The residential and service sector in Sweden accounts for approximately 38% of the total energy usage and Sweden has an aim to reduce the total energy use by 20% by 2020 compared to 2008, which means residential sector will have to improve energy efficiency. As part of that a law was instituted by the Swedish parliament that all Properties must have an Energy Performance Certificate (EPC) to thereby give the property owners a greater insight into energy use in their buildings and propose recommendations for energy-efficiency measures. On the EPC, a value on the building's energy performance in terms of energy use in kWh / m2 per year is declared, of which electricity is a share of it. Instructions on what to include in the amount facility electricity for running the facilities is regulated by the authority for building, Boverket while SVEBY has made an interpretation of the regulations in their report "Brukarindata bostäder" where they have a table on what should be included in the amount and what not to include.This report is a study of two similar apartment buildings, where one of the buildings recently underwent renovation, to see if the declared amount of energy for electricity, in the EPC, is consistent with the measured value, and whether there has been any reduction in facility electricity in the renovated building after the renovation.The result shows that the measured value of the building electricity was 2.6 kWh / m2 per year, 28,8 %, lower than the declared value in the building that have not undergone a renovation. Calculation of values from previous years (2011) by the same percentage of facility electricity as in the results of the measurements, 56.7%, it becomes clear that the declared value for facility electricity in the EPC of the renovated building do not correspond with reality and that there has been an increase in use of facility electricity after the renovation..

Dooria Sweden AB is one of the main door- and doorframe manufacturers inSweden. They deliver door frames for indoor use for project oriented buildingsites, for these types of building sites the doorpost comes pre-assembled. DooriaAB wants to minimize transport to reduce impact on environment and thetransportation costs of pre-assembled doorframes, this thru simplifying themethod of assembly.The main purpose of this thesis has been to develop a prototype solution thatbrings the three parts of the doorframe together with the same Properties regardingstability and tightness of joints as the current method of assembly. A profile ofdemands and wishes were created in collaboration with Mårten Dragstedt, DeputyDirector of Dooria Sverige ABBy following the chosen method the authors have been able to produce a fullyfunctional prototype that meet the demands that were put on the product. Catia V5R20 has been used as an aid during prototype construction and virtual tests.

Properties are bought and sold daily, which means that it is of great importance with rules that regulate the acquisition. The rules on who should be held liable for a property brought to a head when the acquisition relates to a property that is loaded with contaminated soil. The purpose with this thesis is to investigate who could be held liable for contaminated land and also whether an exclusion clause can affect the separation of responsibilities. Two different liabilities can occur depending on which law that should be applicable, MB or JB.MB's rules apply to anyone who may be subject to decontamination responsibilities, which is regulated in Chapter 10. MB.

The purpose of this study is to investigate the perceptions of leadership and gender issues circulat- ing in Womentor leadership development programme, and to have a discussion around what conse- quences they may have on participants' careers. To answer the question I have used a qualitative approach in the form of 10 interviews and non-participant observations. The theories in this study are based on gender and leadership issues.The problem which forms the basis of this study is the underrepresentation of women at senior posi- tions. A basic assumption in this study is that notions of gender and leadership affect the individual's ability to act. The circulating concepts identified in Womentor are: The leader who wants to be a manager, The leader who gets things done, The communicative leader, Change leader, The motiva- tional leader and The leader as a role model.

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

The attitudes towards nature conservation in forestry are based on the individual forest owner. The theme of the interviews is the opinion on nature conservation in forestry. The purpose of this study is to identify if there is any difference in attitude to nature conservation in forestry according to the age of the forest owner. The study discusses different factors that affect the private forest owners consideration of nature conservation and give an insight in different generations attitude to nature conservation. Other topics that are discussed is if future change of generation will change the consideration of nature conservation in Swedish forestry and what is needed to enhance the interest in nature conservation among forest owners.This study is the result of interviews with a number of forest owners in the county of Uppsala, Sweden.

Svenska Kraftnät is (together with the other transmission system operators of the Nordic power system) responsible for keeping balance between the generated and demanded power in the Nordic power system. Spontaneous load variations and system disturbances, however, lead to power imbalance followed by frequency variations. The frequency deviations can be limited to an acceptable level by the spinning reserve, mainly by hydro power control. But there are also other system Properties which have a great influence on the frequency and system stability. The frequency and voltage dependence of the loads have a direct influence on the power balance.

