In this report focus is put on the combustion process at a cement plant. Combustion is the heart of the cement making process and absolutely crucial to have under full control and well optimized. The fuel is put into the process through a burner pipe and this burner pipe is modified to reach a more efficient combustion. The primary target is to enable burning of heterogeneous alternative fuels and increase the production level. Other positive effects from this type of optimization is lowered specific fuel consumption and lowered CO2 emissions. A redundant burner is chosen for the project and overall the project steps are the following: 1. Installing a Jet air nozzle ring in a way so it can move both axially and radially due to temperature changes. 2.

Linjäriseringar av olinjära system är mycket relevanta eftersom det finns en i förhållandevis enkel och omfattande matematisk teori kring linjära system, till skillnad från allmänna olinjära system.För vissa olinjära system är det svårt eller inte ens möjligt att genomföra en analytisk linjärisering.Orsakerna till detta kan vara hög komplexitet av systemet eller avsaknaden av ett analytiskt uttryck.Numerisk analys kan vara en lösning på detta problem.I detta examensarbete används framåtdifferens och centraldifferens för att genomföra de derivata-approximationersom behövs för att genomföra en numerisk linjärisering av ett olinjärt system.Rapporten behandlar även vad som sker då det är dålig upplösning på den indata som används när man genomför enlinjärisering, vad som händer med heltal och binära signaler om de ingår i ett system som linjäriseras ocheffekten av att ha olika samplingstider för olika delmoduler i ett system som linjäriseras.Slutligen undersöks numerisk bilinjärisering av ett system på bilinjär form och en jämförelse mellan analytisk linjärisering och bilinjärisering görs..

This thesis treats Building Information Modeling, BIM, in the production stage. Brieflydescribed BIM is virtual model of a building object where all information about theobject is gathered. All the involved operators in the construction project have access tothe model and can gather or share information about the project. There are several waysto apply BIM in the production stage. This thesis primarily deals with visualization of theobject, preparation and planning, the ability to take amounts from the model andcoordination and clash control.The basic issue was highlighted by Byggdialog AB.

Banverket Trafik has a responsibility to make sure that the companies who traffic the Swedish railroad have the correct information about the status of the railroad. One of Banverket Trafiks information systems (Opera) presents the train?s actual position on a map and provides the user with physical information about the trains. Due to increasing demands on the information systems, Banverket Trafik needs to update the present system architecture in order to manage the increasing demands on map graphics and map functions. This paper analysis the information system Opera on the basis of theory and support of methods and discuss problems and demands for Opera.

Detta examensarbete har utförts vid Elitfönster AB i Vetlanda. Elitfönster AB är Sveriges största leverantör av fönster och fönsterdörrar.Syftet med arbetet är att ta fram åtgärdsförslag för att minska ledtiderna, då korta leveranstider blir ett allt viktigare konkurrensmedel. Arbetet innebar en kartläggning av nuvarande produktionsflöde och identifiering av problemområden.Arbetet genomfördes med hjälp av tidsstudier och intervjuer med arbetsledare och personal. Arbetet bygger även en hel del på observationer, iakttagelser och studerande av statistik.I stora drag kan man dra slutsatsen att de långa ledtiderna beror på främst två orsaker;? hyvelbanornas långa ställtider som medför körningar i veckosatser? kvalitetsbrister och bristfälliga kvalitetskontroller samt trästycken som ?försvinner? längs förädlingskedjan.

The Swedish government has proposed that 20 % of the cultivated land in Sweden should be organic by the year 2010 (The Swedish Board of Agriculture, 2008). In addition to this the production of organic food like milk, meat and egg should increase considerably. To reach the government?s goal it is necessary that the Swedish farmers get motivated to convert their production from conventional to organic. Milko is a dairy association that has chosen to focus on organic products, they want to be the leading organic dairy association, and therefore they have a large need for organic milk (Milko, 2008).

Atlas Copco Tools is a world leading company in tool manufacturing. The productionin Tierp works hard to improve their assembly to maintain its position. This thesis isa part of their improvement efforts to be a more Lean production.The main focus for this thesis was to identify the material flow in the kanban system,which used to supply the assembly groups, focusing on the material flow to assemblygroup 9 and the assembly group 3. Group 3's material flow within the kanban systemwas perceived to perform better than the group 9. The handling of kanban materialand their working methods in the two groups was identify those differences whichaffected the kanban system.As an alternative material supply a study were done in kiting.

