A well-planned grave with a sustainable selection of plants facilitates easy maintenance for both staff and the holder of the right of burial. It also helps reduce the negative impact on the environment.As in many other areas, the environment is high on the agenda within the cemetery administration. One of the major concerns is the impact of the choice of plants for the grave. Within the industry there is a great motivation and willingness to adapt to a sustainable work mode and this has spawned a number of project works. In autumn 2009 the partnership project, ?Environmental aspects of planning and maintaining graves?, was started in Movium (at The Swedish University of Agricultural Sciences).

The purpose of this study was to evaluate the different substrates that enter the digestion on Sundet wastewater treatment plant for production of biogas.This work have done an analysis of data about the biogasproduction from January 2012 to feburari 2013, this showed that the food substrates has a greater gas production than internal sludge.Through laboratory test the VS, TS and COD values for all the substrates used in the biogas production could be determinded. But the COD-method was less optimal for analysis of fat and food, therefore it optimized the method for fat but due to time constraints, this could not be done on the food substrates..

Eutrophication of the Baltic Sea is a serious problem. A major contributing factor is diffuse losses of phosphorus (P) from agricultural land in surrounding countries. In order to estimate P losses, environmental monitoring of small agriculture-dominated catchments is being carried out in most of these countries. Evaluation of the risk of P leaching to waters is usually based on chemical tests originally developed to quantify the amount of soil P available for plant production. The tests are performed in different ways in the different countries and a number of different extraction agents are in use.

This thesis has been carried out in New Zealand in collaboration with the University of Waikato. In association with Dr. Mike Duke the purpose of this work is to investigate whether two different software for modeling of photovoltaic systems are useful in the teaching of solar energy.The next ten years grid-connected photovoltaic systems are assumed to increase and therefore also a rising demand for people with engineering knowledge are to be predicted. For engineer students with a focus on solar energy a more practical teaching with design software´s can be a good method to make the students comprehend more when it comes to large scale photovoltaic systems and be more prepared for working life.The software´s used is called Transient System Simulation (TRNSYS) and Photovoltaic Systems (PVSYST) which are both well used throughout the world. To assess the reliability of the software´s, a reference solar power plant at 16.1 kWp installed capacity are used, which consists of photovoltaic modules from four different manufacturers.

This report contains CFD-simulations of cable tray fires in nuclear power plant applications with the CFD-code SMAFS. Furthermore the report evaluates the use of CFD-codes within this kind of problems. The assessment of this report is that there is a tendency towards the good use of CFD-codes but before using it solely more research has to be done on the subject..

This report summarize a simple and efficient way to convert 2D into 3D designs. It explains the benefits of a 3D design compared with 2D, and how those benefits may be used.It will also give the reader a presentation of the company Clean Air Technologies, which for the most part constructs cleaning facilities for power plants. How to create 3D-libraries for some of those facilities will be introduced in this composition.The collaboration with Clean Air Technologies has resulted in several 3D animated movies and rendered images. This has increased the quality of the companies offer presentations, which has made it easier for the prospective customer to get an improved overall image of the power plant design..

This literature review describes organic pig production in Sweden, its advantages and disadvantages, but also how its problems can be reduced or solved. Organic pigs have the possibility to a more natural behaviour than conventional pigs. With outdoor pigs comes problems, especially during wintertime, concerning water and feed supply, thermal environment and supervision. Parasites and leakage of plant nutrients are other difficulties that comes with outdoor pigs. All problems and difficulties can be reduced or put right through correct management.

Oilseed rape is an important crop in Sweden and is grown on about 90000 ha today. The interest in oil seed pro-duction is increasing because of growing demand and high prices for oil seed both in Sweden and Europe. However, an increased intensity in the oil seed production can bring higher risk of yield losses due to fungal diseases. The purpose of this study was to investigate what different fungi are associated with oilseed rape under field conditions and if their incidence is correlated to crop establishment problems. This study was carried out in three parts: 1) investigations on fungal community structure in roots and rhizosphere soils from young spring- and winter rape plants sampled in failed respectively good establishment patches in four fields, 2) investigations on the pathogenicity of fungi isolated from oilseed rape in controlled environment and 3) investigations on the effect of different fungicide seed treatments on germination and early plant development in a field soil naturally infested with damping off- and Verticillium wilt pathogens. The studies on community structure using a combined approach of standard fungal isolation techniques and DNA based methods revealed a high fungal diversity in three out of four studied fields of spring rape and winter rape. For some unknown reason, very few fungal species were identified from the fourth field.

The mining industry, in terms of ore excavation and metal production, is and has been important to the Swedish economy. In connection with the ore excavation process, large amounts of partly sulphidic waste are produced. When the metal sulphides are exposed to air and water they are eventually oxidised, which leads to the formation of acidic water with high concentrations of metal cations and sulphate ions, so called Acid Mine Drainage (AMD). This water may reach the nearest surroundings and cause negative environmental effects. By covering the waste with soil or water, the oxidation process can be minimised. At the Rävlidmyran mine in the county of Västerbotten open pit mining took place between 1951 and 1991.

