Habitat mapping was conducted in the main stem of River Vindelälven in the autumn of 2009 along the salmon distribution area. The aim was to estimate the Quantity of potential reproduction areas, including spawning and juvenile rearing habitats. The mapping included 61 km of various stream sections along the river length of 269 km. The total area of stream habitats was estimated to 647 ha of which 396 ha (61%) were considered as either potential or optimal juvenile nursery habitats. The area of these two habitat classes were used to estimate the smolt production in the river by using electro fishing densities of juveniles (0+ per 100 m2).

Since the nineties the words customer, effectiveness and quality have become part of everyday school life. Municipalities? makes regular customer surveys to measure both independent schools as municipal schools ' quality. A common method for customer research and background studies is that parents and students are asked to respond to simple Web-based surveys. Customer satisfaction and/or customer dissatisfaction options are presented in tabular form, based on the percentage that expresses a particular position within a query.

The struggle for the customer has become a priority for the fashion industriesconsidering that it is the customers? willing to shop that guarantees theircontinuous survival on today?s competitive market. To keep the customer happyand satisfied, should be their priority as this leads to an economic advantagesince the customer becomes the companies strongest allay with help of the socalled ?word of mouth? effect. The positive response is then transmitted fromthe customer, acting as a spokes- person for the company.

Background:It is always fascinating to observe the events that affect the stock market, especially as the numbers of influencing factors are so many and various. Political elections are important events in society and affect the corporate environment in different ways depending on which political party that is in power. This brings up the question of whether political elections are important enough to affect the stock market; and it is this question we intend to analyse in this paper.Purpose:The purpose of this paper is to investigate whether political elections affect the stock market and to discuss the reasons for any possible affect that might be found.Procedure:An appropriate and thoroughly tested method to investigate if an event affects the stock market or not, is to do an event study. Subsequently we chose to do an event study on whether the Swedish general elections in 2002 and 2006 affected the Stockholm Stock Exchange. In order to give the analysis more depth we have also chosen to interview people with knowledge of the stock market.

The purpose of this master thesis is to present a model that illuminates the important factors when deriving technical information from market data within a company. For companies to be able to become and stay competitive in the market, product quality is an important factor. Whilst good product quality leads to customer satisfaction and loyalty, lack of quality brings costs in service and replacements. To improve product quality, the developers need information and knowledge about what quality issues affect existing products. Most companies gather data from market about known issues, but in order eliminate known quality issues in new products; this data has to be transformed into information and knowledge.

Abstract   Study: Degree project in teacher education, Advanced level, 15 hpUniversity of Skövde.Title: ?The aim is for them to manage as much as possible on their own? ? a qualitative study of preschools´ indoor environment as a pedagogical tool for the independence of children.Number of pages: 31Author: Jenny Karlsson, Marie PerssonTuto: Gunvi BrobegDate: 2009-01-28 Keywords: Independence, indoor environment, preschool, pedagouge This study aims at examining the indoor environment of three different preschools as a pedagogical tool for the independence of children. Is the design of the premises adapted to the height of the children? Can they themselves reach the material they need and is it possible for them to reach their outdoor clothes or do they constantly have to ask for help? In order to acquire a deeper understanding of the different views of the three preschools, the question is asked: what are the pedagogues thoughts of the indoor environment of their own preschool in the perspective of childrens independence and what affects their choice of furnishing, planning etc? The preschool curriculum clearly states that the children must be given the opportunity to develop their independence. We have experianced that the pedagogues feel that they are unable to plan the environment as they wish and thus, interest is also pointed towards the question: are there any limiting factors that affect the design of the indoor environment, and, that being the case, which are they? The study is based on qualitative observations and interviews because it is in its interest to discern patterns and categories rather than Quantity.

The product structure of the fuel tank installation is one of the most complex product areas at Scania. Caused by the number of parameters, which affect the fuel tank installation, a product structure is created which is very difficult to handle. Knowledge exist that the structure in a nearby future will be considerable more complex. The purpose of the study has been to understand in why this complexity exist and find ways to break the trend of a growing product structure. The goal was to achieve a more standardized fuel tank installation.A theoretical study was performed in order to bring knowledge in relevant areas both in general theory but also in documentation at Scania.

