Works on transparent paper, also commonly known as tracing paper, have been described as ephemeral or temporary working documents and they usually number large quantities in archival and museum collections. They have therefore previously been considered of lower priority and can be found in poor condition due to a lack of treatment or suitable storage prospects. In addition, transparent paper can be very sensitive to moisture and reacts by deformation or loss of transparency. Due to the volume of these works and the necessity of treatment, there is a call for simple and efficient conservation methods. A common solution in archives for the treatment of water-sensitive works on paper has been the use of heat-activated tissues as they can be applied without the introduction of solvents. There is little published about the use of heat-activated tissues on transparent paper and is mentioned only briefly in existing literature.

A patient simulator for testing anaesthesia machines has been developed at Maquet Critical Care AB, to reduce costly and time-consuming experiments on animals. The device simulates human lungs regarding lung dynamics and volume, uptake of anaesthetic agents and the production of carbon dioxide, heat and moisture. Further demands on the simulator are durability and size; the device shall be compact enough to be moveable.The resulting simulator fulfils the requirements and enables better repeatability and ability to test extreme cases than experiments on animals do.Uptake of the anaesthetic agent is achieved in a active carbon filter and controlled by regulating the flow. The flow is created by a regenerative blower and controlled using a proportional valve. The uptake can be set by the user or by a simple uptake model modified to recursively handle changes in the concentration of anaesthetic agent.Carbon dioxide is fed into the system from a tank by a mass flow regulator.

This master thesis was written for Arla Foods and the result of the thesisserves to gain Arla Foods in its work with chemical hazardous and to bringnew academic results. The thesis aims to create a common methodology forrisk analysis with the handling of chemicals.The theories displayed in this thesis focuses on different risk managementmethods in order to build up a framework out of which a risk management toolwas created. The main primary data source consists of interviews held withemployees within Arla Foods at different facilities.The risk management tool can be found in appendix K.Available recommendations for how to evaluate risks with chemicals can befound at appropriate government agencies. These recommendations aredrawn up to suite small and medium enterprises and therefore are to narrowto make a good foundation for analysing chemical risks at large companies.With the legislation and government demands in mind, a tool has beencreated to fit a large company?s needs when managing chemical risks.

This study evaluates the retention of nitrogen and phosphorus in four newly constructed wetlands in the municipality of Falkenberg, Sweden. The four wetlands have been selected because they have been specifically constructed with the aim to reduce nitrogen and phosphorus in farming areas. The process of selecting the specific wetlands has been done in collaboration with the county administration in Halland. Through field studies in collaboration with the landowners where the wetlands are sited, the areas that provide the wetlands with water were determined. The size of these drainage areas were determined in a GIS computer program. The type of land use within the drainage areas was also determined.

This degree project is based on identifying and allocation of costs in a packaging section at Electrolux Distriparts in Torsvik.The purpose of this thesis is to identify the costs that emerge when packaging different articles and show how the costs are allocated. The report also contains improvement suggestions about how the company can use the current computer system more efficient.The methods that have been used in order to approach the problem and the collection of information have mainly been literature study, interviews and observation.The work started with answering the questions; which expenditure cost and direct cost exist in the section, how can they be allocated, if improvement can be done and how the flow of information is supposed to happen.In order to answer the questions we used our former experience and the knowledge we achieved by reading literature, interview relevant persons in the company and observations carried out in the section.Through our studies, we came up with an Excel file, which is the groundwork for a template that can be used by the company in different occasions depending on the situation and need. It is important to remember to modify the template if the presumptions change. In the template, we have identified the different kind of costs that emerge when packaging different articles and we have also allocated the costs. In addition formulas and estimations that are necessary for the cost calculation are presented.The work consisted in making the groundwork for a template.

Use of computers and computer networks is nowadays a part of everyday life. You do not use them only at home when you sit at you computer, but you can use them all the time everywhere. This can involve everything from surf to any website when you are at home, to checking your email on your mobile when you are on your way to work. Most people do not think about how it really works when they try to access a web page by typing the address into their browser, but something that most people probably notice is how long it can sometimes take to access a web page.All items which are directly connected to the IP network have a unique IP address that is used to make it possible to communicate. The IP address is either a period separated sequence of digits representing 32 bits or a colon separated sequence of digits representing 128 bits, depending on whether the address is an IPv4 or IPv6 address.

This thesis has two purposes: (1) to analyze the emptiness in Blodbok by Christine Falkenland, and (2) to analyze my own reading of the same book. I have chosen to focus on how emptiness is expressed through the body, the language and the place in Blodbok, because of the deep impact these seem to have on the emptiness. The thesis discusses what kind of emptiness that is described, what it does to me as a reader, and how it is connected to other works by Falkenland. Cultural politics of emotions by Sara Ahmed, Uses of literature by Rita Felski and Pouvoirs de l?horreur by Julia Kristeva together form the theoretical framework.Blodbok is a poetry collection, about the loss of a mother.

Syfte och frågeställningarSyftet med studien är att undersöka och jämföra hur klassrumsundervisning bedrivs i två svenska och två finska skolor för att finna möjliga förklaringar till PISA-undersökningens resultat (Programme for International Student Assessment). Syftet besvaras med hjälp av följande frågeställning: Hur och till vad utnyttjas lektionstiden till? Hur upplevs det allmänna klassrumsklimatet? Hur ser ledarskapet i klassrummet ut?MetodDe metoder som använts i studien är löpande och på förhand kategoriserade observationer och kvalitativa intervjuer. Totalt har 24 klassrumsobservationer, tio lärarintervjuer och två intervjuer med rektorer genomförts vid två högstadieskolor i Storstockholm och vid två högstadieskolor i Helsingfors. Det som observerades var; lektionsinnehållet och tiden lagd på olika moment, elevernas självständighet, det disciplinära klimatet och relationen mellan lärare och elev samt klassrumsklimatet.