This study has been done in order to map the supply of vegetarian and vegan food products in Sweden for business clients and consumers. A total of 665 food stuffs were found and classified into six categories. The biggest category was meat substitutes with 302 products and the second largest category was sandwich spreads with 150 different products. Within the remaining categories a varied number of products were found; 86 beverages, 64 cooking accessories, 34 milk free ice creams and 29 plant based yogurts. Of the meat substitutes were 28 only available for business clients.

Agricultural soils constitute the base in human food production and soil content of organic matter and plant nutrients together with soil microbial activity are all important parameters for high crop yield of good quality. These parameters are dependant on proper fertilization.Anaerobic digestion of organic wastes for biogas production generates a liquid residue called biogas residue (BR). It contains organic material and plant nutrients which makes ita potential fertilizer for arable cropping. However, it also contains heavy metals and toxic organic compounds and it is therefore in need of evaluation before usage.Microbial tests were performed aiming to evaluate the agronomic traits of four different BR and to find a viable procedure for evaluating slurry fertilizers. Two experiments where soil respiration and soil potential denitrification activity (PDA) was measured at fertilizer addition were performed.

Water is our most important provision and its quality is above all dependent on the geological conditions in the area from where it is extracted. Due to geological properties there are certain areas with an elevated risk of high uranium levels in the ground water, which in turn constitutes a risk for human health. Consumption of water that contains a high concentration of uranium implies a health risk due to the chemical characteristics of uranium. Livsmedelsverket (The National Food Administration) and Socialstyrelsen (The National Board of Health and Welfare) therefore recommend that precautionary measures should be taken when the uranium concentration in ground water exceeds 15 micrograms per litre. In particular, drinking water collected from wells in areas with uranium-rich bedrock may have a harmfully high level of uranium. One of the wells of the Ärla water purification plant, located near Eskilstuna, Sweden, contains water that exceeds the guideline of 15 micrograms per litre. One interesting technique for removing uranium from drinking water is adsorption to reactive filter materials.

Målet med detta examensarbete, utfört på uppdrag av Vectura Consulting AB, har varit att undersöka möjligheten att ansluta en vindkraftpark till järnvägens kontaktledningsnät. Möjligheten att koppla om vindkraftparken till järnvägens hjälpkraftnät, som bland annat förser växelvärmare och signalsystem med effekt, har också undersökts. Eftersom kontaktledningsnätet och hjälpkraftnätet arbetar med olika frekvenser och spänningar, 16? Hz och 15 kV respektive 50 Hz och 22 kV, måste därför en komplett krets för frekvensomvandling, spänningsomvandling och omkoppling tas fram. Projektet har begränsats till en del av Botniabanan, sträckan Örnsköldsvik-Nordmaling.I denna rapport har trafikfrekvensen på den valda sträckan på Botniabanan undersökts för att bestämma en genererad effekt till inkopplingspunkten, samt för att undersöka när det kan vara lämpligt att koppla om till hjälpkraftnätet.

Målet med detta examensarbete, utfört på uppdrag av Vectura Consulting AB, har varit att undersöka möjligheten att ansluta en vindkraftpark till järnvägens kontaktledningsnät. Möjligheten att koppla om vindkraftparken till järnvägens hjälpkraftnät, som bland annat förser växelvärmare och signalsystem med effekt, har också undersökts. Eftersom kontaktledningsnätet och hjälpkraftnätet arbetar med olika frekvenser och spänningar, 16? Hz och 15 kV respektive 50 Hz och 22 kV, måste därför en komplett krets för frekvensomvandling, spänningsomvandling och omkoppling tas fram. Projektet har begränsats till en del av Botniabanan, sträckan Örnsköldsvik-Nordmaling.I denna rapport har trafikfrekvensen på den valda sträckan på Botniabanan undersökts för att bestämma en genererad effekt till inkopplingspunkten, samt för att undersöka när det kan vara lämpligt att koppla om till hjälpkraftnätet.

Målet med detta examensarbete, utfört på uppdrag av Vectura Consulting AB, har varit att undersöka möjligheten att ansluta en vindkraftpark till järnvägens kontaktledningsnät. Möjligheten att koppla om vindkraftparken till järnvägens hjälpkraftnät, som bland annat förser växelvärmare och signalsystem med effekt, har också undersökts. Eftersom kontaktledningsnätet och hjälpkraftnätet arbetar med olika frekvenser och spänningar, 16? Hz och 15 kV respektive 50 Hz och 22 kV, måste därför en komplett krets för frekvensomvandling, spänningsomvandling och omkoppling tas fram. Projektet har begränsats till en del av Botniabanan, sträckan Örnsköldsvik-Nordmaling.I denna rapport har trafikfrekvensen på den valda sträckan på Botniabanan undersökts för att bestämma en genererad effekt till inkopplingspunkten, samt för att undersöka när det kan vara lämpligt att koppla om till hjälpkraftnätet.