I det här examensarbetet dimensioneras en solcellsanläggning med batteribank till fyra kolonistugor som kommer att vara bebodda under sommarhalvåret på Wij Trädgårdar i Ockelbo. Den förväntade elanvändningen beräknas för två olika brukarbeteenden. Ett brukarbeteende där hushållsapparater med höga effekter (exempelvis mikrovågsugn) förväntas ha kortare drifttider vilket resulterar i lägre krav på installerad solcellseffekt samt en mindre batteribank.För den kemiska energilagringen i en batteribank undersöks flera olika typer av uppladdningsbara batterier. AGM blyackumulatorn är det batteri som anses vara lämpligt för kemisk energilagring i solcellssystemet och som har använts vid dimensioneringen av batteribanken. Vidare undersöks möjligheterna att lagra elektricitet småskaligt genom pumpat vatten till ett vattenmagasin, som ett komplement till energilagringen i batteribanken.

This thesis has been performed at Uddeholms AB with the purpose to investigate theparameters affecting the formation of inclusions during the manufacturing of a low carbonmanganese-steel.A follow-up, steel and slag sampling and evaluations in microscope have been done for a totalof five heats.The results for each heat have been evaluated in relation to the theory from the literaturesurvey and suggestions for changes in the process to reduce the amount of inclusions whichhave a negative effect on the steel quality have been given.The project extends over a large process where many parameters affect the formation ofinclusions. However, a tendency that a higher addition of alloys seems to increase the totalamount of inclusions before and after the vacuum degassing is seen.The majority of the studied inclusions seem to approach the composition of the top slag aftervacuum degassing. Ladle glaze may cause the inclusions which had a different compositioncompared to that of the slag.A high or low ladleage together with a high argon flow during vacuum degassing seems todissolve particles from the refractory which later on get trapped inside the inclusions.The floatation for two heats has been studied where a short floatation seems to give a higheramount of inclusions in casted material.In machined material so called stringers were found. The main composition of those stringerswas pure alumina. Inclusions with a composition of pure alumina were not found in the liquidsteel, thus the pure alumina inclusions must be formed during the casting.

This study has been carried out in the spring of 2014 on behalf of PQR Consult AB in Stockholm. The aim of the study has been to analyse the energy usage of the building Skarpövägen 1 in order to explore the possibilites of saving energy by using appropriate equipment. These possible solutions have been simulated by using the programe IDA Indoor Climate and Energy, combined with a life cycle cost analysis. The laundry building, Skarövägen 23, has also been analysed due to its high amount of energy usage. The result of the energy analysis showed that the energy usage was much higher than the energy declaration.

The purpose of this work is to study a circulation project in Enköping municipality, where the society?s rest products are used to make beneficial products. In Enköping the rest products from waste treatment plants and private sewers are used to fertilize and irrigate Salix plantations that later are harvested and burned at the local combined heating and power plant, ENA Energy AB, to produce electricity and heat. Possibilities to apply this kind of project ona municipality in Russia are also explored.Guryevsk municipality in Kaliningrad region was chosen since there is a need to improve energy systems and reduce emissions to water and air. This municipality strives to become environmentally friendly.

AimThe purpose of this study is to investigate whether there is scientific evidence that exercise and/or manual therapy can improve function, in terms of increased mobility and strength on shoulder impingement-like symptoms among athletes. Another aim is to investigate whether these interventions can reduce shoulder pain.MethodA systematic review was conducted in the databases PubMed, CINAHL, PEDro and Amed. A total of thirteen articles were selected for further review and compilation. They were then graded for level of evidence according to the PEDro scale and the Swedish Council on Technology Assessment (SBU).ResultsThe systematic review shows that there is strong scientific evidence that acupuncture and heat can reduce pain in athletes diagnosed with supraspinatus-tendiopathy. There is limited scientific evidence that exercise increases strength, limited scientific evidence that stretching increases mobility and insufficient scientific evidence that a combination of treatments, with both exercise and stretching, reduces pain and increases function in overhead athletes.ConclusionsExercise and manual therapy can reduce pain and/or improve function in terms of increased mobility and strength in athletes with shoulder impingement-like symptoms.

