Companies and special interest organizations pays multiple millions each year in order to reach out with messages about that their products are biggest, best and most beautiful. The publicity happens among thing like TV, in brochures, on the Internet andin newspapers etc. places. This means that consumer permanently becomes affected of publicity, and is thereby in an exposed situation. Around the EU, the border of what to consider undue or not, have been in different levels.

To complete an overweight treatment program is associated with better weight loss. Previous studies have in principle focused on drop-out from the entire program, not individual parts of a program. Factors previously shown to influence the patients´ weight loss results are: frequency of individual meetings with a professional, the lack of social support from family or friends, the lack of motivation and in a few studies vacations. In several studies the drop-out patients have stated that their reasons for drop-out were dissatisfaction with the staff and the program design. Drop-out has also been shown to be connected with difficulties in adherence to the diet.

In the area of short stories there is little doubt that Roald Dahl has been an influential writer. Dahl´s short stories have been presented to the general public through TVbraodcasts but in order to grasp the true spirit of Dahl´s writing the best method is, of course, reading his books. The fictional works of Roald Dahl can be divided into two major categories: stories for adults and stories for children. This essay is concerned with the second grouping and is an attempt to analyse three themes that are of particular importance to his work. After a brief biographical note on the author, the essay analyses the element of the macabre in Dahl?s writing.

The writer has attempted to discuss the distinction between the necessary and the contingent. It begins with a criticism against the possibility for a so-called ?a possible worlds realism? to give a ?philosophical explanation? of this distinction. The writer argues that this is impossible, since it requires that a notion of this distinction be already accepted (more precisely that the necessity of such a theory is already accepted).After this specific criticism, the writer intends to show that this is a more general problem that follows any explanation of the contingent/necessary distinction.The writer then discusses the counter-argument that the requirements placed on these explanations are set to high, therefore the writer shows in theory the problem can be solved and sketches a more specific way how to explain and show the basis for this distinction..

The purpose of this thesis is to clarify the grounds upon which an arbitration clause may be binding in the new relationship between the parties after a transfer of rights and/or obligations. The issue is not regulated by law but instead it has been left to the Supreme Court to regulate. In the Emja-case the Swedish Supreme Court left guidance on the issue. The Supreme Court stated that a third party purchaser of a right where the contract includes an arbitration clause shall be bound by the clause. The arbitration clause is only binding to the remaining part of the initial agreement if no special circumstances exist. The binding effect was justified by the reason that a situation where the purchaser but not the remaining part should be bound to the clause was not sought after and the principle through the 27 § of the Swedish debt instruments act..

The aim of this study is to find out what education in literature is like from a student perspective; what kind of literature the students read and how well they understand literature, and the methods and didactics used during the literature lessons. The questions at issue are:1) What kind of literature do the students read?2) How well do the students understand literary texts?3) What do the students think about their literature education?To be able to answer the questions, both quantitative and qualitative methods have been used in the study. The inquiry was accomplished on 29 students, 17 boys and 12 girls in the upper secondary school. The result showed, despite the limited amount of students, interesting facts.

This study investigates a farm in Dalarna which includes 16 ha of farmland and 1, 7 ha of pasture. The purpose is to find out if it is possible to start an animal production in Dalarna. The study is set only to compare spring lamb production with nurse cow production. There are two buildings on the farm that can be used for this purpose. One is an old cowshed, and the other is an unused silo for silage with a roof on top. Both of the buildings are compared to every alternative in the calculations.

A system for sampling of alcohol and aldehyde from diluted exhaust gases from vehicles powered by ethanol has been developed and tested. The major part of the work has been research of earlier work in the field and the construction of the sampling system.The part of the system constructed for the measurement of alcohol has been shown to work, however, more test should be performed. The part of the system constructed for the measurement of aldehyde was tested parallel to a commercially available system, based on the same principle of measurement, and has been shown to work well.Determination of the concentration of gaseous ethanol using a FID has shown the since earlier known fact that a FID is not able to measure a correct concentration of ethanol. Furthermore it has been shown that high concentrations of gaseous ethanol can not be kept in a bag more than a few minutes without a substantial decrease of the measured concentration..

