The dissertation were performed on SP, Technical Institute of Sweden. The dissertation were carried out on the measurement technical department, this dissertation is a part of a bigger project, project ClampCal. One of SP?s returning assignments are flow-measurement. When flow-measurement is performed, the flow has to be stopped so that a meter can be installed in the pipes where measurement is going to take place. At every stop there is time delay in the flow which causes the customers to loose money. This is why SP wanted to find a better solution so that measurement can be done without any stops in the flow. Usage of a so-called Clamp-on meter was considered, but since the measurement uncertainty is too large it takes some investigation on the parts where the largest uncertainties occur and thus find a solution that can diminish the uncertainty as much as possible. The parts that were considered to have an opportunity to reduce measurement uncertainties were the fluid temperature, its characteristics and the pipe geometry and its characteristics. For the fluid temperature a Pt100-sensor with four different radii for various pipes was used.

An important process for grid companies in order to reduce power losses in electricity distribution grids is to figure out where and how they appear. This report describes the factors that cause power losses in low voltage distribution grids and methods for how they could be measured and analyzed. Measurement data for consumed and injected energy were collected for twelve low voltage distribution grids owned by Gävle Energi AB in order to analyze the size of the power losses and how the measurement uncertainty affects the collected data. Then models of three of the grids were created in MATLAB in order to analyze the data and the power losses were calculated to be compared to the collected data. Curve fitting were also used as a method in order to analyze the power losses from collected data.The results show that the losses in the studied grids are low.

During the late twentieth century, political and societal changes gave rise to an increased interest in performance evaluation in public organizations. This development also affected libraries in the public sector. The main concern for this master thesis is performance measurement in libraries. In this study two different types of libraries are investigated, one public and the other academic. My aim is to find out if and how performance measurement appears in the libraries annual activity reports.

The aim of this Bachelor´s thesis is to investigate how library statistics, performance measurement and indicators represent the modern public library activity. During the last decades the public library has gone through a lot of changes. Information overall has increased and new technology has been introduced into the library. This new development has had effects on the library users. The statistics reported to the Statens kulturråd (National Arts Council) has not changed in the same way.

The aim of the thesis is to analyse and understand resolution, repeatability and reproducibility of the measurement system for package distance. The measurement system for package distance is already in use, no Gage R&R has been performed on the system and before spreading use of the system the quality of the system has to be understood and approved.

Bachelor thesis, Business Administration and Economics Programme, School of Business and Economics at Linnaeus University in Va?xjo?.Spring of 2015 Title: Performance measurement from a cost leadership perspective - A case study on Gekås.Authors: Adrienn Csiszer, Hannah Lundberg & Helena WennerströmTutor: Eva GustavssonExaminer: Karin Jonnergård Keywords: Performance measurement, Performance measurement systems, Generic strategy, Cost leadership strategy, Financial and non-financial measurements. Purpose: The purpose of this study is to examine how a company with a clear cost leadership strategy chooses to work with performance measurements, with a view to comparing a practical example to theorethical approaches. Methodology: The method chosen for this paper is a case study on Gekås AB. The presented data were collected through interviews conducted with four employees on Gekås. Conclusion: The study concludes that for a business with cost leadership strategy the financial measurements are more important than non-financial meausurements. For Gekås it is important to keep the performance measurement simple and understandable for the employees. They only use three measurements (sales, hours and sales per hour) in planning and in evaluation.

The Private Equity industry has over the past years been booming and major external environmental changes have made the industry transform rapidly. Increased competition between Private Equity firms is one of the reasons why the industry has been and is being forced to focus more on addition of value through increased operational management. Consequently, the focus of value addition is by some said to be transferred away from deal making and financial skills, and into active operative management. This case study investigates how the portfolio management, and more specifically the measuring and management of performance, is carried out in a number of leading Swedish Private Equity funds with investments in the biotech sector. The biotech sector is characterized by extensive research and development, and many biotech companies often lack income and other measurable financial parameters in the initial phase.

