New technology makes it possible to remotely measure all consumers in a power network onan hourly basis and store the values in a database.This thesis work describes the conversion process between automatic meter reading systemMActor and calculation software Xpower.Then the possible differences between calculations of power networks using load curves incombination with a yearly estimate of consumption and calculations using hourly measuredvalues is examined.The result of the comparison shows that, for the power network under inspection, nosignificant difference could be noticed. This does not mean that calculations using hourlymeasured values would be unnecessary. I believe that in a near future calculations using hourmeasurements will be the primary choice for many power companies to whom technology isavailable.Also some basic calculations of fundamental power network parameters, such as power factorand loses, are presented using hourly measured distribution transformers in combinations withits hourly measured loads.The report is written in Swedish.

In the middle of Australia there is a city called Alice Springs. The city has one of the highest amounts of daily sunshine hours and sun irradiation in the world. The Australian Government runs a project called Solar Cities, and Alice Springs is one of the participators. The main part of the goal with the Solar Cities project is to increase the amount of electricity generated by solar power and by doing that lower the impact on the environment. This thesis examines the possibilities for construction of a large scale solar power plant in Alice Springs. This is done to determine the potential of creating a more sustainable energy system in the city.

In the middle of Australia there is a city called Alice Springs. The city has one of the highest amounts of daily sunshine hours and sun irradiation in the world. The Australian Government runs a project called Solar Cities, and Alice Springs is one of the participators. The main part of the goal with the Solar Cities project is to increase the amount of electricity generated by solar power and by doing that lower the impact on the environment. This thesis examines the possibilities for construction of a large scale solar power plant in Alice Springs. This is done to determine the potential of creating a more sustainable energy system in the city.

Micro-power wind energy convertors have recently increased in popularity. The reasons for this are among other things the increasing cost of electric energy and enviromental concern.In this thesis the connection of these micro-power wind energy convertors to the utility network is discussed. Electric standards for the connection of small production units is presented. Finally some calculations and measurements of electric quality are also presented. The utility network used in the calculations is part of Halmstad Energi och Miljö network..

The use of energy is an important question in today´s society, and a substantial part of the energy that is used today is used in our homes. To lower this usage is vital, and there are regulations in place both on the national and the local level, that say that new apartment blocks must be built to consume less energy, which in the end will lower the impact on the climate.One way to make the housing sector more environmentally sustainable, is to produce energy issions that are bad for the environment, for example to build wind turbines close to or even on the buildings, so called urban wind power. The scope for this report is to see if urban wind power could be a sustainable alternative for the residential area that Svenska Bostäder plans to build in Albano in Stockholm.There are extensive scientific theories regarding wind and wind power, and a literature study is made to investigate past knowledge in the area. Efforts have been made to find earlier trials with urban wind power and, both scientific research and trials where urban wind power actually has been installed. The theory chapter deals both with the wind itself and how electricity can be generated from wind.

This thesis concerns how the power quality in the grid is affected by the connection of wind power plants. As things are at present, Fortum Distribution AB has a number of wind turbines and wind parks connected to the own grid. As the pressure on building and connecting additional wind power is increasing, so is also the interest of how the already existing wind power generation affects the power quality in the nearby distribution grids. The study is performed by direction of Fortum Distribution AB and is limited to the 10 kV/40 kV-grid in Bohuslän, Sweden. The methods for calculation of power quality are compared to the results of a number of measurements.

Due to historically low prices for electricity in Sweden, many small-scale hydropowerplants were closed down. A small-scale power plant has more or less the samemaintenance costs as larger plants, but doesn?t generate as much income. Today?sincreasing price for electricity in combination with a desire for renewable energysources makes small-scale hydropower interesting again.

The purpose of this study has been to evaluate whether a Low temperature bio-mass dryer could be integrated with the local district heating system in Malå. The aim is to increase the thermal efficiency of the cogeneration plant in Malå, by lowering the temperature of the cooling medium. Another benefit that comes from this is improved combustion efficiency at the power plant, since drying the fuel causes an Increase of the heating value.Simulations has been made in Excel, and with use of linear regression, to find out if it is profitable. Data for this purpose has been supplied by the power company Skellefteåkraft and furthermore SMHI.The result of the Calculations shows that a very efficient bio-mass dryer is needed, if yield of investments should be made possible. An Investment of 4,27 Mkr, in a dryer, could at a such criterium return 60000 kr/year, if the price of the biomass is 190kr/MWh.

