence that has been collected from companies listed on the Large and Mid-Cap lists of the Swedish stock market.Theoretical Frame of reference: value relevance, cash flow, portfolio theory, drive theoryResults: It was concluded that the study results conform to the Finnish survey results. The portfolio shows higher returns than the OMX index..

The debate regarding the relationship between state sovereignty and the protection of the hu-man rights was at its peak during the 1990?s. Never again the world wanted to witness the atrocities committed in Rwanda, but at the same time some states argued in favor of a strict interpretation of the principle of state sovereignty and non-intervention. In 2001, ICISS was created ? a commission with the aim to find consensus in the question of how the world should respond to mass atrocities committed by a state against their own people.

This study shows the historical development of the forests in Hornsö and Ebbegärde state forest area in eastern Småland situated in southern Sweden..

Detta examensarbete reder ut arbetsprinciperna för olika typer av hårddiskskrivskydd; hårdvaruskrivskydd, mjukvaruskrivskydd, hybridskrivskydd och bygelskrivskydd. Slutsatsen av utredningen är att endast hårdvaruskrivskydd Detta examensarbete reder ut arbetsprinciperna för olika typer av hårddiskskrivskydd; hårdvaruskrivskydd, mjukvaruskrivskydd, hybridskrivskydd och bygelskrivskydd. Slutsatsen av utredningen är att endast hårdvaruskrivskydd bedöms ha tillräckligt pålitliga skyddsprinciper, vilket motiveras av dess oberoende från både hårdvara och operativsystem. Vidare undersöks hårdvaruskrivskyddet Image MASSter(TM) Drive Lock från Intelligent Computer Solutions (ICS). Några egentliga slutsatser gick inte dra av kretskonstruktionen, bortsett från att den är uppbyggd kring en FPGA (Xilinx Spartan-II, XC2S15) med tillhörande PROM (XC17S15APC).

This Masters Thesis considers tracking of ground targets. Since ground targets often are difficult to detect with sensors a track is easily lost in ground target tracking. The main question in this thesis is whether information on close targets and observations of them can be used to make the tracking more reliable. An algorithm using Kalman filters and JPDA-association to create a group track for vehicles travelling together has been implemented in Matlab. Using the state of the centre of the group the state of a vehicle in the group can be updated.

The means that the Swedish State has to legitimize and standardize different perspectives of women and their sexuality is significant. Persecution of gender and sexuality is today something that can grant refugee status according to the Swedish Aliens Act. By studying the documents that forestall the amendment of the laws is it possible to unveil the concept and ideas about women sexuality that the state manifests and reproduces through these laws and official documents.The aim of this essay is to look upon the sexual policy as it occurs in official the documents that deal with lesbian refugees. The study cover and maps present research on this group of women and gives an answer to how norms about women sexuality are expressed in these documents.Throughout the survey of the research field not much previous research was found, therefore even research that only partly covers the field is included and reviewed.As method a detailed reading of the official documents and a discourse analysis with it?s emphasize on theoretical themes like gender and sexuality, lesbianism and state feminism, was made.

Denna rapport jämför prestandan mellan state-of-the-art AI-botar i racing spelet TORCS och en AI-bot som kör med hjälp av ett artificiellt neuralt nätverk (ANN-bot). ANN-boten, som implementerades som en del av arbetet, använder en feedforward arkitektur och backpropagation för inlärning. Ett separat program som användes för att träna det neurala nätverket med träningdata som spelats in från TORCS implementerades också. Som state-of-the-art AI-botar användes AI-botar som har använts i en tävling. De fyra AI-botarna testades på åtta olika banor och data om hur lång tid varje varv tog och hur snabbt AI-botarna körde sparades och sammanställdes. Resultaten visar att på banorna som ANN-boten klarar av att köra runt så är ANN-boten snabbare än en den långsamaste state-of-the-art boten, men ANNboten klara inte av majoriteten av banorna som den testades på.

The purpose in this thesis is to explore the underlying conceptions concerningeuropeanization and public administration that Statskontoret is expressing in itspublications. Statskontoret is an agency in the service of the Swedish State whichprovides the Government and the Ministries with investigations and surveys. Themethodological choice in this thesis is to perform an idea analysis containing twoideal types which correspond with two polar theories, transnationalism andnation-state logic, concerning how a state will react on increasing european-ization. Initially, the theoretical framework is presented, and is followed by apresentation of the content in the relevant publications of Statskontoret. The idealtypes and the publications are examined from six different dimensions with theambition to explore the underlying conception in the publications.

The aim of this paper is to describe and explain how the separation between state and church effects the power relations between state and religious groups and organizations. Former state church, The Swedish church, is in this paper, not included in the definition of religious groups. The reform (?stat-kyrka reformen?) took place between 1995 and year 2000.I?m examining if religious groups had any influence on the reform. My expectation is to give a clearer picture of religious groups and its power position in Swedish politics and society.

This report reflects an examination work performed for Getrag All Wheel Drive AB during the spring of 2005. Among the companies range of products there exists some concern regarding the amount of clamping force and friction on bolted joints caused by the assembly torque.The aim of this project has been to determine if there is a simple way in which to identify and then practically apply testing methods for clamping force and friction through utilization of existing testing equipment.Three separate methods of clamping force and friction determination have been tested in rear drive unit, RDU, at a 30 Nm assembly torque. A fourth and final method, screw elongation with ultrasound, has been used as reference. The methods are:?Torque-Tension test.?Screw elongation with micrometer.?Joint stiffness test.?Screw elongation with ultra sound for reference.The results from tests can be viewed in table below.MethodTorque-TensionMicrometerCs=318 kN/mm Assembled with torque wrenchMicrometerCs=318 kN/mm Assembled on lineUltra-soundCS=311 kN/mm Ultra- soundCS=318 kN/mm Joint stiffnessTheoreticalClamping force-21,8 kN17,6 kN17,3 kN17,6 kN17,1 kN17,3 kNFriction-0,110,1470,1530,1470,1520,149.

The creation of Region Skåne, and the transfer of the development responsibility from the national administrative country board (Länsstyrelsen) has given the state new challenges. New structures have grown between Region and State, and also between different municipalities. These can be characterized as Policy-networks, and the goal of this study is to analyze the planning process of the regional infrastructure with these theories.This is a qualitative study of the infrastructure process in Skåne, and the actors that acts within this process. It has been studied with the eyes of the theories of Governance and Policy-networks. The main method to collect material has been through interviews with different actors within the process, and very little written material has been used.