Today  Real  estate  companies  face  the  challenge  where  extensive  renovations  on  existinghousing built before 1980 must be performed. Conditions have changed and the housing need performance-­?enhancing measures that meet today's quality. With a current renovation rate,  it  would  take  30  years  to  meet  the  renovation  needs.  The  renovation  rate  must therefore rise dramatically, which requires the real estate companies to act consistently in accordance with commercial principles and in an economically, socially and environmentally responsible way.The  paper  discusses  renovation  strategies  in  four  municipal  housing  companies  in  the Stockholm  suburbs.  The  report  includes  surveys  of  four  ongoing  renovation  projects; Fastighets AB Förvaltaren in Sundbyberg project Hundloken 3, Stiftelsen Signalisten in Solna project Ritorp, Sollentunahem in Sollentuna project Svalgången och Väsbyhem in Upplands Väsby project Dragonvägen. The main purpose of this study was to analyze the practices of redevelopment projects.

Piled friction soil show a set-up which is increasing with the time after installation. The cost could be reduced if the set-up had been taken into account when designing but in Sweden it is very unusual to do that. Previous studies showed that set-up can vary between 25 % and 75 % during the first 90 days after pile installation. This showed that the effect of the phenomenon is difficult to predict. A study involving five projects have been carried out by specifying certain parameters like pile type, method for pile installation and test method for measure the bearing capacity in friction soils located in Sweden.

In May 2008, the Swedish Government proclaimed several proposals in order to increase the status of the teaching profession. One of the proposals was that each teacher should be obligated to obtain a "teaching license" to be allowed to teach. The license/certification will guarantee that the teacher has the sufficient knowledge of pedagogy and subject obtained from University. The existing teachers who do not hold a proper certification today will be given a certain time period to attain one. The teachers that are certificated teachers but that are giving lessons in subjects not certificated in will be given a chance to obtain the proper knowledge of the subject.

In this report a study has been done regarding different heating systems on which are the mostcomprehensive with solar heating systems. The report has also been focusing if solar power can beused as a primary heating source for supplying more than 50 % of the buildings total heatingproduction. The University of Dalarna constructed a demo-house for this purpose and according tocalculations the total solar usage is more than 50 %. This house has been made for referenceregarding the design of the heating system of property 5:37.Further studies have been made to compare different heating systems that are compatible with asolar system, where the compared systems purpose is to be independent of direct using electricity. Asystem of this design is regarded as sustainable according to environmental as economic issues.

Handling materials and packaging, which is the focus of this study, requires efficient logistics, both internally and between companies. To achieve an efficient material flow, good information systems, whose role is to collect, store, process and distribute information, are required. The assumption that packagings are handled in an efficient manner is currently not a matter of course, when many companies do not prioritize the internal management of the package.The purpose of this report was to investigate how medium-sized businesses working with distribution and handling of spare parts packaging can improve their internal management of packaging. In order to answer the purpose, we have used an abductive process and a qualitative data collection. The study had Logistic Center Ljungby (LCL) at Electrolux Laundry Systems (ELS) as a case company and two other respondents, Nibe in Markaryd and Enertech in Ljungby.

I was assigned to the thesis as part of a project GMA AB (Ground Machinery Applications AB) is running. The project aims to develop a new method for injection of drilled holes in rock walls. Currently, the injections usually involve cement but the basic idea of the project is to replace cement with a supplement called Silica sol.Silica sol is known as a gelling liquid. The gel time is controlled by a mixing of saline. Depending on the amount saline that gets mixed in, the gel time varies.

The aim of this study was to understand how social workers deal with honour-related violence, with special focus on the processing from sheltered housing. Our qualitative interviews with social workers that work with this kind of problems show that there are both obstacles and opportunities in the processing from sheltered housing. On the negative side are the loneliness, the shame and the guilt that the girls may experience when they need to leave their families. The social services can both be an obstacles and an opportunity. When the girls need to create a new life in a new city they have a lot of opportunities and in the same time it is hard to get to know new friends when you don´t know the city or have much money.

