This report is the result of a thesis work carried out on the Risifrutti production at the company Procordia Food AB. The thesis is at a master level and is the final work for the author to receive a Master of Science in Innovative production at Mälardalen University. The thesis comprises 30 credits and has lasted for 18 weeks. The thesis is mainly a research on whether it is possible to perform an Environmental Value Stream Map (E-VSM) in a food processing industry and an evaluation if the tools E-VSM and Green Performance Map (GPM) are useful in this type of industry. An extra part to this research is to use the results from the E-VSM and give Procordia Food AB information on improvement potentials in the Risifrutti production. The author has found it difficult to collect some of the quantitative data to the E-VSM, mainly regarding energy, but by using the Value Stream Mapping (VSM) tool and other Lean tools the author was able to identify and quantify several wastes in the Risifrutti production. Recommendations for improvements based on these wastes have been given to the company. In the research part of this report the utility of the Value Stream Map, Environmental Value Stream Map and Green Performance Map in a food processing industry have been analyzed. The author has found that the Value Stream Map has been a useful tool since waste and unevenness in the tact of the production has been identified. The Environmental Value Stream Map and the Green Performance Map are also great tools when a company wants to analyze their environmental impact and then invest in environmental improvements. However, no profound energy analyzes has been done in the Risifrutti production because of the lack of energy meters for steam, electricity and compressed air in the production lines..

This Masters thesis work describes a comparison between two different methods for estimation of the down channel (base station to mobile subscriber) in Wide-band Code Division Multiple Access (WCDMA). The first estimation method, Optimal Feed-forward Channel Estimation (OFCE), is a conventional method that bases the estimates on data that is known to both sender and receiver, so called pilots. The second method, Decision Directed Channel Estimation (DDCE), is an elaboration of OFCE. It also uses user data for estimation. Simulations show that DDCE, in comparison to OFCE, does not attain an improvement in signal-to-noise-ratio (SNR) for high bit error rates (BER). An improvement is only seen when the BER becomes much lower than what is common in real situations. In conclusion DDCE is complicated, involves many mathematical operations and gives insignificant improvement of SNR when BER takes common values. It is legitimate to question if it is possible to use the method in a real mobile phone system..

Denna studie undersöker hur statliga myndigheter är som hyresgäster på den svenska lokalhyresmarknaden. I studien analyseras myndigheternas hyreskontraktslängder samt den faktiska hyresperioden för respektive lokal. Därutöver utreds hur respektive myndighet hanterar sin lokalförsörjning både organisatoriskt och strategiskt. För att få en tillförlitlig perception om dagens situation har såväl historisk utveckling samt rådande trender och framtidsutsikter i den statliga lokalförsörjningen beaktats.Tidigare forskning kring myndigheters lokalhyrestider är begränsad, således är förhoppningen att denna studie ska bringa klarhet i detta. Vidare ämnar studiens syfte till att klargöra statliga myndigheters strategi gällande lokalförsörjning.Studien bygger på en kvalitativ del vilken innefattar intervjuer med fem statliga myndigheter.

Background and problemThe Swedish mobile market is highly competitive despite the oligopoly that currently exists. A short product life cycle together with fads and new innovations puts pressure on the operators to respond to the ever changing environment and to develop and adapt their strategies after it.As a previous study regarding a specific operator?s strategy was cancelled due to the extensive confidentiality surrounding it, an interest was sparked to perform an industry analysis as this is clearly something the actors spend a great deal of time on developing. The launch of the 4G network will offer new opportunities for the operators regarding products services. It may also impact the competition on the overall market.PurposeThe purpose of this thesis is to present a deep analysis of the industry and give the reader a comprehensive picture of existing conditions.

This essay is a selective review of Nordic literature with the aim to explore contemporary conceptions of male-on-female rape, to increase the understanding of how these can construct ?a real rape?. To achieve this two questions were formulated: What circumstances can cause an incident not to be defined as rape? What circumstances can cause an incident to be defined as rape? Searches in international and Swedish databases led to initial selection of peer-review journal articles and dissertations that were reviewed against set criteria. These criteria were met by 8 studies, that were assigned codes, from which comprehensive categories were developed.

Companies that are facing the global market are put in to new challenges in order to streamline its business. One industry that has realized that changes are necessary is the construction industry, it is an industry witch is far behind the development of introducing information technology-tools systems in there business. It has shown there is a relation between high IT usage and high productivity, which is one of the reasons to why companies in the construction industry should purchase a business system especially for procurement. However, companies that have purchased a business system are facing difficulties in having their employees using it for its purpose. People react differently to changes and that?s why variations in quantities exist for usage of information technology-tools.

Level:This is a final thesis for a bachelor degree in Business Administration. The thesis is orientedin the field of marketing and written at the University of Gavle.Authors:Caroline Gustafsson & Caroline Tell LjungbergDate:May 2014Tutors:Lars-Johan Åge, Jonas Molin & Jens Eklinder-FrickTitle:The implementation process of ethical guidelines ? A qualitative study of the Swedishinsurance industryPurpose:The aim of this study is to create an understanding of different approaches to design andimplement organizational guidelines / codes to help the employees to behave ethically and deal withethical dilemmas.Method:By starting from the study's aim, it was appropriate to use a qualitative approach toconducting the survey. The study's empirical study consisted of semi-structured interviews. Weinterviewed ten companies in the Swedish insurance industry.

