Följande rapport är resultatet av det examensarbete som utförts våren 2011 inom innovativ produktion/logistik vid Mälardalens Högskola. Examensarbete behandlar ämnet Green Production med fokus på skillnader mellan ett produktionssystem som bygger på Lean Production och ett som bygger på Green Production. Områden som berörs i rapporten är de verktyg som används i de olika produktionssystemen, hur arbetet med miljöförbättrande åtgärder kan se ut i praktiken samt vilka svårigheter som finns vid arbete med miljöförbättrande åtgärder i ett företag. Examensarbetet består av en litteraturstudie där aktuell litteratur studerats inom området samt en intervjustudie som genomförts med insatta inom miljöfrågor kopplat till produktion samt operatörer.Bakgrunden till examensarbetet grundar sig i att världen står inför en framtid där många utav de råmaterial som används idag vid produktion inte kommer att kunna nyttjas i framtiden. Detta i kombination med de miljöproblem som människan åsamkat, har bidragit till att många företag insett att miljöaspekter måste vara i åtanke genom hela produktionsprocessen.Den uppfattning som erhållits genom intervjustudierna är att det är viktigt för ett företag att visa att de arbetar med miljöförbättrande åtgärder.

Arbetet visar praktiskt hur en organisation kan utnyttja kvalitetsbristkostnader, för att sedan utifrån dessa identifiera möjligheter till förbättring. I arbetet används identifierade kvalitetsbristkostnader för att ta fram en projektplan för motortillverkningen. Projektets resultat ska medföra att kvalitetsbristkostnaderna vid motortillverkningen minskas. Arbetet börjar med att identifiera vilka kvalitetsbristkostnader som motortillverkningen har dokumenterat. Därefter tas en enkät med öppna frågor fram, vilken behandlar kvalitetsbrister vid motortillverkningen.

This bachelor thesis is intended to gather the knowledge and experimental data on the winter wheat crop production relevant for Swedish conditions, with focus on sowing time, row spacing and seed rate. This essay is a literature study with a minor component based on interviews with farmers producing winter wheat. The work is divided into a background part where basic knowledge of winter wheat physiology, development and environment interactions are described and one part where results of field trials studies are presented. Optimal date of sowing winter wheat depends on annual weather variations. Because it is difficult to forecast the weather the choice of sowing date should be based on weather statistics, production experience and previous results depending on sowing date.

Each year, the coffee machines at Ericsson in Kista produce around 100 tons of ground coffee waste.The companies Coor Service Management, Löfbergs Lila and Selecta are all responsible for differentstages in the logistical chain in delivering coffee and, together with Ericsson, they want to increasetheir environmental benefit. The plan is to produce biogas through anaerobic digestion instead ofincinerating the coffee waste in a heating plant. The results are to be presented as different businesscases in which different biogas plants are compared with the reference case (heating plant),comparing costs and environmental impacts.There are two major environmental benefits from producing biogas; reduced carbon dioxideemissions from when fossile fule is replaced by carbon neutral biogas, and reduced emissions fromreturning digestate from the bio reactor to farmland instead of using industrial fertelizer.In order to determine the biogas potential in coffee waste, a couple of properties had to bedetermined in a laboratory. Properties such as the dry substance content, heating value, moisturecontent and ash content. The results show that 100 tons coffee waste could produce around 16 500Nm3 biogas which would contain 163 MWh.The biogas reactor and upgrade plant both need energy gas to function and uses around 14 MWh ofthe produced gas.

This thesis on the sustainable urban development has the intent to discuss the conservator?s position in alteration of the built environment. An essential component of the thesis consists of a case study in the form of an entry in an open architectural competition for the development of Furuset, an urban residential area in Norway. The thesis? discussion is based on two approaches to change and socio-economic transformations, considered being dominant within the heritage theory and practice: the production of ideas and great narratives and conservation as an instrumental tool.

The different aspects of each individual construction project such as the general conditions, design and economic restrictions as well as many more factors mean it is difficult to standardize building processes or plan in detail based on past experiences. As a result operational efficiency is often reduced, and unnecessary waste is generated. To make an organization more efficient and therefore reduce waste production everybody involved needs to appreciate and understand the improvements that can increase the organization?s efficiency. To investigate these improvements a time study was performed on two different construction sites, both of which involved buildings being constructed of prefabricated steel and concrete elements.

