Vattenfall Heat AB is a district heat provider in Drefviken, but has yet to establish any cooling systems in this area. This thesis examines the potential client base within the area today and over the coming 20 years. The feasibility of the most common cooling technologies is evaluated and results show a total potential for an installed capacity of 30 MW providing 50 GWh of cooling per year. One of the examined areas shows good prospect for heat driven absorption chillers during the summer months when the heat load is limited..

Cancer is one of the most feared diseases in veterinary medicine today, and the incidence is higher than ever due to the fact that our companion animals live longer then they did ten to twenty years ago. Cancer is also one of the most common causes of mortality in older companion animals. This literature review will be about two of the currently most common form of cancer treatment of companion animals in Swedish animal hospitals, chemotherapy and radiation therapy. There will also be a section of general nursing care for cancer patients. The section of chemotherapy will describe the indications for choosing chemotherapy, the way to administrate chemotherapeutic drugs, describe specific chemotherapeutic drugs, potential side effects of chemotherapy, and how to handle and store chemotherapeutic drugs safely. The section of radiation therapy will describe the current devices for delivering radiation therapy, describe the indications for choosing radiation therapy and describe potential side effects that radiation therapy may cause.

If a building is heated by a heat pump, it is of high importance that the heat pump has a high coefficient of performance. An exhaust air heat pump extracts heat from the building?s exhaust air. The air has a relatively high and constant temperature all year around, leading to a high seasonal coefficient of performance. This thesis examines whether it is profitable to complement an exhaust ventilation system with an exhaust air heat pump in an apartment block that already has geothermal heat pump, district heating, oil- or biofuel heated system.

This thesis aims at determining the heat losses in a property vent stack and its roof valve. Upon request of a company, the vent stack is analysed for possible heat recovering solutions to be implemented, while relining of the drain system is executed and with a suitable payback time for the economic investments. The heat loss calculations are based on data for properties that are located in the Stockholm region, but also easy to change depending on the situation. The calculations are done on pipes made out of cast iron, which still is the most common type of drain pipe in Sweden, and these are the pipes that relining is usually made on. The calculations that needed to take several variables into account have been done in MatlabR2014a and the thermos dynamical properties that were used in those calculations have been extracted from EES.Three different types of heat losses in the vent stack have been taken into consideration in this thesis.

The main goal with the master thesis has been to do a status evaluation of the chain machinery with its start chain and wire to secure the production on a short basis due to that a reconstruction is not planned at this time. An evaluation of the condition of the start chain and the rollers in the chain depository has been done. An offer has been requested for a new start chain and the evaluation of the start chains may be a basis for the decision taking. The production has been able to go on, although it has arisen some problems which have been difficult to find the causes for. There is no gathered ?picture? of the machinery status and a mapping of each machinery has been compiled of comprehensive logs.

The purpose of this bachelor´s report is to expand the knowledge about heat supply of a small house in Malmö. The heat supply will be provided from solar panels in combination to two accumulator tanks which will storage the up heated water and a pellet boiler.The technique used here is warmth storage in water over seasons, which will provide the total need of heating for the house. Accumulator tanks in combination to solar panels gets more and more common in Sweden but this far it´s unusual to use it for storage over seasons. This report will highlight many of the difficulties associated whit heat storage and give information about a system's possible design and function.The design of this system is decided early on. An accumulator tank is placed 2 meters down in the earth on the backside of the house.

In this report an MCNP (Monte Carlo N-Particle) model is described for the reactor vessel at Ringhals 2. The model is validated against the specific activity in neutron dosimeters, extracted in 1977, 1984 and 1994. The validation showed that the calculations of the model are within the requirements of a maximum of 20 percent uncertainty for every neutron dosimeter except one, extracted after the first cycle. The uncertainty of this cycle was mostly due to the operation data rather than to the MCNP model.The model has been used to investigate various questions concerning radiation damage. The reliability of the traditional measure of radiation damage, fast neutron flux (En > 1MeV) has been evaluated.  This has been done by taking the ratio for this and another measure of radiation damage, DPA (Displacement Per Atom), for various positions and layers.

Vattenfall district Heating power plant in Uppsala produces district cooling with absorption heat pumps which leads to a large amount of waste heat that has to be cooled with evaporative cooling towers. The Environmental Court has ordered Vattenfall to survey the possibilities to recover the heat, which is the focus of this thesis.The study begins with an overview of the system, and conditions and limitations for waste heat recovery is examined. In the next step alternatives to recycle the heat is evaluated, either by direct recovering or by upgrading.First, the technical possibility of each alternative is discussed, and then the operation time and the amount of recovered heat is calculated. Those alternatives which are possible are brought further to an economic analysis.The cost of investment for each alternative constitutes the basis for a present value analysis. The results are put together in a table where the total amount of recovered heat is compared with the present value for the different alternatives.

X-rays are a potential risk for animal health care personnel. The present study will examine the risks for scattered radiation to the personnel, if no lead gloves are used when holding an animal during the x-ray examination. Furthermore, how the impact of the exposure values and body parts examined, affect the scattered dose to the hands of the holder. Also, the distance between the animal and the hand that holds it was evaluated to see the impact on scattered radiation exposure. Tested by a survey, to animal health care students, the frequency of the usage of lead gloves in Swedish animal hospitals was studied. According to the results from the analysis, animal health care personnel don't need to use lead gloves every time they hold an animal or a cassette during x-ray examinations.

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

Modern technology and fast development of heat pumps, the hunt for savings in energy consumption and the strive for environmentally friendly energy sources, convenience, and financial profit, have made heat pumps a reasonable alternative for the heating of houses.When the heat pump starts it will consume a considerable amount of current, which may result in a short-lived voltage-drop if the power grid is weak compared to the start-up current.The company Fortum Distribution which owns and administrates electrical network is interested in an investigation that deals with heat pumps affect on the quality of electricity.The purpose of this investigation is to study fast electrical fluctuations (flicker) as a result of start-up currents for single as well as multiple heat pumps on the same electrical station and from this evaluate whether there will be any problems installing heat pumps..

This rapport is result of a project. The purpose of which was to design a circuit that is used in a heat glove. The heat glove is the technical aid which provides heat inside a glove.It is specially suited for old people who have problems with cold hands because of decreased blood circulation.There already was an old circuit in the glove that gives a constant current which develops heat from battery to glove through a circuit. The temperature is between 32 and 34 degrees.The problem with the existing circuit was to regulate the temperature. There is only on/off switch and there is no way to adjust desirable value of the temperature.In order to solve the problem the old circuit was investigated.

When a combined heat and power plant produces heat and power it often faces a deficit of heat load during the summer or other periods of time. This heat is often unnecessarily cooled away or the power production has to be reduced or shut off. If it is possible to store heat from periods with low heat demand to periods with high heat demand one can get many benefits. Among these benefits are: increased power production, decreased operation with partial load, uniformly distributed load.To be able to store heat in situations like this long-term thermal heat storages are needed. In this thesis five different types of stores are presented: rock cavern storage, tank storage, pit water storage, borehole storage and aquifer storage.

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

The rising demand for electricity and heat raises a big challange for the society and engineers. Many products have been introduced to the market to supply more energy to the energy systems. Absolicon AB is a Swedish company that develops and markets a combined heat and power generating product. The product, Absolicon X10, uses a parabolic trough to concentrate the radiation of the sun onto a receiver. The receiveris equipped with mono crystalline solar cells and is cooled by a circulating liquid media.