The  change that has occurred during the past few decades concerning the development of electronic records, information technology and the constantly increasing Quantity of information, have confronted the archival discipline with new challenges. In the digital world, the concept of ?record? has changed from representing something lasting and physical to something much more abstract and transient. The way to approach archival description has also changed, from focusing on the static preservation of archival records, to documenting the transactions of organisations, and to clarify operational processes. The discussion about the general purpose of the archival discipline, and its place in a changing world, has led to a new approach to archival description.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the Quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

Today, about 15 to 20 percent of Sweden?s total emission of carbon dioxide can be traced to the household sector. By examining apartment blocks in a life cycle perspective, the origin of the carbon dioxide emission has been charted and analyzed. This information has been used to create a computational model that calculates the total emission of carbon dioxide from a specific apartment block. The results from the analyzed apartment blocks indicate that both the use of energy and the emission of carbon dioxide have been reduced since the 1960s. Through the examination of building materials, it is possible to lower the emission of carbon dioxide that origins from the construction phase of an apartment block.

The lifecycle of fashion products get shorter and shorter. Companies in the fashion business needto make sure that they can offer their customers the right products, in the right Quantity at theexact right time. The competition on the fashion market today is tough and if companies aregoing to be successful they need to have access to the most reliable suppliers, and also offer theircustomers products with high quality to attractive prices. It is therefore of highest importance toevaluate and choose the right sourcing strategy. Product category and type of organisation aresome of the factors that will determine which strategy that is most appropriate.

Crop efficiency in utilizing available nutrients is an important factor in increasing produc-tivity and reducing the environmental impact of agriculture. Nitrogen is the nutrient that plants need in the largest Quantity and wheat, along with maize and rice, is the world's most cultivated crop. In this work, the Nitrogen Use Efficiency, NUE, during the major growth period, HTP, of twelve different spring wheat varieties, were examined. The NUE was calculated as the product of uptake efficiency of nitrogen, UN, and the conversion effi-ciency of nitrogen to biomass, EN. The purpose of this work was to find if there are varietal differences in NUE and its components among the twelve varieties and to link a high NUE to specific characteristics of the varieties.

Örebro UniversityDepartment of Social SciencesSociology and social psychology, Continuation course, 61-90 p.Essay 15 p, Spring -08.Title: ?Youth (work)seekers?Author: Karolina LindellAbstractThis essay focuses on young people?s social background when they apply for their first job. I have interviewed four young people from a small town in Sweden, to see how social background and identity affects their vital conditions in general. I?m interested understanding the relationship between structure and agency.

Shock absorber units play a key role in establishing the driving dynamics and performance of automobiles. Öhlins Racing has manufactured high-tech automotive shock absorbers for over 30 years. Öhlins Racing?s advanced technology has contributed to over 200 world championships in automobile racing. Öhlin?s manufacturing process has long utilized automated fluid filling equipment during the final shock absorber unit assembly stage. The filling process consists of vacuum pumping the shock absorber unit and subsequent transfer of fluid. Vacuum pumping is necessary to remove residual air from the shock absorber unit prior to initiating the liquid filling stage. The presence of undesirable gases drastically compromises the performance of a shock absorber. The filling degree, defined as the final ratio of air to oil, is determined by the specific filling protocol as well as the specific equipment utilized.The current investigation aims to develop a viable technique to accurately determine residual air content in shock absorber units. If the filling degree can be appropriately quantified for a specific manufacturing process, then the air/oil ratio may be quantitatively related to shock absorber performance. The utilized measurement method must be completely integrated into the manufacturing process to guarantee shock absorber performance specifications according to the manufacturer?s standards. By utilizing the measurement method developed in this work, the manufacturing process, manufacturing equipment and product specifications can all be tailored to provide improved filling conditions.The developed measurement method provides accurate quantification of the filling degree under a wide range of processing conditions. The method establishes the relative Quantity of air in the shock absorber unit by performing in-situ compressibility tests. The fill ratio can be controlled and varied by manipulating the vacuum pressure exerted during the filling process. Performance tests, however, indicate no correlation between filling degree and unit performance..

This master?s thesis was performed during the fall of 2006 at Cloetta Fazer AB in Ljungsbro. Cloetta Fazer is the market leader in Scandinavia of manufacturing confectionary and chocolates. The purpose of the project has been to identify causes that impact the Quantity of waste in production as well as a cost/benefit analysis of the solutions that can reduce the problem of production waste.The work includes four production lines that are individually designed depending on what kind of product that are produced on the line. By using qualitative and quantitative methods such as focus groups, interviews and observations data has been collected.