Tourism and Hospitality Management.

In recent decades, demands has emerged that the companies shall take a greater social responsibility for the impact that they have on their environment and that this impact shall be reported, which is known as Sustainability Reporting. The Sustainability Report is based on a number of general principles that ensure the content and the quality of the Sustainability Report. One of these principles is the principle of completeness. In the research, this principle seems to have been interpreted in terms of number of reported aspects and indicators, which can be a limited view where only the existence of the aspects and indicators is observed. By including the degree of the reporting in terms of full, partial and no reporting as well as a comparison between the real and the alleged reporting, our intention is to extend the principle of completeness and to develop a tool that we also apply through an empirical survey in a particular area.

The purpose of thesis was to investigate and compare how two companies within pharmaceutical industry and nuclear power industry are currently working with quality development regarding continuous improvement and Lessons Learned in business processes. In addition, a simple comparison was made with the automotiveindustry.McNeil AB are improving their processes continuously and are according to the findings of this report performing well in their pursuit of world-class pharmaceutical production. They have a well functioning process regarding improvements proposed in weekly improvement meetings engaging all employees. However, during interviews it was made clear that the functionality of the process which administer improvement proposals generated in addition to, or beside the weekly improvement meetings, were inadequate. McNeil AB is proposed to administer this through an IT solution instead of by paper and e-mail, that simplifies the process of adding, implementing and follow up an improvement proposal.The nuclear power plant Ringhals AB recently made major improvements in their business processes as well as the plant itself.

 Genotyping can be used to link genetic variation among individuals to certain diseases or conditions. Some known disorders and states that are dependent on single nucleotide polymorphism (SNPs) are lactose intolerance, venous thrombosis, hereditary hemochromatosis and the difference in sensibility among people to metabolise drugs.In this project a new kit, TaqManÒ Sample-to-SNP KitÔ for extraction of DNA and preparation of the extract for genotyping with real-time PCR and allelic discrimination, was evaluated. QIAamp® DNA Blood Biorobot® MDx Kit was used as the reference method.The purpose of the comparison was to find a method that makes DNA extraction from blood samples cheaper and faster, but with the same reliability as the reference procedure.The results of the evaluation showed a complete agreement of the genotype results between the methods tested, which means that the new method was as reliable as the reference method. The costs of reagents and material would be reduced with 52% if the new method is adopted, that alone would result in a cost reduction of 144 000SEK a year with a sample volume of 650 samples/month. The time for DNA extraction would also be reduced with the new procedure. .

Background: The Swedish fashion industry grows steadily, today it?s populated by many small and medium sized companies. Due to the big clothing chains dominant position small businesses risks to be ousted out of the fashion industry.Smaller companies may find it difficult to reach out to the customer by traditional advertising because their budgets are often smaller. It is therefore important for smaller companies to create loyal customers. If the smaller sized businesses in the fashion industry do not follow the rapid developments in society and focus on building strong brands and relationships, they will have problems with surviving in the long run.Problem definition: Which communicative factors are important in the choice of brand strategy to create a long-term survival for small and medium-sized companies in the fashion industry?Purpose: The purpose of the essay is to analyse and evaluate the brand as a communications tool for building a brand image.Method: The data which is being used in the essay is collected from interviews with companies and survey of each company's existing and potential customers.Theoretical perspective: Relationship Marketing Perspective and Transaction Marketing PerspectiveTheories: Brand Strategies, Total Communication, Brand Equity, Involvement Theory, Service Value Profit Chain.Empiric: The empirical data is primary data gathered from interviews with a representative for each company and from the questionnaires distributed to the customers of each company.Analysis: The analysis is an interpretation of the empirical material collected from interviews with each company and customers survey.

Every year the Swedish government invests capital in different projects. In recent years the Swedish government has chosen to invest in design. The reason for this is that the government wants industry to use design as a competitive source. Two organizations, Svensk Form and Stiftelsen Svensk Indistridesign, have been assigned to improve industry and society?s under¬standing of design.

This thesis intended to examine how small enterprises within the retail industry work with brand building of their corporate name. More specifically it intended to examine how they do to choose corporate name and corporate logotype, and how they work to create a desired corporate image. A case-study was performed with three case-companies from different industries. The method was deductive as the empirics were brought in with starting-point in the theoretical frame of reference. The study showed that there are differences in the way small enterprises within the retail industry work with the brand-building of their corporate name.

AbstractThe importance of good construction planning affects the final costs of the production and the timing of the project. Planning for building projects has been studied with the aim of identifying how three week planning appears in the construction industry today.A case study has been conducted in Navisworks Simulate to assess whether the software is suitable to connect the task schedule with the BIM model to create a 4D model. 4D models are used for performing 4D construction simulation to visualize the project. In order to use the benefits of the model, investment in equipment and software is required. This means higher costs for the companies.