To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

This study aims to investigate how federations manage to balance the economies of scale through collaboration and autonomy. This is done through a case study on Länsförsäkringar. The lack of modern research on federations makes the federative structure an interesting field of study. Previous research has shown a general perception that an increased pressure on efficiency and economies of scale creates a stronger common unit that eventually creates an imbalance in the federation. It is therefore interesting to look at the balance, which exists between the member units and the common unit of a federation.

This is an ethnographically inspired study focusing on multilingualism in a Swedish preschool setting. The purpose of the study was to find out how the children perceived their multilingualism and how it was expressed by the children in the interaction with teachers and peers. The research questions were as follows: How is the multilingualism expressed in the day to day interaction in preschool? What significance does the daily interaction with peers and educators have for the children?s perceptions of their multilingualism? How do the children perceive their multilingualism and the value in their multilingual abilities?  To answer these question methods inspired by ethnographical studies were used, namely participant observation and semi-structured interviews with the children.   Theory was used from two areas; childhood sociology as theorized by Corsaro with the ideas of peer cultures and interpretive reproduction, and the sociology of language with the theory of collaborative empowerment as introduced and developed by Cummins. The children in the study were seen as social actors who are important here and now and who contribute to the development of society.   The study showed that the multiple languages were visible in the preschool, but that the Swedish language was upheld as the norm and the language of communication; no children were recorded playing in their ?home language? during interaction with other children.

The purpose of this Master thesis is to examine whether the term elasticity is relevant and functional to apply to public library organisations. Another aim of the thesis is to relate the term elasticity to public library organisations in a network society. Sociologist Manuel Castells provide the theoretical framework on the network society. Three investigations (meant to complement each other) in two Swedish public libraries seek to give answers to these questions.To be able to examine which areas of public library activity are elastic, I make a rough definition of what public library organisations consist of ? nine activity fields are identified using IFLA?s guidelines in combination with Swedish law of public libraries.

To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

The primary function of a mixer is to keep a fluid in constant motion. All mixing applicationsrequire varying degrees of small-scale turbulence and bulk flow. The performance of asubmersible mixer is measured by the thrust that it produces, while the strength of the bulkflow is dependent on the total amount of installed thrust.In a mixer, the fluid quickly flows past the propeller, and as a result, the current is mainlyaxial. The fluid will also obtain a rotating velocity, or a swirl, though this is significantly lessthan that of the propeller. During the process, the total amount of energy increases in the formof static pressure and kinetic energy.

To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

Habia Teknofluor AB makes parts of PTFE. With their process they reaches a pressure of 250bar at maximum. For their parts to improve they need to reach 400bar at least. We will give suggestions that can solve their problem. All our suggestions is described in the report with a conclusion.

The aim of this study was to investigate the intraoperative surgical stress response in dogs undergoing ovariohysterectomy and to compare acepromazine and medetomidine as premedications. 15 dogs diagnosed with pyometra were used in this study. Blood pressure and heart rate were used as parameters to measure surgical stress response. The surgery was divided into four phases. Phase 0 was the period 10 minutes before the skin incision, phase 1 was skin incision and opening of abdomen, phase 2 was manipulation of uterine horns, ligation and transection of mesovarium and phase 3 was ligation of cervix, removal of organs and closing the abdomen. The results showed that phase 2 was the most intense phase of surgical stress, regardless of which premedication the dogs received. When acepromazine and medetomidine were compared the results showed that within phase 3, all dogs that were given medetomidine had higher blood pressure compared to dogs that were given acepromazine. The dogs that were given acepromazine had higher heart rate than the dogs that were given medetomidine in phase 0, phase 2 and phase 3. .

Dagens teknologiska utveckling har bidragit till vårt mediaintensiva samhälle som iallt större utsträckning har övergått till ett konsumtionssamhälle. Trots Sverigesrestriktioner gällande marknadsföring riktat till barn, står barn för stora delar avlandets konsumtion, vilket inte minst förstärkts genom internets utveckling. Dagensbarn är rikare än någon annan generation genom tiderna, vilket är något företag i daguppmärksammat vid utformandet av marknadsföring och produkter. Varumärken harfått en större betydelse på den konkurrenssatta marknaden, inte minst bland barn.Uppsatsens syfte är att identifiera och fördjupa diskussionen kring barnskonsumtionsmönster i yngre åldrar. Uppsatsen belyser den varumärkesmedvetenhetsom råder i åldrarna 6-10, samt identifierar likheter respektive skillnader gällandebarns relation till klädmärken.Studiens huvudsakliga teorier är varumärkesvärde, visual literacy och grupptryck,vilka sammankopplas med den insamlade empirin för att svara på hur barns relationtill klädmärken ser ut.

To reduce emissions of carbon dioxide (CO2) Carbon Capture and Storage (CCS) technologieshave been developed. Chemical Looping Combustion (CLC) is a CO2 capture technologywith the CCS framework, and at Chalmers University of Technology in Gothenburg,Sweden, a 100 kW chemical looping combustor has been built.This project aimed to investigate to what degree air can replace helium as the uidizinggas for uid dynamical studies in a CLC cold ow model of the above mentioned 100 kWfacility. Experiments were performed using air and helium separately as uidizing gas andpressure data were obtained, which formed the basis for the comparison. The project alsoaimed to investigate uid dynamics in the uidized bed and study when the risk of sluggingoccuring was greatest. The results were presented in the form of figures and tables dividedinto pressure, concentration and standard deviation of the pressure.The results obtained showed that air as uidizing gas did not create the same uid dynamicsas helium over the entire fuel reactor.

Increased understanding of the mechanisms that operate in conjunction with the welding of metal surfaces may help to improve existing manufacturing processes, and to enable new products and combinations of materials. The purpose of the project has therefore been to acquire a deeper understanding of what is happening in the bond for steel and for the factors that form the basis for a bond to develop between metals in the production of laminates by pressing. The merge has been done by pressing and the surfaces after the experiments have been studied in detail in the scanning electron microscope (SEM), energy dispersive X-ray spectroscopy (EDX) and with interferenceprofilometry in Wyko, to provide a greater understanding of the mechanisms that influence the bonding in the interface between metals. The project was limited to contain the materials Docol 1000, HyTens 1200, Aluminum AA3003 and a commercial steel. The parameters varied in the experiments to study their influence closer are temperature, pressure, heat treatment and pretreatment. This has been implemented by pressing with varying temperature and pressure.

Jerlemar, M & Nordström, J., Patienters upplevelser av att leva med trycksår. En litteraturstudie. Examensarbete i omvårdnad, 15 högskolepoäng. Malmö högskola: Hälsa och samhälle, Utbildningsområde omvårdnad 2011. Bakgrund: Trycksår är ett vanligt förekommande sjukdomstillstånd som drabbar framförallt äldre och rörelsehindrade. Trycksår kan medföra fysiska och psykiska komplikationer hos den drabbade.