The interest in small-scale electricity in Sweden has increased strongly in recent years. The interest is noticeable both among politicians to increase the share of renewables in the energy mix, and among electricity consumers to partially replace purchased electricity with self-produced. This has resulted in a significant increase of electricity production in low voltage grids in recent years, and the trend appears to continue in the coming years. The majority of the new production plants are solar cells, followed by wind turbines, and it is also in these the greatest efforts are made in this paper.Distributed generation is often seen as something positive since it will contribute to reduced transmission losses and reduced voltage drop in the networks, and that it increases the share of electricity from renewable sources. In cases where the grids are not strong enough, or in other ways not adapted to manage the installed production, power quality may be adversely affected.

The interest in small-scale electricity in Sweden has increased strongly in recent years. The interest is noticeable both among politicians to increase the share of renewables in the energy mix, and among electricity consumers to partially replace purchased electricity with self-produced. This has resulted in a significant increase of electricity production in low voltage grids in recent years, and the trend appears to continue in the coming years. The majority of the new production plants are solar cells, followed by wind turbines, and it is also in these the greatest efforts are made in this paper.Distributed generation is often seen as something positive since it will contribute to reduced transmission losses and reduced voltage drop in the networks, and that it increases the share of electricity from renewable sources. In cases where the grids are not strong enough, or in other ways not adapted to manage the installed production, power quality may be adversely affected.

An important process for grid companies in order to reduce power losses in electricity distribution grids is to figure out where and how they appear. This report describes the factors that cause power losses in low voltage distribution grids and methods for how they could be measured and analyzed. Measurement data for consumed and injected energy were collected for twelve low voltage distribution grids owned by Gävle Energi AB in order to analyze the size of the power losses and how the measurement uncertainty affects the collected data. Then models of three of the grids were created in MATLAB in order to analyze the data and the power losses were calculated to be compared to the collected data. Curve fitting were also used as a method in order to analyze the power losses from collected data.The results show that the losses in the studied grids are low.

The aim with this study was to collect fundamental information, and to plan, a windpower farm in Juddhult , Småland in southern Sweden. The goal is to collect the bestavailable projecting planning support. The pieces of this projecting planning supportthat will be presented is; Environmental Consequence Description (MKB), productioncalculations, comparisons between different plant types, economic calculations, evaluatethe economy and give some farm design suggestions. The imagined wind farm will belocated in forest environment and which may cause a number of new problems. Specialinterest that will be affected, where special consideration because of the forestenvironmental is requested is, hunting, wetlands, ancient monuments and windturbulence.

This project was started within the Market-Design programme of Elforsk, with the aim of developing representative test systems of Swedish distribution networks. Using such test systems as a basis for reliability and customer interruption cost calculations makes it feasible to analyse the network tariff regulation of Swedish power  istribution companies. In particular, it enables studies of the incentives for companies to invest in system reliability. Until now, the available test systems are either not representative of Swedish conditions, or too small in scale and limited in function.Within this project we have created two test systems. In order to represent the diversity of actual Swedish distribution networks, we have created one test system for urban environments and another for rural environments.

Energy Director is a control and measuring system for energy consumption and is part of the product portfolio of E.ON AG for more efficient use of energy, offered to business customers. As of today, the system has only one parameter of control, namely power, and the objective of this essay has been to investigate whether other ones could be added. The emphasis is on the environmental perspective, which is why carbon dioxide has served as an example for this parameter in question.Parallel with the study of Energy Director electricity on the margin, calculations of carbon dioxide equivalents and also the Swedish trade of electricity have all been highlighted. Results indicate that when reductions in energy are made it is endorsed to omit from electricity on the margin rather than some mean distributed electricity, under certain conditions, and in addition the calculations of the reductions should be modified regarding the efficiency of the power stations fuelled by lignite and bituminous coal. Sweden practices trade with the Nordic countries as well as Poland and Germany.

With rising energy prices and the threat of climate change, energy costs and energy savings havebecome a central and important part in building. Therefore it is interesting to explore different andnon-conventional methods of energy conservation. Building Earth sheltered houses is such a method.Earth provides good insulation and provides the ability to both reduce the total heating needs and toreduce the maximum power demand. The aim of this study was to construct a house in Malmö and seeif Earth sheltered houses can be a cost effective alternative for the construction of sustainable andenergy-efficient houses.Previous studies have shown that Earth sheltered houses have reduced their power requirement with upto 25% and their use of energy with 10%. Numerical calculations in Comsol Multiphysic 4.2, wasperformed on a house with different degrees of earth covering.