The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The projects objective is to find an alternative method of heating (the current method being via electric heating) the sewage treatment plant on the island Utö in Stockholm?s archipelago in order to reduce the energy consumption and ultimately the cost for heating the plant. The project is given by ?Skärgårdsstiftelsen? (The Archipelago Foundation) and is a part of the larger EU-project ?Green Islands?.A model for the plants total heating demand is established in order to get a good perception of how much money can be saved using alternative heating methods. The heating demand model gives an annual heating demand of approximately 32 500 kWh and a maximum heating power demand of around 24,7 kW.

As trucks are getting more and more advanced, information about their weight has become a key factor for controlling them in a more fuel efficient and safe manner. Knowing the mass of a heavy duty vehicle in real time has been a difficult challenge for the truck manufacturers. With the processing power for electronic control units in trucks steadily increasing, more advanced algorithms for calculating the mass has been developed, but at the moment there still is a wish for better performance.Since there is a lack of good information regarding the external forces acting on the vehicle, forces that depends on the slope of the road, foundation of the road and the wind, the methods have to be able to disregard these. Such an approach, based on an indirect least square solution, has been evaluated in this thesis. The results have been promising and based on these a recommendation about further evaluation has been made..

Many of todays studies show that district heating is one of the betteralternatives as heating source because of its low environmental load.The energy source is often leftovers from other processes producing energy or waste, like garbage or chips.Electricity in combination with geothermal heating is another heating system that has increased sharply during the last years, and also this system decreases the discharges that have negative affectson the environment compared to several other heating methods.This report aims to, concentrated towards these two different heating systems, estimate the amounts of discharges they indirect cause and how the environment is affected.We have calculated the mean value for discharges of carbon dioxide, nitrogen oxide, sulphur oxide and dust generated from electrical power used in Sweden.Through interviews and research we have gained data for the same substances that district heating based on combustion of garbage and biofuel generates.We have also in cooperation with a housing company chosen a building we see representative for many of the new single-family houses built in Sweden today.Based on its shape and appearance we theoretically created three alternatives of the same house, each of them with climate screens different from each other.Together with the amounts of discharged environmental affecting substances, these houses were the base for our calculations and studies when investigating the different heating sources environmental effect.The results have thereafter been analyzed and discussed from different angles..

This thesis is a qualitative study of a new law that was applied in December 2010. The law is called Lagen om etableringsinsatser fo?r vissa nyanla?nda invandrare, and is meant to help newly arrived immigrants that come to Sweden to establish themselves in the Swedish society. The aim of the study is to see what discourses the Swedish government produces as a result of this new law. Interesting for the study is to see what happens in the implementation stage at a local level, in this case in the municipality of O?rnsko?ldsvik.Theoretically and methodologically I emanate from critical discourse theory and institutional theory.

Ett konsultföretag får in anbudsförfrågningar och måste därmed göra kalkyler för dessa förfrågningar. Med hjälp av ett webbaserat system där en anställd kan göra kalkyleringar kan företaget få ett gemensamt sätt att arbeta och uppföljningen underlättas. Systemet som har skapats ger användare möjlighet att göra anbudskalkyler genom en överskådlig och lättarbetad webbsida, där man kan se förhållandet mellan företagets kostnad gentemot kundpriset. All information lagras persistent i en databas för att möjliggöra uppföljning och synkronisering med andra system som används på företaget..

sustainable development by reducing the energy use by EU:s directive of energy efficiency and the UN Convention. The second purpose is to present the technical solutions regarding ventilation and heating system that is being used in passive houses. This was done using 8 passive houses, 4 germany and 4 swedish passive houses. Even the international and Swedish system requirements for passive houses have been addressed in this project. The goal was also to explain how and why the mechanical system in passive houses has developed to the technology used today.

The actual project presents the development of a testing rig for a steam engine. A short overviewabout the development of steam engines is presented, until arriving to the development of thepresent engine, which will require to be tested in different ways.The testing rig studied on this project (based on a Lanchester engine) will be used to testdifferent materials and layouts for the group Piston-Cylinder.The engine is a high performance steam power engine, which is going to have a highpower/dimensions ratio, what will lead to require high performance components and materials.An introduction to the testing rig is presented, and the entire design project is done in order toreplace the disappeared documentation of the current testing rig, built on the 1970?s. Also somemodifications done in the original testing rig are presented, as well as some detected problemsand their possible solutions..

The purpose of the study is to investigate the possible effects of an unstable ventilation system and its influence on energy use and thermal comfort. The report also explores how qualified personal working with HVAC view and handles system control.In order to meet the requirements in energy efficiency and a comfortable indoor climate control regulation is a prerequisite. With optimized increased complexity of the climate systems, it becomes more challenging to control the system and the risk of unstable control increases. No previous studies about what affect an unstable system can have on energy use and thermal comfort have been found.The report is based on several tests were the controlling variable has been increased until the system becomes unstable. Two different types of unstable systems have been investigated.

The increasing complexity in the development of a configurable real-time system has emerged new principles of software techniques, such as aspect-oriented software development and component-based software development. These techniques allow encapsulation of the system's crosscutting concerns and increase the modularity of the software. The properties of a component that influences the systems performance or semantics are specified separately in entities called aspects, while basic functionality of the property still remains in the component. When building a real-time system, different sets of configurations of aspects and components can be combined, resulting in different configurations of the system. The temporal behavior of the system changes and a way to ensure the predictability of the system is needed.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

I föreliggande studie undersöks hur användare upplever användbarheten i ett säkerhetskritiskt system ? Luftfartsverkets flygledningssystem SIGMA. Utifrån litteraturstudier definieras begreppen användbarhet och säkerhetskritiska system. Empirin utgörs av intervjuer med användare av SIGMA-systemet. Studien visade att användarna upplever att systemet i väsentliga delar har bra användbarhet, vilket utifrån litteraturstudier, intervjuer och efterföljande analys främst tycks bero på att systemet arbetats fram med stor användarmedverkan och att det var utarbetat specifikt för arbetsplatsen.

This master thesis work was done at Saab Underwater Systems AB, a company at the cutting edge of underwater technology. Here torpedoes and other underwater vehicles are developed and manufactured. The major customers are navies of different countries, mostly the Swedish navy. The aim of this master thesis is to develop, construct and evaluate an automatic Trim System for Unmanned Underwater Vehicles. The task of the system is to change the position of the centre of mass and the vehicle?s total mass or volume.

Elever ska enligt kursplanerna i teknik få förståelse för de tekniska system de möter i sitt dagliga liv. Genom att eleverna får kunskap om teknik i allmänhet och tekniska system i synnerhet får de möjlighet att påverka sina liv som medborgare i en demokrati. I litteraturen saknas idag studier om elevers uppfattningar om tekniska system. Syftet med detta examensarbete är därför att studera vilka vardagsuppfattningar elever har om de tekniska system de möter i vardagen. Studien utgår från systemteori vilken ger en möjlighet att utnyttja det gemensamma mönster som kännetecknar analys av system.