Sök:

Sökresultat:

1200 Uppsatser om Pipe flow module - Sida 12 av 80

LIN baserad kommunikationsmodul för GPS

The work that is the basis of this Master Thesis was performed on Scania´s group of cabdevelopment, and concerns the GPS-system in Scania´s trucks. Today, the GPS-systemconsists of an active antenna mounted on the roof of the truck. The antenna is connectedto the receiver with a coaxial cable.The purpose with this Master Thesis was to develop and evaluate a new GPS-system,where the information is distributed using a LIN-network. Today, each unit requiringGPS-information is equipped with its own antenna and receiver. This solution has beenthe most cost effective to this point.

Värmeåtervinning ur spillvatten : En utredning av möjligheterna med spillvattenvärmeväxlare

The purpose of this report is to investigate the possibilities with drain water heat recovery (DWHR) in residential buildings. Information and relevant theory has been collected and summarized in this report. Calculations have been done for given scenarios to evaluate profits. DWHR heat exchangers use simple technology and have long life-time. The heat exchanger is connected to outgoing drainage pipe and incoming cold-water supply so countercurrent flow is accomplished.

Välbefinnande och Känsla av sammanhang bland flickor i skolvardagen (ÅR 6)

I ?Skolbarns hälsovanor? har sedan 1985 frågan ?Vad tycker du om skolan nu för tiden?? funnits med. Skoltrivseln minskar med åldern och till skillnad från många andra frågor skiljer sig pojkars och flickors uppfattning i denna fråga mest i den yngsta åldersgruppen, då flickorna i högre utsträckning uppger att de trivs mycket bra i skolan (Svenska barns hälsovanor, FHI 2005). I den här studien undersöks hur åtta 12-åriga svenska skolflickor i en västsvensk småstad upplever sin skolvardag. Min metod har varit att fastställa deras KASAM-värde genom en enkät (Margalit & Efrati, 1996) baserad på Antonovskys frågeformulär för att mäta Känsla Av Sammanhang (Antonovsky, 1987)och sedan intervjua dem enskilt om trivsel, flow och beröm i skolan.

Vibrationsdämpning av värmepump

Thermia Värme AB is one of the market leading manufactures of heat pumps. In order tomaintain this position, the company wants to improve the vibration characteristics of theirproducts. The aim of this thesis is to develop product design changes that lead to a reductionof vibrations in the heat pump Thermia Diplomat 8.The main cause for vibrations in the system is flow pulsation and mechanical forces inducedby the scroll compressor. Vibration is transmitted through the compressor piping and receivedby the heat exchangers, from where it is further transmitted to the connection points for theradiator and heat source circuits.A number of design changes in order to improve the vibration characteristics have beenevaluated through calculations and practical experiments. The changes have included thecompressor and heat exchanger mountings, the compressor suction and discharge line pipingand also pulsation dampening.The results of the experiments show that the vibration levels in the connections for the heatingand brine circuits can be decreased strikingly through changes in suction and discharge linepiping.

Implementering av dokumenthantering i Medius Flow

IT-företaget Medius tillhandahåller en produkt för ärendehantering, Medius Flow. I denna produkt finns ett visst stöd för dokumenthantering, närmare bestämt en möjlighet att klassificera dokument och lagra dem via Medius Flow. En av Medius kunder har efterfrågat mer funktionalitet och möjligheter att kunna sätta rättigheter på dokument, alltså bestämma vem som ska ha tillgång till ett specifikt dokument.Examensarbetet har gått ut på att undersöka olika lösningar för att implementera dokumenthantering i Medius Flow, utvärdera dessa och sedan implementera den lösning som verkar vara bäst.Efter att en kundintervju utförts framkom krav på systemet i form av bland annat utökade rättighetsfunktioner, möjlighet att skapa arbetsflöden och att man lätt ska kunna hitta dokumenten.Tre olika lösningsförslag togs fram. Det första gick ut på att vidareutveckla den dokumenthantering som finns i Medius Flow idag. Det andra gick ut på att använda sig av ett tredjepartsdokumenthanteringssystem och sedan bygga en integration mellan Medius Flow och detta system.

Kreativitet och undervisningsmetoder - om rutiner och kaos inom institutioners ramar

SammanfattningDetta arbete handlar om att kritiskt belysa de aspekter av undervisning som är centrala för mig som pedagog. Som lärare vill jag nå fram till eleven, jag vill att eleven ska ha möjligheten att vara kreativ och att få uppleva det tillstånd som kallas flow.Arbetet har utgått från de upplevelser jag fick av musik när jag var yngre, då tänkte jag inte i termer och begrepp utan upplevde - utan allt för förutfattade meningar. Nu när jag är lärare känner jag ett starkt behov av att identifiera vad jag då upplevde för att kunna ge mina elever en liknande kick av musik. Identifieringen har lett fram till detta arbete, jag kunde inte sätta ord på vad jag sökte men visste ändå intuitivt vad det var jag ville åt. Så småningom kom orden på plats: jag har i mitt identifieringsarbete kretsat kring kreativitet, flow och undervisnings metoder.

Att na? fram till fritt flo?de i improvisation : En sja?lvstudie i eget la?rande

Detta arbete a?r en sja?lvstudie i att utveckla improvisation pa? saxofon. Syftet a?r att utforska hur det a?r mo?jligt att uppna? en niva? av frihet i det improviserade spelet. En grundtanke som presenteras i inledningen a?r att all musik egentligen kommer ur improvisation.