This master thesis was written for Arla Foods and the result of the thesisserves to gain Arla Foods in its work with chemical hazardous and to bringnew academic results. The thesis aims to create a common methodology forrisk analysis with the handling of chemicals.The theories displayed in this thesis focuses on different risk managementmethods in order to build up a framework out of which a risk management toolwas created. The main primary data source consists of interviews held withemployees within Arla Foods at different facilities.The risk management tool can be found in appendix K.Available recommendations for how to evaluate risks with chemicals can befound at appropriate government agencies. These recommendations aredrawn up to suite small and medium enterprises and therefore are to narrowto make a good foundation for analysing chemical risks at large companies.With the legislation and government demands in mind, a tool has beencreated to fit a large company?s needs when managing chemical risks.

Diabetes mellitus is a rising epidemic throughout the world and there is currently great interest in quantifying the beta-cell mass (BCM) in vivo non-invasively. In the present experiment, the feasibility of in vivo imaging of the glucagon-like peptide-1 receptor (GLP-1R) in beta-cells was examined, using the positron emission tomography (PET) tracer [68Ga]Ga-DO3A-VS-Cys40-exendin-4 as a marker, in native pancreatic beta-cells of a porcine diabetic animal model and healthy controls. Eight Swedish high-health domestic pigs were randomly assigned to be either controls or made diabetic using streptozotocin (STZ). The experiment proceeded during eight weeks, starting with an acclimatisation period. Once the pigs had been socialised they underwent surgery for the insertion of a jugular vein catheter, allowing induction of diabetes with STZ, intravenous (i.v.) injections and stress-free blood sampling. Development of diabetes was confirmed by clinical examinations, blood glucose values and insulin-staining of pancreatic sections post mortem. The diabetic pigs were insulin treated and responded well.

- To be trapped in a roller-coaster That ?s how some of the patients are describing the situa- tion of living with heart failure. To be stuck in their home not knowing if they will have to seek care today and not knowing if they will have the energy to attend that birth- day party later this week.Each year 2-3% of the Swedish population are diagnosed with heart failure, which results in 30,000 new individu- als with the disorder. Cardiovascular disease is rapidly in- creasing in the world and before 2030, people with heart failure will increased by 100%. Our improved living condi- tions and better health have allowed us to grow older and made us more dependent on other types of care, care at home.Today the patients are only looking for changes in weight and if they have excessive water in their body.

A problem in the field of district heating is the oil burners needed to provide power when a peak load occurs. One possible way of reducing the needed amount of oil is to reduce the power demand for space heating in the district-heating substations when the need for district heating water exceeds a certain limit. This can be done by use of a locally working controller function.In this Thesis the options concerning load priority are evaluated. To evaluate the potential for using controller functions concerning peak load priority an experiment was brought out in a chosen district-heating substation. The impact on the indoor thermal comfort during a heat reduction was also taken into account.

As a consequence of increasing wind power installations in the Nordic grid the last years, the need for regulating power has become larger. In the Nordic grid, regulating power is mainly provided by hydro power. One part of the regulating power is called frequency control, which ensures that the grid frequency is stable and close to 50 Hz.However, setting the turbine into frequency controlled operation may cause stress and wear of the components in the mechanical control system. Frequency controlling implies large and frequent servo forces and longer travelling distance of the sliding bearings in the Kaplan turbine.Based on one selected Kaplan turbine, Selsfors G1, measurements and MATLAB calculations have been performed in order to determine forces and movements of the linkage system. With these forces and movements as input, stresses and fatigue have been determined as well as sliding distances, bearing pressures and wear of bearings during a typical lifetime of 40 years.The results indicate that no severe wear exists on the bearings during 40 years of service.

The prevailing food and energy crisis of the world, due to the declining reserves of fossil energy and a never ending rise of consumption, forces us to look into new fields to supply our energy demand. The boom of bio energy is criticized, as food crops are used to provide biodiesel and ethanol and the volumes are ridiculously small to supply world demand. Algae are one of the world?s oldest life forms and exist in many different phyla, providing a great variety to choose from, for different purposes. Cultivating microalgae offer a way to produce energy at great volumes without competing with food production and at the same time the algae offer a way to use our expensive nutrients in a more efficient way, besides this the algae are carbon dioxide neutral since their carbon source can be supplied by the atmosphere and the additional energy required can be supplied by algal oil or other renewable sources.

The eutrophication of lakes and seas with the algal bloom and deficiency inoxygen that follow, has been given priority by the Swedish government as oneof 16 environmental objectives. The purpose of this project was to develop a toolbased on a simple model, limited amount of data and geographic informationsystem (GIS) to identify areas with risk for phosphorus losses due to surfacerunoff. This tool can act as a decision support to decide where appropriatemeasures should be applied with the aim of reducing phosphorus losses and bythat the eutrophication.The method that has been used is a combination of two models, one calculatingthe potential erosion while the other one identifies areas of erosion (net erosion)or deposition. This ability is of great importance because potential erosionshould be calculated on areas with net erosion. Areas with high potential erosionhave an increased risk for phosphorus losses due to surface runoff.The potential erosion was calculated based on factors which describe how topography(LS), land use (C), soil type (K) and precipitation (R) effect the erosion.All of them have been modified to a greater or lesser extent.