The aim of this paper is to empirically examine the ideological trends and positioning of the Swedish liberal party with the Danish social liberal party. This paper also aims to analyze the reasons behind the trends. By examine the development in these two Nordic liberal sisterparties, this paper contributes to our understanding of why and how party change is initiated. The paper commences with an intuitive notion that the Swedish party has in fact, made a lurch towards the right, during the past ten to fifteen years while the Danish party has retained their social-liberal position in the centre of the Danish political spectrum. The questions then asked are: can this hypothesis be verified empirically? If so, how can this phenomenon of divergence, be explained?The method used in this thesis is process-tracing and the empirical material does to a large extent rely on interviews with central agents as they are specified in the theory of each party.

This degree project has been carried out in cooperation with Enertech AB in Ljungby and is pilot study to automating all current manual soldering. The soldering process accounts for a large part of the processing cost in the production of a heat pump. The process is also a quality risk and has a major impact on the lifetime of the final product.The Main task of this project has been to evaluate automation of the soldering process, to develop automation solutions and a principle layout, to draw the design changes required for the automation and to calculate the supposed solution.This pilot study has resulted in a suggested automation solution using laser as a heat source for soldering. Calculations of the solution show that a automating a laser soldering cell is very profitable..

This essay deals with the principle of surprise warfare and its development as well as the adaptation of military action that had to be made to surprise the opponent in the modern era.The concept of surprise is divided into its components in order to clarify what is required to implement a surprising maneuver, to understand the complex concept and form a theoretical framework for gathering facts in the case study.Development and adaption are demonstrated by a comparative case study where Pearl Harbor illustrates an example of historical surprise and Operation Desert Storm illustrates a modern surprise. The product will then be analyzed in order to detect the development and how military conduct is forced to adapt in order to carry out a surprising maneuver. The results shows that the military action of performing a surprise attack has had a major development and is now carried out in a different stage of the attack..

In this essay a model of a potential illegal hunter?s decision-making is created and presented in order to provide an overview of important parts of the complexities associated with the current Swedish predator policy. A comparison is made between a livestock owner?s economic incentives, and the expected costs faced by the potentially caught lawbreaker. In accordance with economic theory the benefits and costs of illegal hunting are compared and thus the optimal choice is determined where marginal costs and benefits are equal.

AbstractWe live in a world today that is characterized by the Internet. We can get hold of people on the other side of the globe whenever we want and we can purchase what ever we want, from who ever we want, anytime we want. This development has made it important to find systems of dealing with the payment in a safe and secure way, both for a private person as well as for a company, when you do transactions with people far away, and those systems is the core of this essay. As a private person you sometimes need to transfer money to family members who live abroad and you can then use clean payments. This means that banks all over the world has systems which makes it easier when their customs wishes to transfer money abroad.

This degree project has been carried out in cooperation with Enertech AB in Ljungby and is pilot study to automating all current manual soldering. The soldering process accounts for a large part of the processing cost in the production of a heat pump. The process is also a quality risk and has a major impact on the lifetime of the final product.The Main task of this project has been to evaluate automation of the soldering process, to develop automation solutions and a principle layout, to draw the design changes required for the automation and to calculate the supposed solution.This pilot study has resulted in a suggested automation solution using laser as a heat source for soldering. Calculations of the solution show that a automating a laser soldering cell is very profitable..

The  construction  industry  is  a  costly  business  such  in  respect  of  capital  for  most construction defects which then require rework, tear down and rebuild again. This study is  meaningful  awareness  of  tools  that  can  reduce  this  best  through  communication  and information sharing between the parties.  The  construction  industry  is  known  as  temporary  projects  organizations,  where  the construction  project  consists  of  several  actors  who  have  to  communicate  and  share information  between  them  to  avoid  mistakes  later  in  the  build  time.  These  actors  are bounded together thus for the duration of the project, then broken when the project has reached its end. The challenge here is for these actors to apply a tool that can help and simplify communications, information sharing, and perhaps the most important aspect is to  create  a  routine  for  the  association  and  the  shattering  of  these  actors.  To  implement such  behavior  using  a  tool  such  as  BIM  in  the  industry  whose  size  perhaps  is indescribable may be a very hard task.  BIM (Building Information Model) could be seen as the solution to this problem because it  acts  as  a  portal  where  the  actors  involved  must  sign  in  and  communicate,  share information, and eventually create a behavior, a routine for this association and division of  the  actors  following  the  end  of  the  project.  The  technology  could  help  the  involved from  the  beginning  of  the  project,  already  in  the  model  stage,  break  down  and  prevent any construction barriers when the building has been placed in the works.