Chapter 1 defines the aim of the project and gives a general orientation about ground heat extractors. In chapter 2 physical processes that could be expected to be involved in the heat transport around a ground heat exchanger are discussed. It is shown from a literature study what amount of moisture transport due to thermal gradients there could be expected in a ground heat exchanger. The conclusion is drawn that the moisture gradient (Sr) is of same magnitude as the driving temperature gradient (°C). At the expected amount of increased moisture around the pipes the moisture transport could be considered to have a little effect on the brine temperature.

I dagens läge har energifrågorna väckt ett stort intresse i samhället. Nu fokuseras det mer på att bygga energisnålare hus. En betydande faktor som påverkar energiförbrukningen i våra hus är köldbryggor. De uppstår då ett material med dålig värmeisolering bryter igenom ett material med bättre värmeisolering. Köldbryggor är nästan omöjligt att undvika, dock går alltid att reducera.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

The division of Engineering Materials at Linköping University, department of Management and Engineering, conducted a research project concerning Fatigue life of thermal barrier coatings during 2009. During this project equipment to provoke these fatigue failure by rapidly heating and cooling test subjects in cycles, was ordered.Design and manufacturing of the equipment was handled internally at LIU.The equipment was built using a furnace that is lowered and raised over the table where the test subject is placed. To keep the temperature of the furnace a lid slides in place to close the downward facing opening of the furnace when it is in the raised position. On this door there is nozzle that is used to cooling of the test subject by air.To make sure that the equipment can work independently you need an automation controller that can evaluate if movement can occur without danger of collisions. The control system also needs to monitor that all elements are performed according to plan.This degree project is based on a modular system from OPTO 22 and includes the configuration of a PLC that will be supplied with logic and a user interface.The degree project resulted in a graphic interface in which a user can set desired values for different parameters and get information about current values for them.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

The purpose is to understand the planning process for residential buildings and toinvestigate the consequences of the choices made in the process. The project will alsoprovide broader knowledge in the design and development under the current law andpractice.The goal is to present a proposal on how a city near the site where water can bedesigned from a sustainable perspective. How can a residential neighborhood be anenvironmentally sound and sustainable region? New systems and techniques havebeen presented previously in terms of sustainable environments and these are intendedof being used in the project Quarter Water-mirror.The project has been implemented on the computer program ArchiCAD in whichdrawings and visualizations have been carried out. These drawings are included asannexes to the report.For information, calculations and drawings, laws for physical planning and Swedishstandard have been followed.Residential buildings have been designed on a site, which is 2, 5 hectares.

It is found that the properties of the record years of 1965-1975 is leaking a lot of energy andthese properties are facing a major energy efficiency. From the energy aspect, the facade isafflicted with poor thermal insulation which is a big problem. To address this problem addinginsulation is a good alternative to reduce overall energy consumption of a building. Thewindows on these buildings are also a problem from the energy point of view. Therefore,there are many reasons considered for energy upgrading.

Climate change is expected to lead to increased rainfall and higher temperatures, among other things. This will have a major impact on our cities. Floods can lead to property damage as well as damages to human and animal health. Higher temperatures will increase the frequency of heat-related health risks and premature deaths. The consequences of climate change will be particularly large in our cities because of the city's morphology with a high amount of paved surfaces and buildings that affect the natural processes in areas such as drainage and absorption of solar radiation.

Ocean Thermal Energy Conversion, OTEC, a technology using the temperature difference between cold deep seawater and warm surface water, can extract the work in the form of electricity. OTEC gives also synergies of drinkable fresh water. The temperature difference has an impact on the efficiency of the technology, which means that the feasibility of OTEC is geographically limited. The project intends to explore the possibility of replacing the atoll Tarawa?s present electricity generation with an OTEC plant and to explore synergies. In the present situation all of Tarawa?s electricity is generated by fossil fuels.

Ocean Thermal Energy Conversion, OTEC, a technology using the temperature difference between cold deep seawater and warm surface water, can extract the work in the form of electricity. OTEC gives also synergies of drinkable fresh water. The temperature difference has an impact on the efficiency of the technology, which means that the feasibility of OTEC is geographically limited. The project intends to explore the possibility of replacing the atoll Tarawa?s present electricity generation with an OTEC plant and to explore synergies. In the present situation all of Tarawa?s electricity is generated by fossil fuels.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

The issue about how Scania shall perform HVAC tests in the climatic wind tunnel CD7, which Scania is about to complete by year 2013, has resulted in four test methods for truck HVAC and also a test method structure. The test methods have been chosen to focus on sun, snow and rain simulations. These are adapted and developed according to what should be tested and to what can be tested in CD7, which has been the object. With CD7 different climates can be simulated in a controlled environment for complete truck level, from desert with high sun load to arctic cold and snow.The test methods represents a basis to start from, for designers and test engineers which make the testing more repetitive as well as time eventually can be saved. Before the test methods can be applied they must be verified as they are based on theoretical and empirical assumptions.

As demand for renewable energy is increasing rapidly, the market for biomass pellets is expected to continue to grow in the near future. Most of the new raw materials that are discussed for pellet production have one thing in common; the production costs will increase compared to using traditional raw materials such as sawdust and planer shavings. The aim of this thesis is to investigate to what degree increased use of new raw materials for pellet production will affect the general pellet prices in Sweden and to survey what plans Swedish pellet producers have concerning new raw materials. To investigate the raw material situation of the Swedish pellet producers an industry survey was performed. Literature studies were also made on previous research in the subject field. Calculations of the production costs for pellets were done for the raw materials sawdust, wet sawmill chips and energy wood respectively. New raw materials are already used by the large-scale pellet producers in Sweden.

Sverige är idag i starkt beroende av importerade oljeprodukter för att driva de dagliga transporter som krävs för att samhället ska fungera. Kraftigt ökade priser på olja, eller en slopad internationell oljehandel skulle få ödesdigra konsekvenser för Sverige. Samtidigt är Jordens klimat i förändring, varmare temperaturer leder till smältande inlandsisar och detta till stor del på grund av världens oljeanvändning. Denna rapport behandlar de ekonomiska aspekterna kring biogastillverkning för ett Väster- och Norrbotten självförsörjande inom drivmedel för vägtransporter. Rapporten utreder huruvida denna självförsörjning skulle vara möjligt med avseende på tillgång utav råvaror för biogasanläggningarna.