Micronic Laser Systems AB produces and develops machines for the photo mask production market. One of their products is the Omega machine which exposes photo masks using 5 laser beams simultaneously. It is important that the distance between the each laser beam, the x-separation, is the same. The x-separation is today measured by exposing a photo mask with a certain pattern and thereafter measured with a metrology system. This takes to much time and it is desired to find a faster method to measure the x-separation without loosing precision.The task for this master thesis is to improve an existing measurement method which uses a calibration mask.

Finnhamn is a small group of islands in the Stockholm archipelago. At Stora Jolpan, the biggest island, there is a hostel. The main building was built in 1915 and is called Utsikten. The purpose of this project is to on behalf of the Archipelago Foundation (Skärgårdsstiftelsen) find alternative systems that can replace the existing heating system of Utsikten (an oil-fired boiler and electricity heaters) to a system with renewable energy. The alternative system that this project focuses on is a system of solar collectors combined with a wood chip boiler.

This master thesis studies how much the cycle time, i.e. the time it takes for an industrial robot to perform a given task, can be reduced if an extra degree of freedom (DOF) is added to the robot system. The extra DOF consists of a linear track, which is supposed to be used in an optimal way. The problem has been studied using simulations in the robot simulation tool RobotStudio. To be able to run an optimization in Matlab, with the RobotStudio simulation cycle time as the object function, communication between Matlab and RobotStudio has been set up with an interface written in Visual Basic.

This degree project was conducted in collaboration with Gremo AB located in Ätran.The aim of the project was to develop a solution to secure quality and to help assemblingthe locknut holding the vertical hinge on the harvesters and foresters from Gremo.At this time the nut is assembled manually by the aid of an overhead crane. The nut istightened differently from time to time, and there was no specified torque to which it istightened. Another present problem was the locking washer which sometimes getsdamaged during assembly, when this happens the procedure has to be started over fromthe beginning. The current assembly procedure is very time consuming and lengthy forthe employees.Our task was to design a machine that could tighten the nut to a specified torque with amargin of error of ± 3%. The assembly procedure will be held simple and the timerequired at a minimum.The project started by developing several principle solutions, the one solution that bestmatched our specifications were developed to a primary solution.Today we have started manufacturing and assembling our prototype.

Essay means attempt, and is a paper written based on self-experienced dilemmas, which the writer then returns to, reflect upon and discusses on the basis of literature and accepted theories. In this essay, I reflect upon my own professional role as a leisure-time pedagogue. The leisure-time pedagogue must provide activities that in different ways relate to the curriculum 2011. I have therefore a responsibility to influence the students' desire for knowledge. Focus of learning is different from the one in school, with an emphasis on informal learning.The dilemma is that I am unable to do any pedagogical work at the museum because of many conflicts.

Background: Every year about 4600 nurses are examined in Sweden. The work as a nurse is responsible and she is often working under time pressure. Aim: To describe nurse?s understandings about her professional role during her first year after the examination. Method: Systematic literature review, where 10 scientific articles were examined.

The aim of this study is to increase knowledge and understanding of free play or free fun time importance for children of age around five years in preschool, in order to promote children?s development and learning. The focus was on exploring and better understanding of teacher?s and educators? approach to the free fun play time as a tool in their educational work, and also about their own role in this context as well as analyzing of forms, rules and structures spontaneously created by groups of children having free play fun time. Another important moment of this study was to give more light on approaches to this issue in education theories by Piaget, Vygotsky and Freud among others.As to the practical experimental part of the study it has been performed at a preschool and kindergarten in a suburb at the outskirts of Stockholm, with four employed educators there and with groups of children of age around five.

Article 4.1(h) in the Rome I regulation establishes which law that will be applicable on contracts concerning financial instruments concluded in multilateral systems. The main problem is that most contracts concluded within these systems have standard clauses which contain a clause on the applicable law. If this is the case, Article 3.1 in the Rome I Regulation is applicable instead. This problem makes it difficult to find a need for article 4.1(h) if it will only be applicable in exceptional cases. However, the legal position on this matter is still unclear since the Rome I Regulation has just been put into force.