Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

The importance of energy- and environmental issues has increased, and the work towards reducing carbon dioxide emissions plays a major part. The European Union has set up goals for the membership countries to work towards this to happen. The carbon dioxide emissions in Sweden have been reduced the last few years, but there is still a lot to do. About 30 per cent of Sweden?s carbon dioxide emissions generate from energy usage related to housing, this is why the housing sector is of interest to examine.

Municipalities in Sweden are responsible for physical planning by developing a general plan. This plan contains intended land and water use for the area. This study aims to investigate the level of integra­tion of environmental issues in the general plan of Arboga municipality and also how well adapted the municipality is for climate change. Further on, the study intends to examine the focus of the gen­eral plan and at what rate the national environmental strategies are implemented in the local physi­cal planning of Arboga municipality. Methods used for this study are interviews and reviewing of the general plan itself and other key documents.

This thesis aims to present the essential background on how to perform climate changeimpact assessments, and to present the results from a climate impact assessment on waterbalance and nitrate leaching for an arable Swedish soil. The soil is a sandy soil in southwesternSweden, grown with spring cereals. This study is meant to be a benchmark example,and cannot be seen as a regional or national assessment for Sweden, rather as an approachto present and analyze the most important parts of these kinds of assessments.A dynamical simulation model (COUP, Jansson and Karlberg, 2004) was used for thisstudy. The model was parameterized and calibrated against data from an experimental site,located in Mellby in Hallands county, south western Sweden. Measurements were carriedout between 1st of April 1988 and 1st of April 1991.

This work is a part of the project ?Våtmarker i odlingslandskapet ? uppföljning av miljömålen? (Wetlands in arable land ? following-up of the environmental goals). The main objective with this project is to study nitrogen and phosphorus retention in a constructed wetland by using mass balance calculations. Continuous measurements of nutrients and water flow through the inlet and the outlet of the wetland are made. However, substantial amounts of nitrogen and phosphorus were assumed to reach the wetland with a drain-pipe transporting wastewater from nearby houses (10 persons).

The energy sector is facing an impending paradigm shift. Today?s technology enables the end-user to generate their own energy locally at home. Furthermore, recently developed storage technologies make it possible to balance energy demand with stored energy and integrate district heating with the local power grid. This means that in the future heat and electric power will interact and energy flows is converted over energy boundaries.

The interest for power and energy measurement has greatly raised with todays increasing electricity prices and enviromental awareness. In the search for energy efficient solutions, the measurements are more complex due to increasing of non linear components. Harmonics and non sinusoidal voltages put high demands on sampling and filtering. Meanwhile, the price must be controlled so the customer still will find it interesting to invest in smaller plants. ITT W&WW asks for a robust, heat resistant power meter with compact dimensions to allow mounting inside the casing of a pump.

The focus of this project was to characterize the occurrence of ESBL-­?producing bacteria in two irrigation water ponds in Southern Sweden. Samples were taken from two ponds nearby each other, from which analyses were made based on levels of community and individual isolates. Community samples were used for attempts for characterization of resistance patterns in irrigation water using the Omnilog PM-­?plate system. The growth of community microbiota in the presence of the following antibiotic substances was assessed; amikacin, gentamicin, kanamycin, penicillin G, ampicillin, piperacillin, trimethoprim, potassium tellurite and ciprofloxacin. Isolates were pure cultured using semi-­?selective media: LB, Rainbow Agar, mEnterococcus, 0.1 TSA and VRBD. A total of 177 isolates were isolated randomly. Each isolate was identified using the Omnilog GENIII-­?system of biochemical characterization. Further, the isolates were tested on Brilliance ESBL-­?agar for their ability to grow. Out of the total number of isolates, 30 were selected, preferably Enterobacteriaceae or Pseudomonas spp., based on their high similarity to library strain during the identification in the Omnilog-­?system. These were further characterized using Etest-­?sticks. Three selected strains were picked for further analyses using exogenous isolation for attempts to simulate horizontal gene transfer, and Omnilog PM-­?panels containing various antibiotics of interest. Selections of samples were chosen for molecular tests targeting plasmid-­?borne resistance genes CTX-­?M1, CTX-­?M2 and SHV. The method for assessing community-­?resistance patterns showed ambiguous data that was difficult to interpret; further optimization is recommended. For all tested PM-­?plates, generally greatest differences between substances were found among wells with the strongest concentration of antibiotic substance. A total of 175 isolates displayed ability to grow on ESBL-­?agar. Etests confirmed ability of isolates to resist many ?-­?lactam antibiotics and many were clinically resistant to certain substances. No plasmids were transferred during exogenous isolation. During molecular tests, a few matches were found for the CTX-­?M1 gene. Isolates analyzed with Omnilog PM-­?plates showed resistance to most compounds tested. The isolates showed greatest resistance toward penicillin G, ampicillin, amikacin, kanamycin and trimethoprim. In the study, it was established that resistance among bacteria was frequently occurring in the irrigation water, and ?-­?lactamase producing bacteria was very common. Extended studies are needed to assess the frequency-­? and occurrence of horizontal gene transfer (HGF) in this environment. Although some potential corresponding data is found, it is at this point not possible to determine whether the resistances are due to antibiotics used in veterinary medicine, human medicine or one additional reason is travel and trade. in irrigation water using the Omnilog PM-­?plate system. The growth of community microbiota in the presence of the following antibiotic substances was assessed; amikacin, gentamicin, kanamycin, penicillin G, ampicillin, piperacillin, trimethoprim, potassium tellurite and ciprofloxacin. Isolates were pure cultured using semi-­?selective media: LB, Rainbow Agar, mEnterococcus, 0.1 TSA and VRBD. A total of 177 isolates were isolated randomly. Each isolate was identified using the Omnilog GENIII-­?system of biochemical characterization. Further, the isolates were tested on Brilliance ESBL-­?agar for their ability to grow. Out of the total number of isolates, 30 were selected, preferably Enterobacteriaceae or Pseudomonas spp., based on their high similarity to library strain during the identification in the Omnilog-­?system. These were further characterized using Etest-­?sticks. Three selected strains were picked for further analyses using exogenous isolation for attempts to simulate horizontal gene transfer, and Omnilog PM-­?panels containing various antibiotics of interest. Selections of samples were chosen for molecular tests targeting plasmid-­?borne resistance genes CTX-­?M1, CTX-­?M2 and SHV. The method for assessing community-­?resistance patterns showed ambiguous data that was difficult to interpret; further optimization is recommended. For all tested PM-­?plates, generally greatest differences between substances were found among wells with the strongest concentration of antibiotic substance. A total of 175 isolates displayed ability to grow on ESBL-­?agar. Etests confirmed ability of isolates to resist many ?-­?lactam antibiotics and many were clinically resistant to certain substances. No plasmids were transferred during exogenous isolation. During molecular tests, a few matches were found for the CTX-­?M1 gene. Isolates analyzed with Omnilog PM-­?plates showed resistance to most compounds tested. The isolates showed greatest resistance toward penicillin G, ampicillin, amikacin, kanamycin and trimethoprim. In the study, it was established that resistance among bacteria was frequently occurring in the irrigation water, and ?-­?lactamase producing bacteria was very common. Extended studies are needed to assess the frequency-­? and occurrence of horizontal gene transfer (HGF) in this environment. Although some potential corresponding data is found, it is at this point not possible to determine whether the resistances are due to antibiotics used in veterinary medicine, human medicine or one additional reason is travel and trade..