The development of productivity in the construction industry has long been at a steady state compared to the manufacturing industry. Studies have shown that, amongst other things, waste on construction sites can reach up to one third of the total production cost. This has been observed from different aspects, and change is forthcoming.This thesis aims to provide a foundation for an increased productivity at production sites of building bridges. It is primarily based on a field study at Skanska, at a bridge construction site near Grängesberg. Via continuous interviews with the whole production crew, construction workers and management, information on interference and possibilities of improvement at the work site has been documented.

One of Sweden?s sixteen national environmental objectives strives to decrease the impact on the climate. By 2020, green house gas emissions should be 40 % less compared to the levels of 1990 and a minimum of 50 % of the energy consumption should come from renewable energy sources. Because of this there is a great need of increasing the production of renewable energy. This is where biogas comes in as a competitive alternative.

Användbarheten av IT-system förbättras ständigt och företag har fokus på att förbättra sina IT-system som företagets kunderna använder då det leder till fler och nöjdare kunder. Annorlunda ser det ut för interna IT-system, alltså datasystem som används av medarbetare och som ska förenkla arbetsuppgifter, effektivisera arbetet eller även möjliggöra att utöva arbetsuppgifter vid en arbetsmiljö på distans. Användbarheten av interna IT-system står inte lika mycket i fokus som användbarheten av kundcentrerade system och istället för att åtgärda brister i användbarheten tvingas medarbetarna att lära sig hantera IT-systemets brister.Utgångspunkten för arbetet var funderingarna över vilken betydelse användbarheten har för ett företag när det gäller interna IT-system vid en arbetsmiljö på distans. Ansatsen var att undersöka om användbarhetsproblem i praktiken leder till att användarna upplever ett IT-system som dåligt i den särskilda situationen av ett arbetsmiljö på distans. I en fallstudie utvärderades ett IT-system som används av försäkringsombud som arbetar på distans med hjälp av en enkätundersökning och användarintervjuar samt hierarkiska uppgiftsanalyser.

Since the turn of the millennium a sharp increase in the interest for bio energy has been observed. Important reasons for this growing interest can be due to the fact that fossil fuels are a finite resource. A net discharge of greenhouse gases occur when fossil fuels are burned. The discharge of greenhouse gases are considered to be the main reason to the greenhouse effect. Means of control to increase the use of bio energy has been introduced and, as intended, the use of bio energy has increased. As a result of the legal provisions the ability to pay for bio energy has increased, which the forest industry view as a problem.

I denna rapport har vi undersökt hur utvecklarna tagit hänsyn till användbarheten för slutanvändarna vid utvecklingen av ett säkerhetskritiskt system. Resultatet erhölls genom en empirisk fallstudie på två företag som utvecklar säkerhetskritiska system. Datainsamlingen bestod av intervjuer med personer som varit delaktiga i och har kunskap om utvecklingen av systemen som ingick i vår fallstudie. Sedan analyserades insamlad data mot teori inom Människa ? Dator ? Interaktion (MDI) samt teori om säkerhetskritiska system.

This study analyses the economic consequences due to ethanol production in Eastern Sweden. The analyses consider the cooperative and the farmers as one vertically integrated company. The area that found the market in this study is illustrated in figure 1. The analyses assume that all members act jointly with the objective of maximizing joint profits at the farm level as well as at the cooperative firm. A mathematical model is created to calculate the optimal use of arable land.

Abstract New methods, techniques and tools for the building industry are constantly being developed and improved and launched on the market. The problem in the building industry development is not that the products are not good enough. The problem is instead that the existing construction companies do not choose to use these innovations, instead they continue to employ the technologies they already possess and master. This leads to the fact that the construction industry is, in the public eye, beeing seen as a conservative industry. AquaVilla is a company that basically produces houseboats.

This thesis examines how knowledge management professionals use trust as a component in the creation of knowledge management systems, and what methods they use for building trust.Adopting a grounded theory approach, interviews with 8 knowledge management professionals active in different industries served as the base for an analysis that identified trust to be the single most important common factor in the data. The concept of trust used by the informants was identified as relating to the knowledge management system itself, rather than other users, employees or groups in an organisation.Building trust, the KM-professionals mainly focused on three methods: simple solutions, system superiority, and implementation security. Using these methods, the KM-professionals seek to ensure system trust by creating opportunities for users to obtain positive experiences of using the system, and thereby generate a foundation for a trust-based relationship between the user and the system..