This exam report has been developed in association with Strangbetong AB, Sweden.The natural gravel that is being used as fine aggregate for concrete production today is an ending natural recourse and the Swedish government has decided to strongly reduce the extraction from the year of 2020. The only reasonable replacement is aggregates from crushed rocks but this material has other properties than natural aggregates. The concrete manufacturers now have to learn how to use these new fine aggregates in a cost effective way in order to ensure the quality of their concrete production.In this project, crushed aggregates and combination of crushed and natural aggregates have been tested with existing formulas for fresh concrete. The two parameters yield stress and plastic viscosity have been measured which gives a good description of the workability of the fresh concrete. Different methods to make measurements on the dry fine aggregates, has also been tested, to find out if there is any correlations between these parameters and the parameters from the measurement on the fresh concrete..

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

This master thesis is about the collaboration between the custom dairy heifer grower and thedairy producer.The custom dairy heifer grower is a rather unusual strategy of reproductive management inSweden compared to other countries like U.S. and Denmark where the specialization withindairy production gone much further. In these countries the research also has reached muchfurther within this type of industry. However in Sweden there has been research made in thearea of collaboration, but then only within collaborations in the industries of crop production,dairy production and pork meat.The down going trend of profitability within dairy production together with poor profitabilityin the beef industry could partly remedy if more collaborations around heifer contractingwould arise. But since the industry still is of a rare kind in Sweden the knowledge about howthese types of collaborative arrangements works and their contracts are put together is poor.By that the aim of this master thesis is formulated as follows: "how is usually thecollaborative arrangement between the dairy producer and custom dairy heifer growerdesigned".

To invent an optimized product is a complicated process. This process is only half of the work. It is equally important to develop a production system that can produce the product in an  efficient and ergonomic way.After several evaluations of conceptual and detailed drawings a final idea has come to light.The idea intends, to the maximum extent, utilize the facility in a more efficient way through moving assembly lines and stations closer to the flock section and the stock for complete products. To make the production better, stations are placed in more logical places given the assignment they are supposed to accomplish. This improves the material flow radically.

During the period 1952-2008, real prices of wood before taxes and charges declined. However, the actual net income has not changed by the same percentage as the price list, because taxation, driving costs and the ability to make deductions has changed. This report considers the inflation by using the Swedish consumer price index. Net income refers to the remaining income when relevant costs, taxes and fees have been paid.The purpose of this study was to examine how the private forest owner's real net income has evolved over the period 1952-2008 for three categories of forest owners. These three categories are1.

Sheep breeding contributes not only with wool, hides, meat and milk but also with openlandscapes. The sheep?s wool is a good raw material thanks to a lot of different qualities as itis water rejecting and easy to form. The wool production today is concentrated to specificplaces in the world which leads to environmental problems and a distorted market. InJämtland, a province in Sweden, there is right now a staking going on for local production andrefining of wool in a project called Ullforum.

Quality was earlier only an issue for the company?s quality departments but today is the entire organization involved in quality- and improvements work. With the customers in focus, both external and internal, quality and improvement work should be integrated in the daily activities. The management shall state goals and visions together with a policy. Through participation the correct requirements for a successful work are created.With SPC, statistics process control, there is an opportunity to perceive variations in the process and with the correct tools make it stable.

The different aspects of each individual construction project such as the general conditions, design and economic restrictions as well as many more factors mean it is difficult to standardize building processes or plan in detail based on past experiences. As a result operational efficiency is often reduced, and unnecessary waste is generated. To make an organization more efficient and therefore reduce waste production everybody involved needs to appreciate and understand the improvements that can increase the organization?s efficiency. To investigate these improvements a time study was performed on two different construction sites, both of which involved buildings being constructed of prefabricated steel and concrete elements.

Companies that invest in e-learning have different expectations regarding the outcome of the investment. According to literature and articles it is common that companies see reduction of costs as the primary benefit with e-learning. Therefore we ask ourselves the question if companies have attained the expected benefit of the investment in e-learning and to what extent cost reduction have been a determining factor in the investments? The purpose of the thesis is to examine if companies that invest in e-learning have attained the expected benefits. We also want to examine what the reason for investing in e-learning is and if cost reduction is the primary reason for investing.