En agil arbetsmetod för utveckling av ett leverantörsstöd

This thesis was made possible by the company Verendus system AB, which is the leading developer of dealership management systems in the caravan and camper market. The goal of the thesis was to create a statistics module for a new producer system envisioned by Verendus. The new system is aimed at manufacturers and importers of caravans and campers, with the goal of enabling its users to create more effective production lines. By providing statistical data to mentioned users they will be able to predict market trends and customize their production lines accordingly. Today such software does not exist which leads Verendus to think that its arrival would lead to a success on the market.Before the development and design of the producer system began, a new agile method had to be developed, MAM (Minimum Agile Method).

Inredningsförslag till Bolandgymnasiets matsal

My bachelor?s dissertation concerns the creation of a proposal for interior decoration of the Boland High School?s canteen. I have been in contact with personnel, students and the school principal through the duration of the project. In the end, substantive changes of lighting, interior decoration and movement were proposed for the canteen. In the proposal I have focused on accentuating the school?s profile, on creating smaller spatial configurations within the larger configuration of the room, lowering the noise level, creating a good movement flow, increase the number of seats and creating a pleasant environment in which to eat..

Utveckling av en ytmonterad fördelningsmätare som underlag för individuell debitering av vattenförbrukning i fastigheter

The master thesis, conducted at Metrima AB, concerns the development of a non-intrusivedistribution meter as a basis for individual tap water billing in apartments.The project is conducted in response to the market interest in individual tap water billing inapartments as an answer to environmental concerns regarding water consumption. Due to thehigh installation cost of traditional water meters, a new method of determining waterconsumption, without having to cut water pipes, is proposed.The proposed method distributes the total water consumption for an apartment complex toindividual apartments according to distribution meters, measuring water run-time, in eachapartment. The water run-time is estimated by measuring the water pipe?s outward vibrationsand temperature changes.A test environment was established and a prototype built, using a tilt- and vibration sensor forvibration sensing and a precision temperature sensor to measure temperature changes. As bothsensors work well in the test environment, further testing was done in 3 apartments for aduration of 5 days.

Motivation och identitet : En studie om ungas deltagande i ideella konstnärliga projekt

Studiens syfte är att ur ett symbolisk interaktionistiskt synsätt försöka förstå vad som motiverar vuxna amatörskådespelare, amatörsångare och amatörmusikalartister att delta i ideella konstnärliga projekt. Något annat som studien tar reda på är om konstutövandet och gruppen de deltar i har någon inverkan på individens identitet och identitetsskapande. Genom nio semistrukturerade intervjuer skapas en förståelse kring motivationen och identitetsskapandet. Detta förklaras sedan genom motivationsteorier samt teorier kring identiteten, där det visar sig att gemenskapen i gruppen, konstnärlig utmaning och utveckling, deltagandet i den konstnärliga processen, känslan av flow, själva utförandet och dess påverkan på välbefinnandet, viljan att uttrycka sig samt personlig utveckling var de huvudsakliga motivationsfaktorerna. Det visar sig även att både det konstnärliga utförandet och gruppen har en inverkan på individens identitet och identitetsskapande..

Konstruktion av patientsimulator för anestesimaskiner

A patient simulator for testing anaesthesia machines has been developed at Maquet Critical Care AB, to reduce costly and time-consuming experiments on animals. The device simulates human lungs regarding lung dynamics and volume, uptake of anaesthetic agents and the production of carbon dioxide, heat and moisture. Further demands on the simulator are durability and size; the device shall be compact enough to be moveable.The resulting simulator fulfils the requirements and enables better repeatability and ability to test extreme cases than experiments on animals do.Uptake of the anaesthetic agent is achieved in a active carbon filter and controlled by regulating the flow. The flow is created by a regenerative blower and controlled using a proportional valve. The uptake can be set by the user or by a simple uptake model modified to recursively handle changes in the concentration of anaesthetic agent.Carbon dioxide is fed into the system from a tank by a mass flow regulator.

Utveckling av Breakoutbox för Fuel Flow Transmitter

Development and construction of an electronic Breakout box is the main work for this thesis. The box is a part of a test system for the component Fuel Flow Transmitter and should convert signals to be suitable for a frequency counter. A previously constructed Breakoutbox for this purpose is being old and needed to be recreated. So SAAB Aerotech, Aircraft services, the company for the thesis work wanted to construct a new, more sustainable Breakoutbox adapted to a more modern technology. The signals to the box comes from the transmitter and should be converted to suitable signals for a frequency counter so it can show pulse and time difference between the signals.

Identifiering av fosfatfosfors käll- och flödesfördelning i ett litet jordbruksområde

Eutrophication of lakes and streams are nowadays a well known environmental problem and implies an enrichment of the nutrients phosphorus (P) and nitrogen (N). Phosphorus is considered to be the most important component for the growth of aquatic plants and leads in too large quantities to an intensification of growth. Phosphate (PO4) is the fraction of phosphorus that can easiest be taken up by plants and thus have the greatest impact on eutrophication. Increased plant growth in lakes and unfavorable conditions for aquatic animals are two examples of negative consequences. A significant portion of the increased nutrient supply to nearby water can be derived to phosphate leaching from agricultural areas, where private sewers and agriculture is two main sources.

Optimering av UA-Värde : Förbättring av en containerkonstruktion

Envirotainer builds containers that are specialized in transporting of temperaturesensitive products these containers are customized for airplanes. The containers arethen leased to other companies, most often to pharmaceutical companies.Envirotainer are based in Lagga, Knivsta. It is also here where the production of thecontainers is held. The container RAP T2 was designed in the early 80ies. The RAPT2 contains a fleet of about 1220 containers spread all over the world.

<- Föregående sida 12 Nästa sida ->