On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

As a result of the Civil Protection Act, there is an imperative for Systematic Fire Preventive Measures, SFPM. SFPM can be divided in two parts: organisational preventive measures, and documentation of fire preventive measures. The manner in which SFPM is to be conducted is similar to that of the environmental management system ISO 14001. This report provides suggestions how to integrate SFPM with ISO 14001..

The Uppsala based company Q-linea develops procedures, instruments and systems for protein and nucleic acid analysis. The components in such an instrument are controlled by microcontrollers. Microcontrollers are computers in one singular chip that can be used in a wide range of applications such as cars, toys or in this case an analysis instrument. When developing a new instrument for biochemical analysis, Q-linea needed new software for controlling and communicating between the components in the instrument. The process of developing this software is the subject of this thesis.The project included research of microcontrollers and the components in the instrument.

När problem med materielsystem upptäcks efter att de har levererats till Försvarsmakten så är detden vidmakthållande organisationen som tar hand om det. Den arbetar för att det aktuella problemetåtgärdas och även förebygger liknande problem. Många instanser runt om i Försvarsmakten är inblandadei arbetet; ibland kan samordning och kommunikation vara ett problem för verksamheten.Uppsatsen undersöker hur ett datorbaserat samarbetssystem kan bidra till att förbättra den vidmakthållandeprocessen inom Försvarsmakten.Undersökningen visar att ett datorbaserat samarbetssystem kan underlätta arbetet för en idag redanfungerande vidmakthållandeorganisation..

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Dairy farming in Uganda provides a source of food, employment and income. Previous studies have revealed high frequencies of bovine mastitis, a costly disease for the dairy farmer. The aims of this study were to investigate the bacteriological panorama in milk from udder quarters with clinical (CM) and subclinical mastitis (SCM) and to determine the antimicrobial susceptibility in staphylococcal isolates. Further, we intended to establish the prevalence of subclinical mastitis and to investigate some environmental factors and animal properties that might influence the frequency of mastitis. For CM, farmers made contact with the members of this study when recognizing an animal with CM.

The purpose of this study is to facilitate sustainable building by the use of BIM. The goal is to determine which aspects of sustainable building, which can be analyzed mainly with BIM tools, but also other aids.The study is based on literature studies and interviews. The literature review examines aspects important for sustainable building by studying environmental certification systems applicable in Sweden, as well as the BIM tools available on the market to analyze these aspects. The literature also includes the concepts of BIM and sustainability in order to provide a clearer view of its meaning. The interviews have brought the study's overall understanding of the industry and guidance on the subject.The results are presented in a table, where the aspects relevant to sustainable building are listed.

Inom industrin används olika testmetoder för att uppnå hög kvalitet i mjukvarukontrollerade system. Kvalitetskraven är särskilt höga för säkerhetskritiska system t.ex. styr- och reglersystem i fordon. I det här examensarbetet används två analysmetoder (Fault Mode and Effects Analysis och Fault Tree Analysis) för att ta fram ett nytt säkerhetstest för ett broms- och växlingssystem som Scania tillverkar. Det studeras även hur formella metoder kan användas för att ytterligare öka kvalitet ochh tillförlitlighet.

Simulation of different systems can be done using a graphical model description of the system based on block diagrams. The simulation software Matlab/Simulink offers a lot of possibilities to describe a huge number of systems, which can be linear as well as nonlinear. The simulation using Matlab/Simulink is done by integration based on different kinds of numerical methods.When nonlinear Simulink-models are simulated, it is often interesting to apply a Kalman filter to handle the noise that may occur within the process as well as corrupting the measurement. However, application of such a filter leads to an extensive time-consumption despite using fast computers. The reason is that the existing Matlab functions are not constructed for time optimal evaluation.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.