Inom Radiostyrd Bilsport tävlas det med ett antal olika klasser som drivs av 2-taktsförbränningsmotorer. Dessa blir mycket varma och måste kylas av. Det sker med hjälp av enkylfläns som är monterad ovanpå förbränningsrummet, och som kyls av fartvinden.HP Hobbyprodukter har frågat oss om vi kan hjälpa dem att ta fram en egen kylfläns åt dem.Eftersom det ofta förekommer ovarsam behandling i tävlingssammanhang, är det ett krav attkylflänsens ska tåla detta. Den måste även avleda värme från förbränningsrummet, motorblocketoch övriga motorkomponenter effektivt. Ett önskemål är att kylflänsen ska ha ett unikt utseende,så att den är lätt att känna igen ute på banan.Arbetet har inriktat sig på prototypnivå.

To achieve a sustainable development, three aspects have to take equal place in the society; environmental, economical and social. To reduce the impact on the environment and the amount of greenhouse gases supplied to the atmosphere, industrialized countries and less developed countries must start cooperating. Also the use of renewable energy sources, like solar, hydro and wind power, have to increase.Wind power has great potential as a future energy supply. It is cost efficient, quickly developed and the resource is abundant and available worldwide.Examinations made in Sweden, indicates that there are difficulties establishing wind power at the same pace as the environmental goals, set by the Swedish government, requires. Mainly because people living nearby potential areas for wind power farms, appeal against the decision.This study aims to investigate differences between how people in Sweden and Brazil look at wind power as a future energy source and at the establishing process.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

Den senaste FN-rapporten som utfo?rdes av IPCC sa?tter punkt pa? faktumet att katastrofala klimatfo?ra?ndringar kan undvikas utan ma?rkbar inverka pa? levnadsstandarden. Det go?r fo?rnybar energi till den billigaste och minst riskabla va?gen till en fossilfri framtid. Detta motiverar intresset fo?r att underso?ka lo?nsamheten i solcellsanla?ggningar fo?r elna?tinmatning.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.

Med dagens växande besättningar är det svårare att upptäcka brunst hos mjölkkor genom visuell observation. Detta leder till ekonomiska förluster, minskat genetiskt framsteg, högre inkalvningsålder och längre kalvningsintervall. För att underlätta brunstregistrering i besättningarna finns olika automatiska registreringar som kan upptäcka fysiologiska eller beteendemässiga förändringar som framträder hos kon vid brunst. Denna litteraturstudie sammanställer tre olika principer för brunstdetektering; visuell brunstdetektering, stegräknare och bestigningsdetektor, som kan vara antingen elektronisk eller manuell. Resultatet visar att stegräknare är den metod som upptäcker flest brunstperioder medan visuell observation ger minst felaktigt detekterade brunstperioder.

The probiotic bacteria Lactobacillus reuteri DSM17938 was evaluated as a starter culture in cheese production, with the intention to produce a new interesting product within the functional food market. Growth and acidification rate in milk subjected to different heat treatments, as well as supplementation with growth promoting factors or support cultures was measured during controlled fermentations. The results showed that the weak proteolytic activity of L. reuteri could be compensated for by supplementation with 1% casamino acids or 5% MRS broth. Furthermore, a decrease in growth and acidification rate could be seen when using yoghurt culture or Lactobacillus delbrueckii as adjunct cultures.

Recent turmoil surrounding nuclear power as an energy source, especially since the accidentat Fukushima, has largely contributed to the debate of whether or not nuclear power should beused as an energy source. This study has examined the economic feasibility of replacingForsmark?s 3rd nuclear reactor with a bio fueled power plant, and find out how this could bedone.The power generation that has to be replaced is equal to 1170 MWe. To replace this, 6 largescaleCFB-boilers, each providing over 200 MWe, were necessary. In addition to this, eachboiler required their respective turbine sets, comprising one high-pressure-, and one lowpressureturbine with intermediate reheating capacities.Based on this, a rankine-cycle was modeled using the software EES, to be able to calculatethe total heat required in the power plant.

The purpose of this degree-project was to investigate the possibilities for primary air preheating into the two smallest waste incineration boilers of Halmstad Energy and Environment. The investigation is a pre-study which has the primary goal to evaluate technical and financial offers from companies that manufacture primary air preheater, and investigate if it is technically and financially profitable to do a purchase on primary air preheaters in the future.In the pre-study it is proposed that it is most efficient to have individual primary air preheater, one for each incineration boiler and the primary air are also proposed to be preheated by hot water in the pre-study. Further in the pre-study it is proposed that the heat-exchanger should have plain tubes instead of finned tubes, to avoid getting dirty fast. The space in the boiler-room is limited, and therefore the major problem was to fit in the primary air preheaters into the boiler-room. By comparing the different offers from the companies, the result in the pre-study shows that the offer from the company C.A.