The project contains a force analysis of the vertical axis wind turbine Lucia's supporting arms and a measuring device to experimentally measure the forces is made. The forces between the supporting arms and the tower are calculated theoretically and then simulated by a computere. A measuring devise is then designed to measure the forces experimentally. The forces acting on the attachment between the supporting arms and the tower is primarily the centripetal force, gravitational force and the aerodynamic forces on the rotor wings. The maximum forces were theoretically calculated and is 13.38 kN along the x-axis, -0.25 kN along the y-axis and then 0.5 kN along the z-axis.

AbstractIn urban societies people spend more and more time indoors, which put great demands on the indoor environment. If the ventilation is to manage the removal of unwanted substances in the indoor air, a good mixing of the air is required. The question arises that, whether the buoyancy forces will counteract a good mixing of the indoor air or not?This report aims to clear up the difficulties whether you need to consider the buoyancy forces or not, when adjusting a ventilation unit. For studying the indoor mixing of the air a two dimensional model is constructed in COMSOL Multiphysics.

The jetengines of today are growing in complexity. Reliability for aircraft engines are of extreme importance, mainly due to safety reasons but also economical ones. This master thesis deals with faultdiagnosis in the turbine section of RM12, the engine used in Saab/BAe's Gripen. Three different faults which can occur in the turbine section was studied. These faults are: clogged fuel nozzle, hole in outlet guide vane and sensor fault.

Traditions are something that is very important to many people, Christmas is usually no exception. Christmas tree, Christmas ham, herring and candle lights are just as important as the advent candlestick. The advent candlestick help you get the Christmas feeling during the countdown. In this report the work with a new advent candlestick concept can be followed step by step.A lot of information was needed in the beginning. By doing some research, surveys and interviews the ground was established for further work.

One of the most important components of a harvester is the crane. Most harvester cranes are only possible to pivot (or horizontally rotate) at the crane pillar. Cranab in Vindeln, Sweden, has developed a new type of harvester crane which has an extra pivot point on the outer boom. This makes it possible to reach around residual trees, easing thinning work in dense stands. The aim of the study was to analyze if the use of a pivoting outer boom (POB) crane gave an increase in thinning production and if there were any differences in time consumption between the work elements for the POB crane and a conventional crane. A Valmet 911.3 equipped with a POB crane was used in the study.

In Sweden there are about 4 million hectares of bare peat (mire). This land has great potential to be transformed into productive forest land, provided drainage is carried out and, in some cases, even fertilization with ashes. Drainage of mires is necessary because the high groundwater table prevents trees from growing due to reduced oxygen availability. Some of the key nutrients that trees need to grow appear in too small quantities in mires, especially potassium (K) and phosphorus (P). Ash from the combustion of biomass contains these elements and is therefore suitable as a fertilizer.

The aim of the study was to investigate if the Grazemore Decision Support System (DSS) is able to provide a grazing management strategy that gives a high utilisation of grazed grass in milk production in the north of Scandinavia. To do this, a grazing experiment was planed and performed during the summer 2005. Simulations in the DSS were run to get a suggestion of how the cows should graze, grazing calendar 1. Deviations and updates during the season resulted in the simulated grazing calendar 2. During the experiment, the actual milk yield was recorded twice weekly. The difference between actual and predicted milk yield by Grazemore DSS was analysed statistically with regression analysis and the mean square prediction error (MSPE) was estimated.

This thesis work has been performed at the department of diagnosis and dependability at Volvo Car Company, Torslanda. The background of this project is based on interest in ascertaining how different factors possibly can affect a diagnosis method, which has been developed to find leaks in the fuel tank and evaporation system. According to the OBD II requirements leaks with an orifice diameter larger or equal to 0,5 mm, must be detected. The idea of the diagnosis method is to create an over pressure in the system with an air-pump. The current through the pump is measured and correlates to the power consumed by the pump.

The discharge from Lake Mälaren is regulated to keep the lake water level within limits set by a water decree. Despite this, in the year 2000 the lake water level rose above the upper limit. Studies conducted at the climate modeling unit Rossby Centre at the Swedish Meteorological and Hydrological Institute (SMHI) indicate that the inflow to the lake may increase in the future. A flood in the area will, among other things, strike infrastructure and residential districts.The aim of this study was to investigate the water levels of Lake Mälaren in future climates. In addition to this possible future expansion of the lake discharge though the sluice gates in order to keep water levels below limits set by the water decree and to prevent flooding of the shoreline were discussed.

The purpose of this project was to evaluate how energy efficiently some of JM?s residential buildings can become in standard production. What kind of measures are needed to achieve the level of energy demand that is included in BBR12 (Boverkets Byggregler)? What measures are needed for achieving a lower demand so that the buildings could be classified as passive houses? The investigation has included a single family house and two different types of apartment blocks.The simulation programs Enorm and VIP+ have been used to calculate the energy demand of the buildings. The results from the programs have been compared with the measured energy demand for the three buildings.

This thesis project has been written and accomplished in cooperation with HABO AB. The objective of the project was to develop a standard stated packaging system. The background to this is that HABO is not pleased with the system currently in use. The system which HABO is currently using consists of to many sizes. The largest benefit of a standard stated system is that it becomes much easier to organize the packaging with the aid of a computer program.

Bakgrund: Cirka tre till fyra procent av alla barn ligger i sätesbjudning vid fullgången graviditet. Med alltmer antal lyckade vändningsförsök och ökat antal kejsarsnitt minskar antalet barn som förlöses vaginalt vid sätesbjudning. Det påverkar barnmorskors och obstetrikers möjlighet att upprätthålla kompetensen vid sätesbjudning. Syfte: Syftet med studien var att beskriva barnmorskors synpunkter om vaginal sätesförlossning. Metod: Öppna frågor vid intervjuer med fem förlossningsbarnmorskor i Göteborg.

Based on laboratory studies with lysimeters, the concentrations of dissolved reactive phosphorus(DRP) and particulate phosphorus, which is the main part of other P (OVRP), has been studied inpercolating water. The experiment was conducted through irrigation of small soil columnscontaining clay topsoil from an experimental field in Västergötland. Three rain simulations wereconsecutively performed. DRP concentrations in the percolating water ranged between 0.2 - 0.3mg·Lclearly related to the phosphorus concentration in the soil, measured in a soil extract ofammonium lactate (P-AL). Concentrations of OVRP were relatively low and ranged between0.12 and 0.16 mg·Lwas not proven and the experiment may reflect how a relatively slow percolation of water mayrelease DRP.

In the early 80s, several new synthetic materials have come to be used in the treatment of canvaspaintings, among them Plextol D 360, Plexisol P 550 and Beva 371. Today, many conservatorsfind the information about the long term sustainability of these binding mediums to beincomplete. Evaluation of synthetic materials is mostly done through clinical research, sometimesartificial aging is simulated. The correlation between artificial and natural aging is however notestablished, useful information can therefore be gained through evaluations of actualconservation treatments. The intention of this study is to find out more about how thementioned products perform over time in normal museum conditions.

Flooding events are no longer rare, floods occur all over the world. Accordingly, it is vital for the society and different authorities to work with flood mapping. To meet the goal of Uppsala kommun to map the risks of floods in Uppsala län, a map of the different areas around Funboån which are inside the area of risk for flooding have been developed.In the work, cross sections and the water flow have been measured. Moreover, an echo-sounding have been carried out in Funboån to map the bottom topography. From the bottom map and laser scanned data covering the study area, a terrain model was created.