Thermia Värme AB is one of the market leading manufactures of heat pumps. In order tomaintain this position, the company wants to improve the vibration characteristics of theirproducts. The aim of this thesis is to develop product design changes that lead to a reductionof vibrations in the heat pump Thermia Diplomat 8.The main cause for vibrations in the system is flow pulsation and mechanical forces inducedby the scroll compressor. Vibration is transmitted through the compressor piping and receivedby the heat exchangers, from where it is further transmitted to the connection points for theradiator and heat source circuits.A number of design changes in order to improve the vibration characteristics have beenevaluated through calculations and practical experiments. The changes have included thecompressor and heat exchanger mountings, the compressor suction and discharge line pipingand also pulsation dampening.The results of the experiments show that the vibration levels in the connections for the heatingand brine circuits can be decreased strikingly through changes in suction and discharge linepiping.

This thesis aims to present the essential background on how to perform climate changeimpact assessments, and to present the results from a climate impact assessment on waterbalance and nitrate leaching for an arable Swedish soil. The soil is a sandy soil in southwesternSweden, grown with spring cereals. This study is meant to be a benchmark example,and cannot be seen as a regional or national assessment for Sweden, rather as an approachto present and analyze the most important parts of these kinds of assessments.A dynamical simulation model (COUP, Jansson and Karlberg, 2004) was used for thisstudy. The model was parameterized and calibrated against data from an experimental site,located in Mellby in Hallands county, south western Sweden. Measurements were carriedout between 1st of April 1988 and 1st of April 1991.

Reducing the CO2-pollution, resulting from the combustion of fossil coal for energyproduction, is important to affect environmental changes. One way to achieve a reductionis to use the oxy-fuel technology. The technology uses O2 and re-circulated flue gasduring the combustion which results in a flue gas mainly consisting of CO2. The flue gascould then be compressed and stored without environmental effects. A problem thatfollows from the compression is the risk of acidification in sensitive parts of the process.Acidification can occur because of reactions following from the contact of condensedwater and sulphur- and nitrogen-oxides which are also present in the flue gas.This report compiles and evaluates the basis of a scientific unit with the purpose ofexploring the possibilities of extracting impurities of SOx and NOx from the flue gases.The dimensions of the unit are based on basic conditions, defined for an existing oxy-fuelprocess at Chalmers, and on the results of computer modelling.

The main goal with this thesis report was to come up with ideas of how to make the use of energy more effective and thus save money for the company.First a survey was made to find out where and how the energy consumers were divided within the company. The results were then used in calculations to find out how much money that could be saved and how long it would take to get back the investments.There is a big potential in saving money by recovering heat from the UV-lamps with a heat exchanger. It would also even out the pressure in the factory which is a source to heat loss and a cause for discomfort amongst the employees. It?s possible to save 105 000 kr in a year and the money needed for the investments is 600 000 kr.By using the recovery air more effectively the company could save up to 250 000 kr a year in lowered heat purchases, but this would require the use of automatic dampers.If you reschedule the running times for the wood chipper and invest in some kind of load management, for example Sydkraft?s ?Energidirigent? you can save at least 42 000 kr.

The Earths climate is changing at a higher rate, i.e between 1861 and 1994 the annual mean temperature in Scandinavia increased with 0,68º C and according to recent climate models the annual mean temperature is likely to rise with another 3º C during this century.A warmer climate in many ways is associated with changing conditions for lake ecosystems. An expected higher water temperature and a stronger summer stratification of the water column increases the risk of anoxic conditions at the lake bottom. Thus anoxic conditions are likely to cause a phosphate leakage from the sediment, i.e. a higher internal loading of phosphate.In this project, the extremely warm summer of 2002 has been used as an example for a possible scenario for a future climate. By comparing levels of phosphorus in the summer of 2002 with a ten-year median value, a phosphorus related sensitivity to climate change has been analyzed for 55 Swedish lakes.

Starting point to this Paper is the idea and wish to adapt the society and its different activities to a recycle society. A building area in Göteborg is planned and investigated for such adaptation. In the district named Skogaberg, about 130 households totally are planned from what 20 are blocks of flats. The idea with this project is to constitute an alternative sewage system, a Blackwater system, were the fractions of most nutrients and least pollution are separated, taken care of and utilised. The aim is to get a market and use the nutrients of the organic waste from the household in agriculture use.

This thesis compares different methods for risk assessment of a creosote contaminated site in Vansbro, Dalarna. In a complementary study the importance of using representative data for calibration and validation of stationary groundwater models is discussed. The time dependency between surface water levels and groundwater levels on the site in Vansbro is evaluated by step response analysis. The results show that the groundwater levels reflect only long-term variation in the surface water levels. Hence the use of such long-term means for calibration and validation of the stationary groundwater models is the only theoretically defendable alternative.As a first step in the comparison of risk assessment methods the degree of contamination is evaluated on the basis of generic guideline values for contaminated soils, developed by the Swedish Environmental Protection Agency.