Bacteria are a problem that occurs naturally in dishwashers when the dish stands there dirty for an extended period of time. To get rid of the unpleasant smell that the bacteria is causing, the most common solution is to run a regular washingcycle which can cause problems for the environmentally-conscious consumers since this causes unnecessary energy waste and emissions of chemicals in the washwater. To solve the problem in a more environmentally-friendly way by directly attacking the bacteria with an appropriate bacterialreductionmethod can therefore be an attractive feature in a dishwasher. There are many different ways to treat surfaces that have been exposed to the bacteria. Some high-profile methods are UV-radiation, microwaves and oxidant (ozone) that all three have had success in reducing bacteria in different contexts.

The purpose with this report is to examine how the implemented energy efficiency measures on Bokelundskolan in Växjö have had impact on the energy use. The measures which have been implemented are, new ventilation system, new heating system, optimized adjustment of the heating system, new windows with U-value 1.2 and lower window height, insulation under windows and in the crawl space. The school's energy use before and after rebuilding has been calculated with the calculation program, Vip-Energy 1.5.5.Calculations of energy use for the school with windows on U-value, 0.9 and 0.7 have also been done. The replacement of windows has been studied from a cost perspective. The conclusion is that the exchange of heat and ventilation system was the biggest contributor to reduced energy use on Bokelundskolan.

I denna kandidatuppsats avlägsnas organiska föroreningar från vatten genom användning av textilier, vars yta belagts med nanopartiklar utav ämnet titandioxid. När titandioxid belyses med UV-strålning sker en fotokatalytisk reaktion, vilket i sin tur bryter ned bland annat bakterier och organiska färgämnen. I hopp om att finna ultimat vidhäftning mot textil passande titandioxid har olika typer av beläggningar studerats; akrylbaserade, sol-gel och slutligen en hybrid. Dessutom har fem olika konstruktioner av textila bindningar jämförts i syfte att undersöka dess påverkan på den fotokatalytiska effekten. Förorenade vatten är ett stort problem, både i utvecklingsländer och i industriella sammanhang.

Opcon Powerbox is a product developed by Opcon together with the underlying company SRM (Svenska Rotor Maskiner) where surplus heat from the industry is used through an Organic Rankine Cycle (ORC)?process to produce electricity. An ORC-process is a thermodynamic circle process in which a refrigerant is used as the working fluid. The refrigerant makes it possible for the circle process to operate at lower temperatures than the conventional Rankine process.In this master?s thesis a data analysis software for the Opcon Powerbox has been developed in which measurement data is retrieved and handled from the Opcon Powerbox.

A field experiment was carried out in 2006 to investigate the effects of deep rotary cultivation on sugarbeet growth. The background to the experiment was a 2005 study showing potentially higher yield, higher cleanness and higher sugar content when primary tillage was carried out to 35 cm depth with a rotary cultivator. On four field sites in Skåne (L:a Isie, Ädelholm, Stävie and Vragerup), five different treatments were compared: mouldboard ploughing in the autumn to 20 cm; mouldboard ploughing in the autumn to 20 cm + rotary cultivation in the spring to 35 cm; rotary cultivation in the autumn to 35 cm; rotary cultivation in the spring to 35 cm; and mouldboard ploughing in the spring to 20 cm. The rotary cultivator used in the treatments is manufactured by a Dutch company, Imants. The implement cultivates the soil with spade tines fitted on arms that are mounted on a horizontal rotating PTO-driven axle. Beet plants were inspected and yield determined in the experiment, and three soil parameters were examined: penetration resistance, water infiltration and infiltration of blue dye. Root shape was also examined. The site at Stävie was not harvested due to poor beet establishment. At the other sites, the highest yield was found when the soil was rotary-cultivated in the autumn.

The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.

The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.