In this bachelor thesis a complete prototype of an industrial vibration measurement platform has been developed. By measuring a number of variables such as acceleration, temperature and speed conclusions can be drawn on machinery health. The aim is to evaluate hardware and software solutions for a possible future product. Based on a requirement specification a proper hardware design has be developed. The hardware consists of a four-layer PCB with an ARM Cortex-M3 microcontroller and about 250 other components. The PCB was designed, assembled, tested and finally housed in a box.

There is considerable variation between stallions in semen quality and fertility due to the fact that selection of stallions for breeding is not based on fertility or semen quality but on performance. The increasing use of cooled semen for artificial insemination has resulted in decreasing pregnancy rates. Therefore the equine breeding industry needs new methods for evaluation and development of sperm quality and fertility. This study is a part of such a project and is performed by SLU in cooperation with Flyinge AB. Ten stallions at the Flyinge National Stud were used in the study and three ejaculates were collected from each stallion.

Arktis är den plats där den globala uppvärmningen är som mest märkbar på hela jorden (Arktiska rådet). Därför är Arktis ett intressant område att studera ur klimatsynpunkt. Enligt Gore (2006) så kan en ökning av jordens medeltemperatur på 1,5 °C leda till att de ekvatoriala områdena får en temperaturökning på 0,5 °C medan temperaturen vid Arktis kan stiga med hela 6 °C. De senaste 30 åren har medeltemperaturen vid Arktis stigit med drygt en grad per decennium (Anisimov, 2007) medan den globala medeltemperaturen för samma period endast stigit med ca 0.15 grader per decennium.Arktis tros ha varit isfritt under en värmeperiod för ca 6000 ? 8500 år sedan (Founder, 2011) men det som är unikt med den aktuella situationen är att avsmältningen går så snabbt.

It has been shown that moose can affect plant community composition and structure. Selective browsing with other damages of large herbivores on tree species with different tolerance to disturbance could reshape the tree layer in both managed and natural forests. Rowan Sorbus aucuparia is widely distributed throughout Sweden and Europe. Research has shown that browsing by moose may prevent rowan from reaching browsing safe heights. The goal has been formulated that, where rowan is indigenous, it should have a good competition status and be able to reach tree level.

Glulam is a product that was engineered to make use of timber in a more efficient way. Bychoosing timber of similar quality and discarding natural defects during production, thedevelopment of a stronger cross-section is achieved.Carbon fiber is a relatively new material with a high tension capacity. This feature is used toexamine how the bending capacity of the beams improve by adhering carbon fiber laminateson the lower edge of the beamsThe strength of the material is tested with three experiments: carbon fiber on the bottom of thebeam (a), carbon fiber attached to the lower sides of the beam (b) and carbon fiber in thebeam, covered with a layer of wood (c)The results show that the first case, where the carbon fiber is attached to the bottom of thebeam, gave the best result with an increase in capacity of 59 % compared to the nonreinforcedcontrol. The other two cases also show an improvement in capacity, beam-type 3had a capacity increase of 47% and beam-type 4 increased with 25 %Tests were also made with glulam beams reinforced with fiberglass, but these tests were notanalyzed in depth because the purpose was to compare the capacity to carbon fiber. Thisbeam improved its capacity by 40.3%.The tests show that carbon fiber as a reinforcement material for glulam is a good choice whenthere is a requirement for stronger cross-sections in both new production and renovation ofold buildings.

Svenskt Rockarkiv is an organization located in Hultsfred, Sweden. Its goal is to collect and document the history of Swedish rock music. The archive contains several types of documentation, such as audio recordings, photographs, posters, video recordings and books representing Swedish rock music history. In order to store information about the audio recordings in the archive, Svenskt Rockarkiv uses a SQL Server 2000 database and a client application written in Microsoft.NET C# and Windows Forms. The purpose of this degree project is to audit the database and windows client, since the organization has needs of new functionality.

Sweden?s most trusted news distributor, Sveriges Radio (Swedish Public Service radio broadcaster), has high ambitions with the journalism it broadcasts ? especially when it comes to gender equality and diversity. This thesis examines how gender is constructed in Dagens Eko (Today?s Echo) to find if and how power structures are expressed language-wise. Queer theory is used to look at how gender is constructed and how one can look at, and question, gender and gender hierarchies.

E-business innebär att företag använder Internetteknologier eller nätverksteknologier för att skapa större affärsnytta i deras affärsprocesser. För att kunna genomföra automatiserade affärsprocesser krävs att de olika system som används är interoperabla, d v s kan kommunicera och fungera ihop på ett effektivt sätt. Målet med Web Services är att skapa hög interoperabilitet, vilket gör denna teknik lämplig för e-business. Företag kan specialicera sig på att skapa specifika Web Services. Dessa Web Services kan sedan vara byggstenar åt andra företags tjänster.