Microwave is a time- efficient device for heating and reheating of foods. Despite the fact that its effects on foods have been evaluated during a long period of time, without any more negative effects shown compared to conventional cooking, one third of the Swedish population believes (in 2010) it accounts for a higher loss of nutrition. This literature review aim to compile studies regarding how food is affected by cooking in microwave, with respect to cooking losses, nutrition, secondary metabolites as well as sensory and textural aspects and compare it with conventional cooking. The compilation shows that different combination of effect (W), time and amount of water during microwave cooking have different effects on foods. The contents of proteins, vitamin B and carbohydrates are generally higher after microwave cooking, while anti-nutritional substances are affected much less during conventional cooking. This also depends on if it is of animal or non-animal origin. However, for the majority of nutrition values the differences are quite small.

An analysis of a specific application of anaerobic wastewater treatment at a pulp and board mill, Stora Enso Skoghall, was carried out. A literature study was done and effluent wastewater from CTMP pulp production was analyzed. The analysis consisted of a broad constituent analysis and an anaerobic treatment trial. Results from these test where used to calculate the treatment effectiveness and resulting energy potential at the mill.The literature study and constituent analysis showed that toxicity of the water to be treated, due to wood extractives and sulphur content, was of concern. Detoxification chemicals targeting these constituents where used in the anaerobic treatment trial.

Modern methods for managing pine (Pinus sylvestris) create homogenized forests. This decreases nature?s potential for biodiversity and might threaten species in need of different types of milieu. The main purpose of this study was to investigate how important older pine trees are for biodiversity. In the Hall-Hangvar Reserve in the north-west part of Gotland, insects collected from traps showed that more species were found in old or dead trees compared to younger pine trees.

Microwave is a time- efficient device for heating and reheating of foods. Despite the fact that its effects on foods have been evaluated during a long period of time, without any more negative effects shown compared to conventional cooking, one third of the Swedish population believes (in 2010) it accounts for a higher loss of nutrition. This literature review aim to compile studies regarding how food is affected by cooking in microwave, with respect to cooking losses, nutrition, secondary metabolites as well as sensory and textural aspects and compare it with conventional cooking. The compilation shows that different combination of effect (W), time and amount of water during microwave cooking have different effects on foods. The contents of proteins, vitamin B and carbohydrates are generally higher after microwave cooking, while anti-nutritional substances are affected much less during conventional cooking. This also depends on if it is of animal or non-animal origin. However, for the majority of nutrition values the differences are quite small.

Timber floating operations in Scandinavia during the 19th and 20th centuries has contributed to severe negative impacts on riverine ecosystems. Increase in water velocity and lack of stream bed heterogeneity as a result of stream channelization lead to increased bed load transport. Since availability and recruitment of new suitable spawning substrate in Scandinavian watercourses is sparse, spawning habitats for salmonids has become a scarce commodity. Lately, increasingly more attention has been given to the recreation and improvement of brown trout (Salmo trutta) spawning habitats in restoration projects. While much of the research on spawning habitat has been focused on evaluation of the influence that the constructed spawning grounds have on fish populations, few studies have been conducted to evaluate the persistence of these constructions over time. I evaluate erosion of constructed spawning beds as an effect of sediment transport attributable to water discharge.

This master thesis is a study of the Swedish hydropower capacity to balance wind power. The Swedish government has decided that it should be possible to produce 30 TWh from wind power in the year 2020. The Swedish municipalities have to have plans for wind power plants with total yearly generation of 30 TWh. Wind power is an variable energy source that needs to be balanced by other energy sources. In Sweden the Swedish hydropower can be used for balancing a large scale introduction of wind power.

It is important that the current urine separating systems are evaluated to allow improvements to be made and consequently increase their future propagation. In order to increase the knowledge about urine separating systems this study was made. It included, among other things, measurements of amounts of urine as well as of the composition of urine collected at Nytorgsgatan 4 in the city of Hallsberg. The study was increased after an inquiry that also included the district of Understenshöjden in the city of Stockholm. In the inquiry, the users were asked questions about odour, cleaning of toilets and occurrence of blockages in the urine water locks etc.

In the pilot plant at Hammarby Sjöstad, Sjöstadsverket, several new methods are tested in order to achieve a good use of resources. When a new technique is considered it is often the performance of the technique itself, under given conditions, that is evaluated. However, in order to evaluate the overall function the whole picture is needed. With a system analysis it becomes possible to make a comparison where all the positive aspects are put up against the negative ones, for the technique itself as well as its requirements. In this way the influence that minor components have on an entire system can be considered.This report presents a system analysis of an anaerobic membrane reactor (MBR) with a VSEP-membrane (Vibratory Shear Enhanced Process).