There is always a need for more effective ways to store energy in order to reduce the human impact on the environment. One step on the way can be the use of flywheels as kinetic energy storage devices. Low frictional losses are essential for a flywheel to be effective. To minimize these losses active magnetic bearings (AMB) can be used to keep the shaft centered instead of the more conventional ball-bearings. AMBs use actuators and a fast control system that needs correct and noise-free measurement data of the shaft position and the current in the actuators to work properly.This thesis explains the process of constructing power electronics and a current measurement system for active magnetic bearings (AMB).

This thesis deals with different methods for measuring moisture-related dimensional changes ofwood. Typically relative humidity is measured to determine if the ambient climate around anobject is harmful to it or not. Values between 40 to 65% RH are recommended for hygroscopicmaterials. To know how a wooden object actually reacts to changes in the surroundingenvironment requires methods that involve the object itself. Because of the wood anisotropy,differences in wood structure, finishes and other restraints, it is not always possible to predict themovements.This paper addresses various measurement methods, primarily methods that have been testedin the field of conservation, with examples of their use.

Authors: Maria Bergholtz, Alexander WestessonTutor: Daniel EricssonTitle: Performance Measurement of Creative work ? a culture study at PS CommunicationKeywords: Key Performance Indicators, Organizational Culture, Macro-culture, Subculture,Micro-culture, Art, Business, Creativity, PS CommunicationIn the paper?s introductory chapter, the chosen problem area regarding art and business willbe presented. The paper?s studied empirical case will also be introduced here. This then leadsto the reports chosen research questions:How do the company management and the companies? creative personnel approach differ inthe discussion regarding performance measurement on PS Communication?-What causes these differences?What impact does the corporate culture have in the discussion about performancemeasurement of PS Communication?-Is the corporate culture weak or strong?The purpose of this paper is to resolve the stand still in the discussion regarding performancemanagement by creating an understanding of different people active in the organization?sapproach to performance measurement.

The aim is to describe the factors that influence nurses' assessment and measurement of pain in patients. Literature study based on 13 reviewed articles, searched in the Cinahl. Qualitative and quantitative articles were analyzed. Six themes were identified that can be seen as the factors that influence nurses' assessment and measurement. The themes were   pain education, nurses´ experience in the profession, nurses´ level of knowledge about pain relief, documentation about pain, nurse´s perspective on the patient, and pain measurement.

The acoustics in a control room is a complicated phenomenon. Early reflections, reverberation time and area in the room are some of the problems. This report is about the reflection on the mixing console in a control room. The control room being built, these reflections are difficult to take into consideration since the mixing console is one of the very last items you place in the room. This report will explain three main measurements that were done in order to get the answer to the following question: Does the mixing console interfere the frequency curve at listening position? Three measurements were done and the difference between the measurements was that the microphone and the loudspeakers were placed in different places in the control room.

A system for sampling of alcohol and aldehyde from diluted exhaust gases from vehicles powered by ethanol has been developed and tested. The major part of the work has been research of earlier work in the field and the construction of the sampling system.The part of the system constructed for the measurement of alcohol has been shown to work, however, more test should be performed. The part of the system constructed for the measurement of aldehyde was tested parallel to a commercially available system, based on the same principle of measurement, and has been shown to work well.Determination of the concentration of gaseous ethanol using a FID has shown the since earlier known fact that a FID is not able to measure a correct concentration of ethanol. Furthermore it has been shown that high concentrations of gaseous ethanol can not be kept in a bag more than a few minutes without a substantial decrease of the measured concentration..

The aim is to describe the factors that influence nurses' assessment and measurement of pain in patients. Literature study based on 13 reviewed articles, searched in the Cinahl. Qualitative and quantitative articles were analyzed. Six themes were identified that can be seen as the factors that influence nurses' assessment and measurement. The themes were   pain education, nurses´ experience in the profession, nurses´ level of knowledge about pain relief, documentation about pain, nurse´s perspective on the patient, and pain measurement.

Strong relationships are something that is really important for companies to succeed with, in purpose to increase and protect their market shares. After major research on the subject, it has been found that variables like exchange of relationship, trust, control mutability, satisfaction and commitment are important in the establishment of measuring a relationship. The purpose with this thesis was to: increase the knowledge on how companies measure, and then consequently evaluate, their relationships. To answer the purpose of the study we chose to do a case study at Stadium AB, which is a retailing concern with a high level of customer contact on a daily basis. The conclusion is that trust most likely is the key variable in measuring relationships.