The present study concerns a concept development of a product idea that Bengt Magnuson, associate professor, had when a heavy storm caused a widespread power failure of long duration. With a basic power-producing unit one should be able to get through a power loss. The product could also be useful for other tasks if different modules are connected, e g grass mower or snow-blower.According to the product idea the basic unit will be able to produce electric power enough for a fridge, freezer, TV, and a few electric lamps. Normally the basic unit can be used e g as a mower, when such a module is attached. An increased number of tasks would make the contraption useful and tempting for those who do not own an electrical power set in reserve.

The purpose of this paper was to analyze fishbones from the Pitted Ware Culture settlement named Hemmor. in Dalbo, När parish on Gotland. The fishbones are unburnt and derive from one specific culture layer (c:6) in trench one VI:7, and radiocarbon dated to 2600-2300 BC cal.In this paper I wanted to answer these following questions:1. What kind of fish species did they eat in Hemmor?2.

The purpose of the present study was to examine effects of driver, vehicle, and environment characteristics on Collision Warning System (CWS) design. One hypothesis was made that the capability of collision avoidance would not be same among a driver, vehicle, and environment group with different characteristics. Accident analysis and quantitative analysis was used to examine this hypothesis in terms of ?risk? and ?safety margin? respectively. Rear-end collision had a stronger focus in the present study.

Democracy has been a part of the Swedish society for a long period of time and it is also a part of the Swedish elementary school curriculum, in which you can find a number of statements that expresses that the Swedish elementary school should socialize the children into becoming role model citizens. This also conjures with the available research that describes schools in general as socializing. This led me to a question that hasn?t been answered: How much of the curriculums reasons for socialization the pupils are based on democratic values and how much of it can be dated back to events prior to the curriculum?The methodological approach is an analysis of ideologies as described by Sven-Eric Liedman and Ingemar Nilsson in Ideologi och ideologianalys. The text is focusing on the fact that a text has two layers; one is the manifest which is roughly the same as explicit or present in the text.

When constructing a building, a number of aspects must be harmonized in order for it to fulfill requirements ? a building must fulfill requirements such a load-bearing, conservation of energy and a good indoor environment by means of, among other things, moisture proofing .Moisture problems in buildings can affect health negatively. As we are increasingly staying in indoors, demands on a good indoor environment are higher.This work starts with examining moisture problems in slab-on-ground solutions, and then links the various scenarios to moisture problems in a concrete slab of a real building. The building with moisture problems is located in Årby by in Borlänge and moisture damage was found in the slab at an apartment adjoining wall.By reviewing literature written within the field of moisture problem, making hand calculations and modeling in the program Comsol Multiphysics, judgments are made to find explanations as to why the rise of moisture occurred in the building in Årby by.Generally, the following guidelines may be used to reduce the risk of moisture problems in slab-on-ground constructions:Drying of construction moisture before laying the floor material.Using draining layer beneath the slab, to prevent capillary suction.Using insulation under the slab, partly for comfort and to establish the temperature difference between the ground and the concrete slab.Avoid direct contact between the wood and concrete, due to degradation and fouling smells that normally occurs.If necessary, use additional vapor barrier.In addition to the above, there are various methods for moisture-proof and moisture-monitoring by design or by the method ByggaF suited for the entire construction process various events..

The aim of this study was to map the prevalence of aeolian sand dunes in Västerbotten, northern Sweden to find dunes formed during earlier deglaciation phases, which was then preserved in cold-based conditions during the youngest stadial of the Weichselian glaciation. These preserved dunes were expected to be covered by a layer of till and have a rather faint morphology compared to dunes formed during the Holocene. Consequently, high resolution LIDAR-derived images from the Swedish mapping, cadastral and land registration authority (Lantmäteriet) was used to detect the dunes throughout an area covering most of Västerbotten, above the highest coastline and below the mountain range. The analysis resulted in several new findings of aeolian dunes compared to the findings in the quaternary soil map created by the Geological Survey of Sweden. Despite the fact some of the dunes at the LIDAR-derived image had a strange faint appearance, it was quickly evident during the fieldwork that the aeolian sand was not covered by till on any of the dunes visited.

This report deals with prefabricated bathrooms and the advantage, during the production process, they have compared to ordinary produced bathrooms.The work is done together with the building company JM. The common task is to investigate if the manufactures, in spite of standardized design can meet the concept of JM, i.e. high flexibility and adjustment towards the customer. In JM they are doubtful to the method, as they did not yet worked with prefabricated modules and think that the choises for the costumer will be limited.There will be a short resume of the progress of the bathrooms and its importance as sanitary and wellbeing.The recent problems with damage caused by damp in bathrooms. Have resultade in regulations.