Multiple factors are involved in control of beef sensory quality so great variation can be induced. The perception of meat quality can be affected anywhere in the product chain. Both the environment and the set of genes of the animals have an effect on the final output. A problem facing the beef industry today is the significant variations in meat quality between individual animals, which is reflected in the uneven quality of the meat that reaches the consumer. If the quality of meat in stores varies significantly over time, the consumers? trust may decrease.

Wood pellets are an upgraded product of residuals from several wood processing industries, for example saw mills and pulp industries. The pellets are produced by pressing the milled and dried sawdust to cylindrical units with a higher density than the initial raw material. Pellets have great benefits compared to the raw material: high energy per volume, good transport and storage Properties and homogeneity. Several parameters collaborate in the whole process, which makes it complex. Wood is a heterogeneous material, chemically and structurally dependent on wood parts, habitat and storage procedures.

There are two species of potato cyst nematode (PCN), the yellow, Globodera rostochiensis, and the white, Globodera pallida. Each of them can appear in different pathotypes. These are separated by testing the nematode ability to multiply on a number of potato cultivars with different resistance Properties. The aim of this project was to examine the virulence of Swedish and foreign PCN populations and to compare two test methods. Biotests are today the only available tests used to study virulence.

The aim of this study is to find information about what to do when riding arena footings are worn-out. Especially, the surface layer of riding arena footings is very interesting because of its importance of giving grip in every step for the horse, as well as shock ab-sorption. Generally, surface layers are containing several different parts in order to achieve desirable Properties. These different parts can consist of organic material or in-organic material (mostly gravel). Gravel and many other materials in the top-layer are environmental friendly, and therefore, easy to get rid of.

The aim of this paperisto find out which plants the Cistercian monks might have cultivated in Sweden during the Middle Ages and which types of plants it would have been practical to grow inside or outside of the Cistercian monastery precinct. Archaeologicaland archaeobotanical studies have been consulted to find out which plants were available in Sweden during the Middle Ages. Examples, mainly from Scandinavia, but also from the continent, are used to show that the monasteries were large institutionsthat had to feed a large number of people and that there would not have been enough space to cultivate everything needed within the monastery precinct.Secondary sources have in the main been used to gather this information, except in the case of the Swedish monastery of Nydala where F-Topo, a database developed by the County Museum of Jönköping,has been used to analyse the amount of land and the types of Properties owned by the monastery.The conclusion is that for practical reasons the monks would have cultivated plants that needed to be close at hand, that were rare or delicate, that could not be stored for long periods and that were used in small quantities within the monastery precinct. This would include medicinal plants, herbs for cooking and some vegetables like lettuce, spinach,and similar,that do not keep well. Most other items, grains, cabbages, root vegetables, peas and beans could equally well be cultivated outside the walls.

For systems with multicore processors contention for shared resources is a problem that occurs when several memory-intensive processes are executed in parallel within the same memory domain. This contention has a direct influence on the performance of the system and is a complex problem that has been recognized for a long time. An attractive and actively studied way to minimize this problem is by using a process scheduler adapted to allocate processor cores in a way such that contention for shared resources is minimized.With the introduction of multicore NUMA-systems (Non-Uniform Memory Access) the situation has become even more complex. In these systems the access time for processor cores to different memory domains vary depending on factors such as distance and load. Thus, the process scheduler also has to consider where the memory of each process is placed to minimize the distance and balance the load on each memory domain.This report presents a user-level process scheduler for a NUMA-system based on the multicore processor Tilera TILEPro64.

The present project was initiated with the aim to create pattern modules for use in public environments. My intention was to let the Properties, of the specific materials used, have a marked influence on the realisation of the final form. I also wanted to find a material, which is suitable from the perspective of sustainabilityand possibilities to create modules from it. The work was initiated with a study of some candidate materials and many sketches before I finally made my choice. My decision was clear after a visit to the company Glasfabriken inKalmar.

The purpose of this master thesis is to implement and validate a Power System Stabilizer (PSS) to a generator at Trängslet hydropower station in Dalarna, Sweden. Problems with local rotor oscillations can occur at the hydropower station when power is transferred on a new power line (130 kV) from Northern to Southern part of Dalarna. To ensure good operation Properties on this power line Fortum Generation AB and Fortum Distribution AB wants to activate a PSS on a generator.There have been investigations in which situations and what equipment that contributes to rotor oscillations. When this is known the PSS is tuned to damp these oscillations by choosing a good set of parameters. The most important parameters for good performance are to choose amount of gain and phase compensation.